The contact owns a 2008 Ford Escape. While accelerating from a red light, the engine stalled without warning. The vehicle was not able to restart. The vehicle was towed to a dealer where it was diagnosed that the transmission failed and need to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 124,000.

- Burlington, NJ, USA

On my way to work today, my car starts to slow down when I try to accelerate. The car eventually jerks forward and starts to go faster after the RPM goes up to 4. I thought it was the transmission slipping until I see the wrench shaped light come on. I turn around, put my flashers on since it's happening off and on and immediately take it home because I don't want to get stuck this far away from home. When I get home, I check to see what the wrench light means and find out it's a throttle body issue that for some reason there is no recall for even though it's an on-going issue.

- Ridgely, MD, USA

Ford won't honor recall 14S05 they did a software update and but now I need an entire power steering torque sensor replaced and they won't cover that. Other consumers have complained on line that Ford won't repair your steering after having your recall software done. A Ford Escape recall gotcha ' recall 14S05, Transport Canada... https://medium.com/@joewardpr/A-Ford-Escape-recall-gotcha-recall-14S05-Transport-Canada-201413-7F0D7ca0D84C Mar 17, 2015... Ford 'closed out' the recall after only updating software and won't pay for the... a facebook group exists entirely about Ford not 'honoring' recall #14S05....

- Anchorage, AK, USA

"wrench" indicator light and vehicle symptoms of high rpms in teh 3.5 to 4 range at low speeds (cycling from 1st gear to 2nd and 2nd to 3rd) on city streets 0-35 mph. Engine codes not yet read, but similar issues reported as a fault in the throttle body. Consumer satisfaction program 13N03 has identified the problem for same make and model starting in manufacturing year of 2009. My car has a manufacture date of 01/07, though it is a 2008 and is only about 126,000 miles. This throttle body fault should be identified in other years of manufacture if the reports are documented.

- San Bruno, CA, USA

Turning right onto a major intersection, the vehicle would not accelerate to effectively merge into oncoming traffic. After letting off the gas, then reapplying the accelerator, the vehicle finally began to increase it's speed. Took it into the dealer, discovered the vehicle would need it's 2nd transmission overhaul in less than 18 months.

- Olathe, KS, USA

Shitting cable came off transmission. It said it was in park but when I tried to get out the car continued to move forward.car was on street at time. Could not put car back in park

- Kane, PA, USA

Takata recall - vehicle transmission slips, engine revs and decelerates while driving, ignition switch will not start car each time. Sometimes it takes twenty tries. I have read hundreds of these complaints on the internet.ev

- Earlysville, VA, USA

Car will not start unless the key is forcibly inserted into the ignition. This has to be done several times. When exiting the car, it will ding to alert the driver that the key has been left in the ignition but the key has been taken out of the ignition.

- Knoxville, TN, USA

I received a recall notification 14S05 from Ford about my 2008 Ford Escape. The recall was for a faulty torque sensor that would either be reprogrammed or replaced. Instead of replacing the torque sensor, Ford service decided to just reprogram it because it had not failed or produced a service code. Just recently the torque sensor failed and my steering lost power while driving through a parking lot. I did not have the strength to turn the wheel and had to just stop and leave the car in the lot until someone could come help me. I brought my car back to the same dealership that performed the original recall repair and am being told that the recall has been performed and now I must pay them to replace the torque sensor. After spending time researching the issue online I discovered that this is a widespread problem. It is apparent that Ford is only replacing the sensors if they have already failed when you bring your car in for the recall. If it has not failed then Ford only does a reprogramming that doesn't prevent them from failing but allows Ford to close out the recall on your vehicle and save money on a replacement part. I don't understand how this is legal for them to do. I talked to several of Ford's service managers and customer service representatives and they all give the standard rehearsed answer.

- North Las Vegas, NV, USA

Wrench light on... trouble shifting... higher rpms when shifting

- Camdenton, MO, USA

Pulled into driveway, stopped, put the car in reverse - car would not move, engine just revved without moving; put it in D and nothing again. Turned off engine, restarted it, put it in gear and it kinda jerked backward. Sometimes the gears would engage, sometimes not. Noise coming from transmission area sounds like a blender on low speed. Mileage is 87,000. It is a 4WD. Have not yet determined whether it is the transmission or the transfer case - I'm nine miles from a dealer/garage and don't think I can make it there. Would probably have to tow it. I've parked it in a garage until a mechanic can respond to my residence. Had no problems with drive train until this happened. I've read that 2008 Escapes have had some problems, but this one is not under recall at this time.

- Salem, OH, USA

I own a 2008 Ford Escape. My wife was at work and when she started to drive home noticed the steering wheel difficult to steer. Luckily she was driving straight on the highway on the way home. She did notice vibration of the steering wheel. I took it for a test drive and noticed it was very difficult to steer or turn at low speeds. Also the steering/powertrain wrench light had come lit. It was evident the steering assist had malfunctioned. After some research I became aware of an electric power assist safety recall on 2008-2011 Ford Escapes. Which is the exact same issue I'm having on my 2008 Ford Escape. I contacted the local Ford dealer and was told that according to the VIN number there was no recall announced for my vehicle. This makes exactly no sense to me because its the exact same issue and vehicle for which the recall was made. I'm basically on my own to fix at this point.

- Connell, WA, USA

I put my 2008 Escape in park, removed the keys from the ignition and exited the vehicle. I walked approximately 60 yards and was informed by a bystander that my vehicle was rolling away. The 2008 for Escape rolled approximately 200 yards down hill into a tree. I went to the vehicle and the gearshift was now in the "R" position after striking the tree. I know there was a recall for such a problem on certain Ford Escapes. According to Ford my VIN number was not included in the recall.

- Collegeville, PA, USA

I purchased my 2008?Ford Escape last year 2015. I have replaced both cv axils on each side and I had my steering column replaced. I purchased the car with 95,000 miles on it at a great deal of $8,900. I then found out why it was so cheap from such a trusted dealership. The dealership was closing in the next 2 weeks. It closed shortly after my purchase and a new Ford dealership opened in its place. Through out the last few weeks my car has not been driving correctly, especially on the highway. I took a closer look and noticed that no matter my speed my car will not go above 3rd gear. My power tran light came on today. I have read on other sights that there were recalls on this issue. I do not think these issues were fixed while being recalled. The related I've done so far have not been cheap by any means. After a year (even less 2 of the above cases) I should not be having these issues. M.carcomplaints.com/Ford/Escape/2008/recalls/ the above sight was my reference tara

- Minerva, OH, USA

Have to force the key into the ignition really hard and turn the key many times before the vehicle will start.

- Knoxville, TN, USA

Vehicle power train light came on. Vehicle began to shutter then lose power on the highway without a shoulder. Vehicle reduced speed to max 20mph.

- Houston, TX, USA

Truck is accelerating and switching gears on its own. While at a traffic light, a wrench light pops on and the truck begins to switch gears. Once the truck is turned off, the wrench light goes away but returns after driving begins again. Truck is not getting enough power when driving as if it is going to shut off. There are also jerking motions while driving.

- Columbus, OH, USA

The mecs coolant pump fails without warning causing the DC-DC inverter and hybrid drivetrain to instantly shut down without warning at interstate speed. You get the red triangle and stop safely now with the engine turned off leaving you to coast across 4 lanes of the interstate to get to the shoulder. You must completely stop and put it in park before the car will restart. This is such an important hazard to life and limb that there needs to be an immediate recall. This is a well-documented problem that Ford knows about. Online it says they recalled them but the dealer said that they did not recall them. If you touch the brake with the engine shut down the car comes to an immediate stop automatically in 3 seconds. Leaving the interstate traffic to veer around you. Mine failed intermittently last summer. Now every hot day the car just turns off on the interstate 5-6 times a day. Someone is going to get killed over this. It needs an immediate recall to avert a loss of life. I checked my coolant pump and it is not functioning. The recall I see says they are removing the dorman brush rotor pumps and replacing them with Bosch brushless rotor pumps. The hybrid drive only fails at interstate speed when it is a warm day. The car started doing it last summer when it had 70000 miles on it. It is no longer intermittent but occurs daily now.

- Urbandale, IA, USA

When starting to accelerate from a traffic light, the engine raced to over 4K rpms and the car was barely at 20 mph. No acceleration and the wrench light was lit on the dash. Rpms randomly fluctuated and only after reaching 3,500 rpms would the transmission shift gears. After shutting the engine off and restarting the wrench light is gone but returns after a minute. 105,000 miles.

- San Mateo, CA, USA

I notice about a week ago that a wrench light signal came on my dash. I checked my owners manual and google the information and then I check to see if there was a recall. I can feel my car doing a pull when I try to accelerate and when on the freeway I am not getting not power it seems like I am moving slower than what my speedometer says, I see that there has been a recall for this issue but not for my VIN number. I guess I don't understand how centain VIN # an be excluded from a recall but you have the same issue. This is the same thing that happen about 1year ago to my power steering there were recalls but not for my VIN. I was out $1000. Now I have I have get this fixed and my mechanic can not do it because he said something about you need a computer and I need to take back to Ford which is going to cost and arm and a leg. I am so done with Ford I have always had Ford cars/trucks but I am at my end with them.

- Minnetonka, MN, USA