2010 Dodge Viper
NHTSA Defect Investigations
The Office of Defects Investigations (ODI) is an office within the NHTSA which investigates serious safety problems in the design, construction or performance of vehicles. The NHTSA is authorized to order manufacturers to recall and repair vehicles, if the ODI finds a safety issue. NHTSA investigations for the 2010 Dodge Viper, both ongoing and closed, are listed below:
Rear suspension knuckle fracture NHTSA Preliminary Evaluation #PE13010
Summary: ODI opened PE13-010 on April 26, 2013, to investigate two complaints alleging loss of control crashes caused by rear suspension knuckle failure in model year (MY) 2005 and 2006 Dodge Viper vehicles.The incidents described in the complaints occurred in November and December 2012.Chrysler's response to ODI's Information Request (IR) letter for PE13-010 indicates that the left and right rear knuckles used in MY 2005 and 2006 Dodge Viper vehicles were used in MY 2003 through 2010 Dodge Viper SRT-10 vehicles and in all Dodge Viper Competition Coupe and ACRX race cars (see Figure 1 of attachment to this resume for a view of the rear suspension in the subject vehicles).Chrysler's response included information about 8 reports related to rear knuckle failures, including the 2 incidents identified by ODI in the opening resume for PE13-010.In addition, after PE13-010 was opened, ODI received 2 additional complaints resulting in a total of 10 incidents of rear knuckle failure in MY 2003 through 2010 Viper vehicles, including 8 alleging crashes.Based on its review of physical evidence from field inspections of 6 of the 8 incident vehicles identified in its response, including the two incidents that were the basis for ODI opening PE13-010 (VOQs 10492180 and 10492169/10491122), Chrysler concluded that collision forces were the causal factor of rear suspension control knuckle failure.Chrysler's assessment was primarily based on examination of knuckle fracture surfaces, as well as evidence of wheel rim damage that would indicate impact loading of the affected suspension components.Each of the fracture surfaces examined by Chrysler displayed clean, granular fracture surfaces indicative of single event, overload failure.None of the parts showed any indication of fatigue crack growth.In addition to the 6 vehicles inspected by Chrysler, ODI obtained a fractured knuckle from a recent incident involving a MY 2004 Viper (VOQ 10510248).NHTSA's Vehicle Research and Testing Center in Ohio submitted this part to a laboratory for fracture surface and metallurgical analysis.The analysis concluded that there was no evidence of fatigue in the part and that the fracture was due to a single overload event (see Figures 2-4 in attachment to this resume).Analysis of the fracture surfaces found evidence of a mix of load states, with some failures associated with rear toe links in tension (Figures 2-4) and some in compression (Figures 5-6).Seven of the 8 incidents in which the side of the knuckle failure was identified involved right knuckles, the side that is generally most common for impact failures involving wheel and suspension components.The single, left side failure was associated with an incident involving an impact with a concrete barrier dividing highway travel lanes.Analysis of the failure data indicated these are random events and do not show any clear patterns related to vehicle build range, vehicle age or mileage.Examination and testing of failed knuckles have not identified evidence of a manufacturing or design defect in the parts.Accordingly, this investigation is closed.The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.The agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.VOQs associated with this investigation: 10523321, 10510248, 10492180, 10492169 (duplicate to 10491122).
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE13010 »