Complaint regarding front brake rotor separation on 1998 Chevrolet Tahoe. The rotors separated under normal braking conditions. The consumer contacted the manufacturer who indicated that the separation occured due to age and/or wear. The rotor separated at the steel hub section attached to the cast iron section and blew apart.

- Blue Bell, PA, USA

The front brake rotor/hubs failed while driving vehicle. The brake rotors were replaced by an independent mechanic. The vehicle was not under recall #98V033000.

- Yorktown Heights, NY, USA

Consumer's vehicle has the same problem as mentioned in recall 98V033000 concerning brake:disc:rotors. Dealer would not repair because VIN was not included.

- Cedar Rapids, IA, USA

When the brake was applied, the vehicle stopped abruptly. The next day, the front left wheel started to shake, the dealer stated the front rotor had sheared off from the mounting bolt. There was a recall regarding the issue, recall # 98V033000, however the vehicle identification number was not included.

- Brewster, NY, USA

When applying brakes there is a pulsating noise due to warped rotors. Dealership is aware of problem.

- Irwin, PA, USA

Rotors went bad, they kept wearing out. Had rotors changed twice. Contacted dealer noted that there was no problem.

- Robesonia, PA, USA

Rotors causing surging and premature brake wear, and squealing.

- Damascus, MD, USA

Brake rotors failed.

- San Diego, CA, USA

While braking vehicle would shake / vibrate due to defective brake rotors which heats up and warp. Dealer replaced rotors twice. Problem is reoccurring.

- Mt. Holly, NJ, USA

Brake booster malfunctioned, causing extended stopping distance which could result in a crash. Also, dealer replaced brake rotors.

- Mechanicsburg, OH, USA

Brake rotors and pads failed causing vibration.

- Austin, TX, USA

Brake rotors became warped at 15,000, causing the brakes to be inoperative. It also may reduce braking ability and cause an accident. Replaced rotors 3 times. Cause unknown.

- Hillsville, VA, USA