Excessive corrosion on brake and fuel lines. Had a metal line blow out near rear driver side wheel causing driver to have to use transmission and holding parking brake release handle while using E-brake while steering with one hand. Upon splicing in a section of replacement tubing, I noticed the fuel return line from the engine to the tank is corroded severely too. I had a section of fuel line fall apart upon replacing a fuel filter and spliced in a rubber fuel hose with clamps to get a fuel filter replaced. When the fuel lines rupture, there is a chance of fire from the exhaust or hot brake drums. Was advised by mechanic that I need to sell truck as it has 18-24 months left without proper and expensive repairs being made. Rarely gets underbody wash as a quality wash is far away and was advised that the rust is probably holding it together and advised not to knock off any more rust as it would accelerate further corrosion. Was advised a waste of time to use rust reformer or undercoating. I noticed this stationary as the vevicle was making squeaking sounds from the rear axle hub on driver side (same line that blew) and figured hanging caliper so I did a full brake pedal press and felt the pedal get spongy and drop another 1" toward floor. I opened door, hung out looking under truck and pressed pedal again to see fluid pouring from rear axle area. Drove it 30 miles with no service brakes to get to the garage using only E-brake and 3,2,1 and neutral range of transmission to be able to stop if needed. Also was advised about fuel tank strap and that I would need a flame cutter to change the fuel pump as truck bed bolts looked horrible or would need to cut tank straps depending on how much fuel is in the tank. The "annual underbody wash" most owners manuals recommend is insufficient to prevent this problem.

- Miamisburg, OH, USA

Corrosion and failure of metal brake line directly below left front door. Very poor design as tubes are behind a double loop of chassis wiring causing buildup of dirt and moisture resulting in premature failure. Failed when backing out of the driveway and thank god I was not on the road

- Elizabethtown, KY, USA

While approaching a stop sign I applied the brakes and the pedal went to the floor. No warning of any kind. Lucky for me no traffic was coming.

- Felton, PA, USA

Brake lines rustd out. Making my truck loose brake fluid and had to be replace, . serious problem, lucky I did no have an accident. Rust etc, all over the rest of the brake system, very costly, $$$$$, I was driving down a street slowly.

- Florissant, MO, USA

Chevy rust. Brake lines rusted out completely and failed - happen at slow speed no one injured. Shackled broke off and hit bottom of bed without towing. Frame is rusted out. Neighbor has similar vehicle with same problems (put jack on frame and it went through the frame.) many complaints online about these very issues.

- Utica, NY, USA

Brakes pulsating at low speed trying to stop almost hit another car in front of me.

- Mcclure, PA, USA

About 165,000 miles brake pedal started to pulsate at low speed when stopping.started out only when I would be turning left, now does it going staight, about 170,000 miles now.had new caliper on driver side, new hub assemblie and sensor on passenger side, brake system flushed, still have problems with brake pedal pulsating, does not matter what kind of road I'm on.

- East Berlin, PA, USA

Recall 05V379000 related to low speed activation of the ABS braking system while my vehicle is operated was performed in 2006 on my vehicle. This has not fixed the issue as low speed activation of the ABS system is occuring now. I have contacted Chevrolet corporation (GMC) and asked to have the recall protocol performed again. They refuse. I spoke with kimberely from NHTSA and she advised me to file a complaint if GMC refused to take responsibility for this defect. Phone confirmation # 868194

- Rochester, MN, USA

2002 chev. 1500 silv. Purch. 2001 tx.ABS brake system failed on St under 5mph, brought to mechanic.,brake pads, and tires.southeast Texas hot and very humid, laws of nature, airbags are no good in either vehicle.(she has a son age 14, and 3yr old grl).axil is rusty worried that it might break.god is with all of us, his intentions are always good. God protected her and her chiildren in this vehicle thus so far..\& we desire to protect thier children and you know this, but sometimes people go through unfortunate tragedys such as divorce, health, etc.a single, no money that wants safety for ther children and work.Chevy Silverado brought new paid off less than 3yr. Her 1994 Ford mustang (was insured farmers)purchased in 1997.ABS brakes failed, transmision prob.& engine replaced. Truck( geico ins) undrivable because ofelectrical system and ABS, rusty brake lines, rusty axils, leak in the line, no horn, doors do not seal water leak, paint faded, even tools can not fix these problems.she has a college degree and living in a home she bought (before the tragedy )when she worked.(helping others at herman memorial baptist hospital beaumont behavior center of southeast Texas, mehaffy weber law firm, christus St.marys hospital outpatient center, port arthur animal clinic, port arthur news paper, png isd as a sub-teacher, spindletop mhmr and family services womans and childrens shelter. She has volunteered at 3 rivers council for boyscouts of America and even gradulated with the wo he lo medalion in boys and girls campfire scouts when she was 15.)she has reached out for help, and no one listens....like she does. Even though she is down for the season, she continues to helps others by showing others that god is good he is real & alive.we R all gods children.please NHTSA, what can be done? -K

- Groves, TX, USA

The contact owns a 2002 Chevrolet Silverado 1500. While driving approximately 30 mph, the brake pedal was depressed and traveled to the floorboard without warning. The failure recurred three times. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The VIN was not provided. The approximate failure mileage was 125,000. Updated 02/12/16 invalid VIN number 4/23/18

- Randallstown, MD, USA

The contact owns a 2002 Chevrolet Silverado 1500. While driving at 10 mph and proceeding to stop the vehicle, the brake pedal failed when depressed. The vehicle was restarted and functioned normally. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 121,648.

- Jackson, SC, USA

Seems that below 10 mph anti lock kicks in on dry pavement and makes truck hard to stop in motion on road

- Brighton, IL, USA

While driving through my subdivision approximately 20 mph and pressing the brake, the pedal went completely to the floor and the vehicle did not slow down. I pumped the pedal repeatedly and only slight braking action could be achieved. I went through the subdivision just narrowly missing two crossing cars and kids then turned onto a nearby side street. After finally getting the vehicle to stop, I got out and saw a puddle of brake fluid forming a few feet behind the driver side front wheel.

- Grove City, OH, USA

Brakes failed completely. After I felt the brake pedel was not right I backed the truck into the front yard, and when I tried to stop there was no pedel and the truck kept going and hit a tree, lawn bench, misc. Objects, and stopped after hitting S retaining wall. I estimate several thousand damage done. I was told the brake lines were rusted.

- Florence, KY, USA

The contact owns a 2002 Chevrolet Silverado. While driving at a low speed, the contact applied the brake pedal and the ABS kicked in; however, there was a loss of brake function. The stopping distance of the vehicle was dramatically reduced. The vehicle was taken to a mechanic who stated that there was a wheel bearing sensor failure. The entire wheel bearing with the sensor was replaced, but the failure recurred multiple times. The contact researched and found NHTSA campaign number: 05V379000. The manufacturer was notified of the issue. The approximate failure mileage was 90,000.

- Waterville , ME, USA

I was driving in appomattox va when I step on break I had no breaks. Two of lines had bust.

- Pamplin , VA, USA

Approached corner and pressed brakes to turn. Peddle went to the floor. Almost ran into a car turning and I had to swerve to miss them.

- Freeland, MI, USA

Multiple times stopping about 4-5 mph on dry pavement, my vehicles ABS system kicks on and I loose breaking power.

- Canton, OH, USA

The first time I lost all brakes was when I was backing up to a traler on 7/13/15. The second time I was hauling a dump trailer with rock and lost all brakes and was able to get it to coast to a stop. The first incident was taken to a Chevy dealership and had the rear brake line replaced, only to lose my brakes again 40 days later! this time it was my front brake line. Why is there no recall on this? I don't feel safe driving this vehicle anymore. I have 3 young children and I can't trust your vehicle with their lives or mine!

- Pittsfield , IL, USA

ABS stopped brake pedal from going down. By the time I lifted and pumped again vehicle struck young girl. Travel was about six feet. There is a recall in other states but not ky.

- Livingston, KY, USA