ABS motor will not turn off after the consumer takes the keys out of ignition.

- Manassas, VA, USA

While traveling at 30 mph, consumer pressed brakes to avoid hitting a deer and vehicle started to slide. Consumer states ABS locked up. Driver and passenger sustained injuries, passenger sustained injury to vocal cord due to seatbelt failure.

- Reedsville, WV, USA

ABS motor was still running while vehicle was parked in the garage. Dealer contacted. Feel free to provide any further information.

- Sturgis, SD, USA

I already filled out a vehicle owner's questionnaire to send through the mail with my signature to authorize NHTSA to provide a copy of the report to the manufacturer. Reference no. 8008990. I included a copy of a recall notice on the 2000 Chevrolet Silverado 1500. The recall states: Light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an ABS motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the ABS would be non-functional. The base brakes would remain functional, but the dynamic rear proportioning system (drp), which optimizes front to rear brake balance, would become inoperative. This is the same malfunction my 1999 Silverado 1500 has. The ABS systems are identicle in the 1999 and 2000 Silverado. The replacement part number is the same for a 1999 and a 2000. I don't believe this is a coincidence, that this part has failed in my 1999, when in fact this is the same part in the 2000's that were recalled.

- Lock Haven, PA, USA

Consumer stopped vehicle, when he went to restart the engine, consumer noticed the motor running, after investigating consumer discovered the ABS brake module was still running after the engine was shut down and the key turned off, consumer removed the fuse for the ABS to get the motor on the brake module to stop running.

- Longview, TX, USA

Brakes locked up while the consumer was driving 25-35 mph, causing vehicle to crash into a tree. Contacted dealer who was not willing to do anything.. consumer has documentation that the ABS module malfunctioned, there were 2 injuries, consumer does not believe that the recall on the seat belts was not repaired.

- Reedsville, WV, USA

Control module failed, pump runs off of which makes ABS inoperable.

- Georgetown, IN, USA

Vehicle exhibiting antilock brake module and antilock brake valve failure.

- Poland, OH, USA

ABS computer malfunctioned causing loss of anti lock braking feature. ABS motor continues to operate after vehicle is shut down. Dealer disconnected fuse to deactivate the motor.

- Clayton, NY, USA

ABS was not working properly due malfunction of control unit. Dealer contacted.

- Mechanicsburg, OH, USA

Vehicle could be turned off and ABS motor would remain on. Repair shop notified, and informed consumer that ABS pump and module needed to be replaced. Dealer notifed. Feel free to provide any further information.

- Cleveland, OH, USA

The ABS light came on and the ABS pump runs continuously even after the ignition is turned off. The only way to shut off the pump is to disconnect the battery or the pumps power supply. Chevy says so far that they are unaware of the problem, but they are looking into it.

- Middletown, CA, USA

Consumer had to unplug ABS due to ABS motor running. Dealer contacted. Also the brake light is on. Dealer found ABS moudle failed.

- Lock Haven, PA, USA

The ABS module was making noise. Took to dealer and dealer indicated the electrical brake control module was faulty.

- Brunswick, OH, USA

Transmission causing vehicle to stall. The first shift solenoid broke and the sencond one cracked, the ABS module failed at 73554 miles causing the ABS pump to remain on, consumer had ABS pump disconnected.

- Lead, SD, USA

ABS brakes operate poorly making it difficult to stop the vehicle. ABS module failed causing the ABS pump continuously operate, component was disconnected causing the ABS to be inoperative.

- Lead, SD, USA

ABS and brake lights came on while driving 20-30 mph. ABS motor remained running after vehicle was turned off. Vehicle at the dealer. Consumer states ABS makes noise.

- Evansville, IN, USA

Gas pedal sticks every time you start the truck, which makes you lunge forward or backwards every time you drive. I have read numerous complaints on this situation & I think it should be recalled. The ABS system went out and when I took it to the shop they said it was very common for the Chevrolet, Silverado to do that, I think it should be checked on too.

- Arlington, TX, USA

ABS brake boxes failing. Causes box to run with the ignition switch turned off. Fuse must be removed to cut power to box. When power is cut ABS system no longer is in service. Boxes are not replaced at manufactures expense if vehicle is out of warranty. Cost is extremely high for consumer, $1000 to $1400. This problem is occurring with Chevrolet and GMC trucks equipped with ABS brakes. This situation creates a fire hazard, a braking hazard and economic hardship on the consumer.

- Greenville, NC, USA

Electronic braking control module, which is part of the ABS brake system, malfunctioned, resulting in lack of ABS brakes. Also caused battery to drain within 12 hours with vehicle turned off. Consumer disconnected fuse for ABS brakes to prevent battery drain, the motor continues to run after the vehicle is turned off.

- Palm Bay, FL, USA