Car stalls out when driving for no reason no warning signs or anything loss of all power no brakes working or steering wheel almost crashed brakes get hard and steering unable to use.

- Poughkeepsie Ny, NY, USA

The contact owns a 2006 Chrysler 300. The contact stated while driving approximately 40 mph the steering wheel locked without any warning. The brake pedal was engaged and the engine was turned off. Upon restarting the vehicle it resumed normally. The vehicle failure was not diagnosed nor was it repaired. The manufacturer was notified of the failure. The approximate failure mileage was 72,000. The VIN was unavailable.

- Jensen Beach, FL, USA

Gear shift stuck in park.

- Pikesville , MD, USA

After filling up engine complete shut down, after pulling into intersection. Problem has happened about 6 times. Very careful not to fill tank full. As we have researched this problem, and find there are a lot of people with the same complaint. Very dangerous. Don't know what to do because, Chrysler doesn't seem to acknowledge the problem.. any help is appreciated.

- Anthem, AZ, USA

Upon driving on the highway the legal speed limit is always 70mph. While following the flow of traffic individuals ahead of me started slowing down to a cruise speed of 40-50mph abruptly. While paying attention to the change in pace I slowed down as well to feel comfortable with the flow of traffic. When checking my rearview mirror to see if there was a opening to change lanes I noticed a Ford truck coming from behind at a excelled pace. With seconds before the contact I braced myself for the wreck. Without paying attention suddenly the driver from behind ran into my rear of my car. This impact not only shattered my entire rear window, but my truck caved in, both my tail lights were knocked out, and I was knocked into the next far right lane. During the impact I braced myself and hit the steering wheel, my driver side rear mirror was knocked down and the hazard wheel alignment lights came on. While all of this occurred I was shocked my driver side airbag didn't employ. I am a male, 5?8, 160 pounds so I am sure the electronics could tell a person was visibly in the seat. Had I not seen the truck come from behind I could've been thrown out the window. I am surprised of the malfunction and wanted to report it.

- Grand Prairie, TX, USA

The engine started ticking noticeably on the upper right side of the engine. The noise was typical of a lifter or worn rocker arm. About a month earlier the car had a shifting problem with the automatic transmission on an interstate highway under acceleration. The car was checked for the transmission problem at a Chrysler dealership but nothing was found after diagnostic testing was completed they did advise they found the strut bushings were in need of replacement. After hearing the engine noises the car was again taken to the Chrysler dealership. Both sides of the engine had the rocker arm assemblies replaced. The bushings for the struts were replaced. Both of the tie rod ends were found to be in need of replacement while they were trying to realign the front end. The alignment was needed after replacing the strut bushings. The car was well maintained and oil changes & lubes were done at or near every 3,500 miles. There are a massive amount of replacements/repairs being done for these particular parts failing at a low mileage.these parts are failing prematurely and Chrysler should take the initiative & recall these components. Reimbursing customers that have become dissatisfied with their cars and it's manufacturer are being burdened with unnecessary repair costs. I was fortunate enough to have purchased an extended warranty which covered all the costs (over $2,000). I still had to pay the deductible. NHTSA needs to find out what is happening and hold the manufacturer accountable. This was the first time I had to have repairs done since purchasing the car in 2008 with about 30,000 miles on the odometer. Dependability is one of the most important parts of owning a car and we all pay a lot of money to purchase/lease them. Paying for routine maintenance is expected but exorbitant repair costs are unacceptable when a car is properly cared for and not abused.

- Litchfield Park, AZ, USA

The car lost power and just stopped..no check engine light or anything. Locked engine. I always did oil changes and took good care of the car. Not only did the engine lock but the tire rods on the car kept breaking causing more issues..

- Saint Charles, MO, USA

The contact owns a 2006 chrylser 300. The contact stated that the vehicle would not shift out of park. The vehicle was towed home. An authorized dealer was notified and the contact was informed that the entire gear box would need to be replaced. The contact also stated that the steering wheel would turn freely to the left and right when the key was not in the ignition. The manufacturer was made aware of the failures, but offered no assistance. The vehicle was not repaired. The failure mileage was 77,179.

- Pooler, GA, USA

I have a 2006 Chrysler 300 limited the tie rod ends goes fast like every 9 to 10 months I check the car regularly an I notice that each wheels I jacked up had movement so I replace them again before it got worse er never had a car with this problem tie rod end last some times for 9 years or so if your in the country or city an no pot holes this problem need to be addressed.

- District Heights, MD, USA

I recently had new tires mounted on my vehicle and was told that the tire rods were worn badly. I just passed 42,000 miles on my vehicle. I was told by my mechanic that this has been an issue on many Chrysler 300 models around the same mileage. There are even two options for repair. You can have the tie rods replaced with standard equipment but will most likely have the same issue or Chrysler came out with an upgraded replacement with a lifetime warranty. Obviously Chrysler knows that this is an issue and should be an actual recall. I will be having the tie rods replaced tomorrow.

- Appleton, WI, USA

I have a 2006 Chrysler 300 and on Nov 24 2010 my tie rod end broke and had to be towed to the shop for repairs, it has been others with the same problems with these type of cars and I think this should be looked into by someone.

- Crockett, TX, USA

At 36,000 miles the inner tie rods are worn and very loose. Outters are worn but not as badly. Car is out of warranty (over 36 months). When I called the dealer they said this is a common problem and they have seen it happen at less than 36,000 miles. Failure consequences will be complete loss of steering control and accidents. This a serious and dangerous manufacturing defect and should be addressed immediately.

- Gloucester, MA, USA

The strut tension arms and tie rod ends had to be replaced at 68,000 miles. They were rusted due to there was no nipple to lubricate them. The mechanic said in another 60,000 miles the same thing will happen. This was an $800 repair.

- Yorkville, IL, USA

Tie rods failed at 31,512.

- New Castle, DE, USA

Took car in for oil change and to have front end shaking checked out. Was informed that the front tie rod was defective. Since I had an extended Chrysler warranty I took it to the local dealership for repair and found that it needed replacement but was not covered under the warranty. This is a 2006 vehicle with under 50,000 miles. Never had a tie rod go bad in anything else I've owned--and it looks like I'm not the only one.

- Lowell, MI, USA

Since I purchased my 2006 Chrysler 300 touring the idle has been very rough and you hear a moaning sound coming from the engine.

- Antioch, CA, USA