The contact owns a 2010 Chevrolet Malibu. The contact received a recall notification for NHTSA campaign number: 14V252000 (electrical system, electronic stability control, exterior lighting, service brakes, hydraulic, vehicle speed control); however, the parts needed to repair the vehicle were unavailable. The manufacturer was notified of the failure. The contact had not experienced a failure.

- Copiague, NY, USA

The contact owns a 2010 Chevrolet Malibu. The contact received a recall notice for NHTSA campaign number: 14V252000 (electrical system, electronic stability control, exterior lighting, service brakes, hydraulic, vehicle speed control) and stated that the parts needed were unavailable to perform the recall repair. The manufacturer was not notified. The contact had not experienced a failure.

- Muscle Shoals , AL, USA

Interior electrical problem with the lights in the dashboard---dash lights (driver information center) and radio lights occasionally do not come on and/or frequently go off while driving. Radio will be working then aux imput device will appear and the radio stops working. Also the radio lights will tile at times and then start rolling in rectangular lines.

- Charleston, IL, USA

The contact owns a 2010 Chevrolet Malibu. The contact received a recall notification for NHTSA campaign number: 14V252000 (electrical system, electronic stability control, exterior lighting, service brakes, hydraulic, vehicle speed control); however, the parts needed to repair the vehicle were unavailable. The manufacturer was not made aware of the issue. The contact had not experienced a failure.

- Coeymans Hollow, NY, USA

2010 Chevrolet Malibu. Consumer writes in regards to brake system recall notice and consumer seeks a loaner vehicle until parts become available. Recall# 14V252000.

- Williamsville, NY, USA

I received a recall notice 1 week prior to this incident. Recall #13036. I was almost rear ended when my brake lights failed. I was on my way home from work and watched my stability control and traction warning lights come on. I contacted GM and was told that no replacement parts are available. GM also stated that they are not responsible for towing or a rental even though it is a defect in the design and/or manufacture of the body control module. I have been without a car for 4 days at this point and GM stated that no replacement parts are yet available. My car is a shiny peice of junk that I can pay for yet cannot drive because of the defect. I am a veteran and I am absolutely disgusted. All of the above problems are directly related to the defective part.

- Melrose Park, IL, USA

Low beam front passenger headlight out. Had headlight replaced at dealership where vehicle was purchased only for the light to go out 1 week later. Called dealership and they suggested I contact NHTSA/GM for this problem. Afraid for my families safety when driving at night in rain/fog and so fourth, as well as a traffic fine for driving with one headlight. Please refer to numerous forums online ( chevymalibuforum.com & mototrend.com/cars/2010/Chevrolet/Malibu with drivers complaining about the same issue.

- Chula Vista, CA, USA

Rear exterior brake lights stayed on while driving. Lights would go off when brake was slightly depressed and would come back on when pedal was depressed more firmly.

- Garrett, IN, USA

I was stopped at a stop light when my car stalled. The cabin started filling up with smoke. The lights would not work. The trunk would not open. The locks would not work. The smoke was coming from the trunk. I had the car towed to the dealership. It was determined that the fuse box in the trunk was melting the junction box and main body harness. My insurance company picked up the claim and made repairs. There is now a recall on these cars for this type of failure.

- Gold Hill, NC, USA

Intermittent problem, occurring at least five times since date above. One or more of the following conditions noted: 1. cruise control fails to engage, or stops engaging. Indicator light on (/off wheel toggle switch), but no engage. 2. "service ESC" and alternating "traction control" warning with alarm tone on speedo cluster. Orange warning triangle illuminated, also. 3. brake lights constant on, with no foot on brake pedal. Or, brake lights can go off when brakes are applied. Confusing, possibly dangerous, to drivers immediately following. Once aware of this, fashioned a reflector fitting just behind the rear top mount brake light that reflects into my rear-view mirror. These problems can clear after car is stopped for a time (over 45 minutes) and may not appear again for another unknown interval. Already replaced (March 31, 2014) a brake position sensor switch ($186.60 - my cost) at local selling Chevrolet dealership. This did nothing to fix the problem and when asked, dealer claimed no knowledge of any tsbs or of others having issues similar.

- Norman, OK, USA

So about 2 months ago the service traction light came on briefly and didn't come back on for a while. Then about 2 weeks ago it started going off almost everytime I drove. I brought it to the dealership that I bought it in kannapolis, nc called classic Chevrolet on 5/3/14. They said I could pay $98 to get it hooked up to the computer reader, but the light was off so I decided I didn't really have $98 to waste. As it had been hooked up to a code reader when the light was off before and didn't read anything. There is an option to turn off the traction control so I was driving with it off. We went to Michigan on 5/8/14 it was driving fine. Light never came on. When we were in Michigan it started going on again, again driving with the traction control off. It was hooked up to a computer and no codes came up and light goes off when you turn it off and never came back on our whole way home. Nothing felt or sounded different with the driving. Driving fine to drop off our son at practice this morning 5/17/14, turned on car to go pick him up and couldn't reverse, but would go forward. I had my husband and his brother push us out of the driveway and it was driving fine for the first 3 blocks, then started to chug and wouldn't shift correctly leaving a stop light. I turned around on a circle drive. We live on a culdesac so I pulled ahead of our house, so we could push it back in the drive way. When my husband came back out it was like locked, we couldn't push it in reverse. Then it wouldn't go forward. My husband unhooked the battery and was able to reverse with struggle and pull into the driveway with struggle. During all of this, the brakes have been illuminating when not being pushed and sometime they don't even work.

- Statesville, NC, USA

Brake light illuminate without pressing the brake pedal. When brake pedal is pressed then lights go off for a brief moment then go back on. While accelerating brake lights come on and stay on. I have nearly had several close encounters. I have had this issue twice already. First time the dealer repaired it and that lasted a year. It recurred and I have taken it to an independent mechanic in which he replaced the brake pedal sensor and had it diagnosed. I am still having this occurrence. This is absolutely ridiculous to have this recurring problem. Every time they want a fee plus repair charge. They are making money both by car payment and repairs. What the hell"?" frustrated with Chevrolet.

- Bellflower, CA, USA

2010 Chevrolet Malibu brake lights stay on without brake pedal being pressed and go off once pedal is pressed...this is a serious issue that I have researched and found common among this model and other GM models. I believe that a recall should be issue immediately to fix this issue.

- Riverdale, GA, USA

The contact owns a 2010 Chevrolet Malibu. The contact stated that the brake lights illuminated independently without the contact depressing the brake pedal. The contact also mentioned that all of the door locks would independently lock and unlock while the vehicle was in motion. The vehicle was not diagnosed. The manufacturer was made aware of the failure. The vehicle was not repaired. The failure mileage was 80,000.

- Grandview, MO, USA

The headlamps provide poor visibility. The illumination of the low beams is only about 15 feet in front of the vehicle. This requires us to drive with the high beams on most of the time. However, when oncoming traffic are coming, we switch back to low beams. We have tried various light bulbs but that didn't fix the issue. My husband has physically tried to tilt the light bulbs, but that doesn't work either. There needs to be a redesign of the headlamps to provide better visibility. Poor visibility can cause accidents. We purchased this vehicle as a used vehicle in April 2012. I have always had this problem, just decided it was time to report it.

- Springfield, TN, USA

The brake light comes on when the brake pedal is not being pushed. It doesn't matter if the car is sitting in park or being driven on the highway, the brake light stays on when the pedal is not pushed. When the brake pedal is pushed, the brake light goes off.

- Edgewood, KY, USA

The contact owns a 2010 Chevrolet Malibu. The contact stated the brake lamp would illuminate independently without the brake pedal being depressed. When the contact did depress the brake pedal, the brake lights would fail to illuminate. The manufacturer was made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 135,000.

- Lancaster, SC, USA

The brake lights on our 2010 Chevy Malibu, turn on while driving but turn off when the brake pedal is pressed. After tapping the brake pedal, the brake lights then stay off for approximately 4 seconds, then illuminate on their own again. When this occurs, the cruise control does not work and the service ESC and service traction warnings are displayed. This problem occurs intermittently and for varying periods of time.

- Blue Springs, MO, USA

The contact owns a 2010 Chevrolet Malibu. The contact stated that while driving at various speeds, the cruise control failed to engage and the brake lights failed to operate intermittently. The vehicle was not taken to a dealer or diagnosed. The vehicle was not repaired. The manufacturer was not notified. The failure mileage was 58,000. The current mileage was 58,200. Updated 11/13/13 according to the invoice, the brake lights illuminated when they were not needed and did not illuminate when the brake was applied. The dealer replaced the brake pedal position sensor. Updated 11/14/13

- Janesville, WI, USA

The contact owns a 2010 Chevrolet Malibu. The contact stated that while driving 55 mph, she was stopped by law enforcement and asked why she was depressing the brakes for such long periods of time. The contact determined that the brake light was illuminating when not depressing the brakes and would not illuminate when the brakes were depressed. The vehicle was taken to a dealer for diagnosis where the contact was informed that the brake light sensor would need to be replaced. The vehicle was repaired however, one week later the failure recurred. The dealer replaced the brake sensor a second time and the failure recurred the following day. The manufacturer was notified of the failure. The vehicle had not been further repaired. The failure and current mileage was 53,000.

- New Virginia, IA, USA