The key fails sometimes to turn in the ignition cylinder, went to mechanic, ignition switch needs replacement.

- Brunswick, ME, USA

The contact owns a 2005 Chevrolet Equinox. The contact stated that the ignition switch failed to turn preventing the vehicle to start. The vehicle was taken to a private mechanic where it was diagnosed that the ignition switch needed to be replaced. The manufacturer was made aware of the failure. T he vehicle was not repaired. The failure mileage was 65,000 and the current mileage was 66,000.

- Pittsburg, PA, USA

The key can be removed from the ignition while the car is running, the headlights only work on highbeam, the brake lights do not work except for the small one in the middle. The car will continue to try to start even after the key is removed. The car currently runs hot so the fan runs constantly and runs the battery down. I have parked the car and wont drive because of the safety issue.

- West Frankfort, IL, USA

The contact owns a 2005 Chevrolet Equinox. The contact stated that the ignition key failed to turn. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The VIN was not available. The failure mileage was 130,659.

- Dayton, OH, USA

I had to have my battery replaced today. My battery had to be replaced due to the ignition switch that is not completely turned off when I put the car in park. For a year or so I have been able to drive down the road and my cars key has been removable from the ignition switch. I have asked about the ignition switch before to my dealership over the years with no resolve. Since the recall of other GM models during the same year my car was made recently I have read over these issues and my Equinox is having the same issue. I do not have to put my car in park for the key to be taken out of the ignition switch. Now my battery is being compromised due to it not completely being able to shut off.

- Columbus, OH, USA

First while driving at approx 25 mph I hit my key ring and the keys fell out. The car continue to run I just put the keys back in to the ignition when I came to a stop. I have since found that you can start the car and then remove the key and all continue to run and work. Also found that when I went to start the car the other day, once I turned the key to start it would kept running the starter. Let me explain a little better, when I turned the key to start the car and then let go the car starter continue to run until I moved the key to the off postion.

- Jacksonville, FL, USA

The contact owns a 2005 Chevrolet Equinox. The contact stated that the key was erroneously removed from the ignition while the engine was active. The contact experienced the failure on multiple occasions and notified the local dealer who informed the contact that the vehicle was not included in NHTSA campaign id number: 14V171000 (electrical system). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 77,000....updated 12/09/15 updated 8/21/2017

- Wayne, MI, USA

The contact owns a 2005 Chevrolet Equinox. The contact stated while driving approximately 30 mph, she erroneously struck the key ring and the ignition key released onto the console cup holder. The engine continued to operate without the key being positioned in the ignition switch. The contact immediately placed the key back into the ignition switch. The engine would operate at any given time without the key being permanently placed in the ignition switch. The vehicle had not been diagnosed or repaired. The manufacturer was notified of the problem. The approximate failure mileage was 100,000.

- Catasaqua, PA, USA

Key can be removed when ignition is not off. Can and does fall out while driving vehicle no matter what gear the selector shift is in ( including park).

- Rockford, MI, USA

Problems with power windows and door speakers. Had read about issues with the wiring harness between the door and the frame. I took the rubber boot off to find 4 broken wires. I would imagine the other doors are similar. Haven't ckd them as of yet. I have pictures if you like.

- May, TX, USA

On trip stopped for gas, pulled key out only went 1/2 way. Was stuck would not go in or out. Could not turn key to start the vehicle.was waiting for service, heard the door locks cycle on their own, panic button on. Then key would turn and vehicle would start. Replaced the ignition switch as per the dealer. Cost $587. This happened twice both times while trying to fuel up the vehicle. Since the switch was replaced we have encountered this twice again and do notice excessive wear on the key.

- Taylorville, IL, USA

1st time, going down steep hill, could not stop vehicle, thought brakes died, had to use the hand brake to stop, just missed a truck by a foot, would of hit me on driver side. That was in 2012 had SUV towed to robinson township, non GM dealer, they said it was the ignition sensor, replaced it, re-towed to GM dealer in moon township. They checked it out it was ok since sensor was replaced. 2nd time was in 2013, stopped coming down a hill again, no power again, called aaa they towed to GM dealer in moon township pa. Again ignition sensor replaced and also some other wires burned which were all replaced. Vehicle has around 33,000 on it only.

- Coraopolis, PA, USA

Went to start my car and the key would not turn. I jiggled it for a long time and it finally turned but the headlights wont work now. I looked on line and saw a few other have this issue. I cannot drive at night now.

- Norwalk, CA, USA

Driving on smooth road at about 60 mph when the ignition key fell out of the ignition switch onto the car floor. The switch was still in the run position and I was able to reinsert the key into the switch. The engine did not stop and there were no warning lights. This has happened several times since. Current mileage is 73500. I noticed I can manually pull the key from the switch at anytime. I have not tried to move the steering wheel while moving to see if it will lock when the key is out and the switch is in the run position. It does not lock when the vehicle is stationary and the switch is in the run position with the key out. I had the car into the dealer for a brake issue and in a follow up phone call brought the key issue to the service writers attention. She said to have a new key made by the dealer using the vehicle VIN. I did not do this yet. I have three keys made by local hardware stores all with the same result.

- Largo, FL, USA

The ignition gets hung up and wont allow to start or move ignition switch to turn off unless you giggle it around. This problem is sometimes helped by going to the dealer and getting a new key. This wears out in a few months and the problem returns.

- Griffith, IN, USA

Car will not start unless I change the rear brake fuse. When I change it, it continues to blow out..

- Philadelphia, PA, USA

It been in Chevy dealer for repair hub replace wind in dealer refund cost.

- Shreveport, LA, USA

Key keeps getting stuck in the ignition when trying to remove the key, after months of this and complaining bout it to carmax and them not finding a "problem" the key would no longer work, turn in the ignition. Now the warranty has expired and I have to pay out of pocket for the repair. This is an issue with many Chevy equionxes from 2005-2010.

- Charlotte , NC, USA

The contact owns a 2005 Chevrolet Equinox. The contact stated while driving approximately 10 mph over a speed bump, the brake pedal was depressed and the brakes began to pulsate with the illumination of the ABS and traction control warning indicators. The vehicle failed to slow down after repeatedly applying the brakes. The emergency brake was engaged in order for the vehicle to stop. The vehicle was able to resume normally and had been taken to four independent mechanics for diagnosis, all of which were unable to locate the cause of the failure. The front brakes, ABS sensors and ABS module were replaced. The problem persisted after the repair was performed. Most recently, a technician informed the contact that problem could possibly be caused by an electrical issue. The manufacturer was notified of the problem. The approximate failure mileage was 92,000.

- Oakland, CA, USA

I stopped at a gas station and shut off truck. Got out and pressed twice on the lock on keyless alarm system. The truck locked but no honk. Came out of gas station and tried to unlock truck with keyless system. Nothing. Had to use key to get in. Put key in ignition to turn on and bing bing bing nothing. No electronics work truck doesn't do anything.

- Slidell, LA, USA