The contact owns a 2004 Chrysler Crossfire. The contact stated that the field of vision was limited because the plastic covers on the head lamps were severely fogged up. The contact also stated that the failure occurred when the vehicle while still under warranty. The manufacturer was notified of the failure. The vehicle was not repaired. The VIN was unknown. The approximate failure mileage was 6,000.

- Gasport, NY, USA

Vehicle leaks water into driver side compartment every time it rains. As it does so the blower motor fills with water and can lead to a fire starting in the cars cabin. Chrysler was contacted but no repair was offered though this problem is a manufacturing defect.

- Fl, FL, USA

The problem is same as below. Hyundai is recalling 91,202 my 2002-2003 Hyundai sonata vehicles. Repeated use of the interior door handle may cause wear of the chrome plate. If the top edge of the handle has very thin chrome plating, that portion of the plating may wear away more easily than more thickly plated areas as the door handle is used. The worn chrome plating on the upper edge of the handle may result in a crack or separation between the chrome plating on the inboard and outboard surfaces of the handle, which may form a sharp edge. 2004 Chrysler Crossfire.

- Tallahassee, FL, USA

Design of vehicle did not allow for camber adjustment to front tires unless a weld is cut and a new piece is installed. Therefore, over time the camber of the tires can became such that the front tires wear on the inside edge that cannot be seen by the owner of the vehicle during a normal walk around inspection. This places the owner of the vehicle in a position that a tire which appears to be in good condition when inspected, may blow out without notice when at highway speeds. It would seem that a manufacturer's design that requires a weld to be cut and a new part installed at a later date to allow for a simple tire alignment adjustment and may lead to a potential tire failure until discovered by the owner, is not a vehicle design which incorporates a high degree of safety engineering.

- Buchanan, MI, USA