Radiator
If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the
radiator, please perform the following before replacing the radiator/cooler:~
1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings
on the radiator. ~
2. Remove hex nut and the top flared fitting on the radiator tank.~
3. Using a wire brush and gasket remover, clean off the old sealant on the smaller
threaded portion of the flared fitting. Do the same for the threads on the trans oil
cooler.~
4. Apply a new application of Mopar PN 04318032 to the flared fitting, leaving the
first threads free for ease of engagement.~
5. Install the top flared fitting by hand, then torque the fitting to 235 +/- 15 Lb-In.~
6. Install the hex nut and torque to 100 +/- 10 Lb-In.~
7. Repeat steps 2-6 for bottom flared fitting.~
8. Reinstall transmission line per normal installation procedures and ensure correct
fluid level.~
