Engine stalled and shut off while driving at low speed. Steering mechanism completely locked up. Pulled over best as we could and restarted.

- Choctaw, OK, USA

Engine shuts off while driving. Dashboard lights still work but driver is unable to steer and car is very difficult to stop. Will restart once in park. Vehicle was going 30mph on a city street. All recall repairs have been performed. This has happened multiple times. Dealership nor local shops can determine what is causing the issue.

- Byron, MN, USA

Engine stalls while driving, unable to steer as steering locks. Then difficult to restart. Doesn't happen any specific time. Been happening on multiple occasions.

- Doylestown, PA, USA

On the driveng the traction control light come on the steering went out and brkes went out I can not control anything

- Plainsboro, NJ, USA

It began with the front wipers coming on (as if it was raining) on a sunny day.. and the switch wouldn't shut it off. Have to pull the fuse to get them to stop. Then this progressed into not cranking, as if dead battery. I believe my problem is in the keyless switch.. as the battery is new, and I've had both battery and alternator checked. Both ok!

- Mobile, AL, USA

When driving, the engine switch turns off without warning while driving on a street. This is very dangerous. There is a recall with selected VIN numbers with this issue but not ours. The recall is Chrysler recall R03 (formerly L25). We would like our VIN number to be added to the recall list.

- Madison, AL, USA

Vehicle stalls between 20-40 mph on city streets and the traction icon comes on. Power steering immediately goes out and the vehicle must be pulled over and restarted. Problem was very intermittent when it first appeared 3/31/18 but now happens on almost every trip, typically near the beginning of the trip (11/21/18). Mechanic has failed to replicate, diagnose, or fix the problem.

- Edina, MN, USA

First problem is the drivers side back door does not open. It stopped working electronically and manually as well as the window. The lights on the dash flicker off and on, radio turns on and off, the van door dings, and it dies while slowing down or even when driving. It happens in town or on the highway

- Okmulgee, OK, USA

The engine stops at low speeds, never at highway speeds, not always but three times in the last 2 weeks, I have to restart the engine, this could cause an accident.

- Thief River Falls, MN, USA

The contact owns a 2010 Chrysler Town and country. While driving various speeds, the vehicle stalled without warning. Simultaneously, the engine and traction control indicators illuminated. The contact stated that the traction control warning indicator illuminated on an intermittent basis after restarting the vehicle in an attempt to correct the failure. The contact stated that the failure occurred seven times in one day. Granger motors Ford Dodge Chrysler Jeep (1708 sycamore street, granger, Iowa 50109, (515) 999-23224) was made aware of the failure. The vehicle was repaired per NHTSA campaign number: 14V373000 (electrical system, air bags). The manufacturer was not made aware of the failure. The failure mileage was approximately 110,000.

- Johnston, IA, USA

The contact owns a 2010 Chrysler Town and country. On several occasions, while driving various speeds, the vehicle stalled. The contact stated that the brake pedal was difficult to depress and the steering wheel was difficult to turn. The contact was able to restart the vehicle. The vehicle was taken to kimberly car city (located at 625 w kimberly rd, davenport, ia 52806, (563) 391-8300) to be diagnosed, but the mechanic was unable to duplicate the failure or retrieve a fault code. The vehicle was not repaired. The contact stated that the failure was intermittent. The manufacturer was notified of the failure. The approximate failure mileage was 123,000.

- Lillian, AL, USA

The contact owns a 2010 Chrysler Town and country. When the contact attempted to start the vehicle, he heard an abnormal clicking noise intermittently and the vehicle would not start. When the contact tried again, the vehicle started. The vehicle was not taken to a dealer to be diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 65,000.

- Killeen, TX, USA

My van caught on fire only driving it less than 5 minutes away from my house. Fire department and cops had to come and put it out.

- Endicott, NY, USA

The contact owns a 2010 Chrysler Town and country. When the vehicle was started, the motor mount shifted out of place and caused the vehicle to make a grinding noise in the transmission. There were no warning indicators illuminated. The vehicle was taken to an independent mechanic where it was confirmed that the motor mount needed to be replaced. The contact called several dealers, including the barbera autoland (215-333-3700, 7810 E roosevelt blvd, philadelphia, pa 19152) and was informed that the part was on back order. The manufacturer was made aware of the failure and stated that the part was on back order. The vehicle was not repaired. The failure mileage was approximately 148,000.

- Philadelphia, PW, USA

Stalling problems: Vehicle stalls out at stop lights and coming to stops in traffic on highway. The vehicle would re-started after putting in neutral. The car has stalled when slowing down and making left hand turns. This is very dangerous crossing through the intersection and not knowing if your vehicle will stall out or not. It is becoming more frequent, it happened 5 times on the one trip. I thought I purchased a really good used vehicle, and I think someone just passed on their problems to me. My husband's friend replaced the egr and it stopped doing it for a few days and then started stalling again. So I parked it for a few weeks. This past Friday I took to the mechanic. The mechanic road tested vehicle with scan tool, performed data scan. No codes present/active or stored. They performed complete fuel injection/combustion chamber fuel service. Cleaned throttle plate area. Cleaned combustion chamber. Added fuel system cleaner to fuel tank to clean fuel injectors. Replaced spark plug wires and all spark plugs, erased memory, then re-test drove with scan tool, ok at that time. They advised us that they were unable to duplicate the stalling concern at that time. On Saturday I picked up and it hesitated when going through the intersection, but otherwise seemed ok. On Sunday stalled out at the two red lights in town, but restarted ok. Then after driving on the highway for a half hour, at the exit it stalled at stop sign and did not want to restart - 3 tries before I could get it going. So displeased with this vehicle, and I am worried about driving my daughter and nieces around in it! I wish someone would just tell us what is wrong so we can get it fixed.

- Verona, PA, USA

Ever since Chrysler issued a recall and replaced the ignition the car stalls while driving down the road. All power is lost and we have to pull over and hope the car starts. Usually it does however sometimes it requires a jump start. It's not a bad battery! I have had it tested and I continued to use the same battery to this day. Over a one year time I have logged probably 50 stall events. Moisture humidity seems to make it worse. Learned this when I moved from Maine to tucson. But now it's stalling a lot here in tucson although it is monsoon season. The dealership said it was due to the weight of keys hanging from the ignition key, the problem is I bought the car new and have never had anything attached to the ignition key. I only carry the ignition key by itself. Nice try Chrysler, but you are wrong. I need to state this stalling problem did not occur until Chrysler issued a recall to prevent stalling instructing the dealership to replace the keys and ignition. Chrysler says it''s my problem I need to pay to fix, I say they created the problem and need to pay to fix. Maybe the ntsb should investigate! didn't GM have a problem like this?

- Vail, AZ, USA

While driving, the engine cut out and I lost power to steering and brakes. The traction control light then came on when I finally pulled over. After resetting, the vehicle started and drove normally. If this happened on a busy road, serious injury would have occurred to the passengers in my vehicle and anyone else I would have struck due to loss of control.

- Seymour, CT, USA

I have 2010 Town and country that has a intermittent cranking problem. I have taken it to two Chrysler dealers and they have kept it for several days and then they tell me they can't find the problem, the dealers say when they have the van hooked up to their diagnosed machine the test does not duplicate. All cranking issues are happening at home and when we are out and about, the van does shut off sometimes after cranking. We have taken van to dealer for a recall that we received pertaining to wireless ignition nod.the fix did not resolve the cranking problem. This cranking issue happens when engine is cold or hot, no lights come on instrument and no codes are stored to help find the problem. The two dealers have checked battery, starter, all grounds, fuel pump relay, fues, any thing they could think of, still no fix. This has been going for two years, please help, mr CEO of Chrysler please help your owners of your vehicles.

- Hampton, GA, USA

Engine stalls in the first 5 minutes of driving. Sometimes it is difficult to restart, other times not difficult to restart. Occurs 20 mph or slower. Usually while slowing to stop or turn. Has bee happening intermiitantly since January.

- Santa Maria, CA, USA

Approximately two months ago the 2010 T&C began being sluggish to start. We replaced the battery and it started fine. A week after it began to stall with the dash lights turning on and off. A day or two later it began to stall and turned off in traffic. The battery has been checked and it is functioning - the local mechanic performed a diagnostic test and no code was present. Currently it had stalled and turned off several times - extremely stressful and dangerous.

- Mayaguez, PR, USA