When the ABS system is engaged vehicle experiences extended stopping distance. Dealer replaced ABS sensors, but the problem still occurred.

- Wexford, PA, USA

ABS system engages on dry road and or dry conditions and low speeds. This increases stopping distance greatly and could potentially cause a serious accident. This occurrs mostly when approaching a stop at 10 mph or below. The ABS engages unexpectedely and the vehicle continues to roll partly into the intersection or potentially into another vehicle.

- Butler, PA, USA

On multiple occasions vehicle failed to stop. Consumer was told by service writer for Chevrolet that ABS brakes premature engagement was the reason why ABS brakes surged.

- Parish, NY, USA

Vehicle is 2000 Chevy Silverado 4 wheel drive with approx 50K miles. At slow (under 15 mph) speed coming to a stop driver side front ABS engaged and almost hit car in front. At first I thought maybe wet road but it nows does it every morning when coming to a stop at the end of my road dealer said I need to replace front wheel bearing. Have an appointment for first week in Sept. And will have all parts saved.

- Charlestown, NH, USA

When the brakes were applied, the vehicle experienced extended stopping distance. The consumer had the ABS sensors cleaned but it was too early to see if the problem was corrected.

- Windber, PA, USA

The anti-lock braking system on the Chevrolet Silverado is too sensitive. I have had several incidents where the system activated when it should not have causing the vehicle to experience increased stopping distances.I consider this to be a major safety problem.I filed a complaint with your office several years ago, but have yet to see any action taken to correct this problem

- Duryea, PA, USA

My brakes failed after accelerating from being stopped at a red light. The light turned yellow before we were into the intersection when the vehicle in front of me stopped, speed was less than 10 mph. I attempted to stop on a bumpy dry surface while braking the pedal went to the floor and hit the vehicle in front of me. Dealership claims brakes were within specifications set by manufacture. Something needs to be done about this problem, there are too many complaints dealing with the ABS system on the Silverado. Please do something to correct this problem.

- Granbury, TX, USA

ABS failed prematurely. Dealer notified. Whenever the consumer came to a stop, when approaching another vehicle at a stop light, the ABS malfunctioned and caused the vehicle to drift into another vehicle in front.

- Attica, NY, USA

While pulling into driveway ABS system engaged and brakes failed. Dealer notified.

- Johnstown, PA, USA

While traveling 5 mph and applying brakes ve ABS system kicked in without any indication, causing vehicle to flip over.

- Johnstown, PA, USA

The vehicle experienced extended stopping distance. When the vehicle had come to a stop, the anti lock brake motor started, the pedal vibrated and pushed back adding the extended stopping distance. This was an ongoing problem but not constant. Recall# 00V055000

- Kent, OH, USA

The anti-lock brakes activated at very low speeds. The pedal moved upward and driver pushed the brake pedal with force but the brakes did not respond. The left front brakes failed 100% of the time and the right front assembly failed intermittently. Both front wheel bearing assembly/sensors were replaced. The brake pedal had become hard as a rock and would not stop until both feet were pushed with maximum force.

- Waterford, PA, USA

The vehicle experienced the same problem as recall (anti lock brake), #00V055000, however the vehicle identification number was not included in the recall.

- Milford, MI, USA

Brakes showing same failure as recall 0 0 V 05 5000. Call Chevrolet with questions of recall but was told that my truck was not effected by. My truck has shown the same problems that were summarized with recall listed above. Repair includes replacing brake pressure module valve.

- Hudsonville, MI, USA

The ABS brakes failed. The ABS braking system caused a resistance behind the brake pedal. Refer to evoq#8021722 scc

- Bellevue, WA, USA

Antilock system activated without cause and disabled the braking system. This happened on dry pavement at speeds below 30 mph when coming to a normal stop. This happened today and almost everytime I dare to drive the truck.

- Esperance, NY, USA

Applied ABS brakes at 40 mph.brakes started to catch then went to floor causing increased stoppping distance and vehicle collision.

- Benbrook, TX, USA

Consumer experiencing problems with brakes. Delayed stopping when brakes are applied. Feel free to provide any further information.

- Fryeburg, ME, USA

Dealer confirmed by inspection that ABS pump needs replacement at a cost of about $700 I did not have the repair done due to the cost.

- Canton, NY, USA

While applying brakes pedal sticks to the floor. Dealer has been notified.

- Burlison, TX, USA