Driving in a parking lot 36K miles and then throttle pedal acted useless, engine idled down rough. Power train light came on (wrench). Turned off the ignition, restart the SUV it took longer to catch then normal. Drove fine for about 30 more miles till I got to the dealership. I was told it needed a new throttle body and it was a 670$ fix.

- Lewisville, TX, USA

The vehicle is a 2010 Ford Escape. Driving my 2010 Escape the engine stalled. The speed I was going was about 20 mph. With no prior warning the wrench light came on, the RPM's fluctuated and I could not accelerate the vehicle. The dealer said it could be a number of things but after investor I found in the internet very similar behavior with other Ford Escapes and it said that at the end it was the electronic throttle body needed to be replaced I waited after 3 days with my car at the dealership and called them and told them to check the throttle body. They confirm that it needed to be replace, but I told them and yet I had to pay for diagnostics and the replacement of the throttle at my expense as it was not under warranty. This engine stall issue occurred 08/17/2013 to 08/19/2013 ( 5 times).

- Miami, FL, USA

When driving I loss all acceleration. The acceleration pedal has no effect while depressing. A red wrench icon illuminates on the far left end of the display console. Once in awhile the engine light would illuminate. The owners manual icon description reads "throttle control/power train. This occurs unexpectedly on several occasions. I activate the hazard lights and pull over to the roadside. The SUV will shake, but will not shutoff. I will shutoff the SUV and then would have no problem restarting.

- Portsmouth, VA, USA

Car stalled while I was driving over the railroad track. After barely got it to go over the railroad (luckly train didn't come while I was barely moving) pulled over to side and shut the car off and started back up. Wrench looking light and engine check light came on while it was trying to stall, it happened 2more times while trying to make it back home. After few checking around it is caused by the faulty throttle body.

- Centralia, IL, USA

Vehicle was moving. The gas pedal lost control for acceleration and the car came down to an idle and it's thrusting itself forward to move. The gas pedal would not react. The yellow wrench light came on.

- Champaign, IL, USA

While traveling on the interstate at 70 mph, the throttle control stopped. The engine maintained running but there was no throttle control. I was forced to cut across traffic while losing speed to reach the shoulder. After stopping, turning off the car and restarting all control returned. I took car to Ford dealer and upon a diagnostic was determined that code P2112 and the etb failed.

- Virginia Beach, VA, USA

This is the second incident on vehicle, which occurred on Aug.13,2013 while driving approx.35/40 M.P.H. everything was almost exactly like the first incident, except this time the check engine light stayed on until the next day when I returned it to my Ford dealer for repair. The Ford dealer replaced ( not for free ) the throttle body & motor asy. They said it was a loss of communication from the tps sensor inside throttle body. Anyhow the car is back on the road tonight, Aug 15, 2013 & seems fine. Hope it stays like this. Ps -- as an after thought the Ford dealer couldn't have been nicer.

- Bear, DE, USA

My vehicle started shaking and the wrench light came on I pulled over and turned it off, restarted it and was able to drive home the next day it happened again and I drove it into the dealer that I had just purchased the vehicle from 6 weeks earlier and they determined it was the throttle motor. The vehicle is still under warranty but they want me to pay for half of repair and I have discovered this is a common problem in this vehicle and I am afraid if they put in the same part I will continue to have this problem down the road.

- Daytona Beach, FL, USA

While traveling at hwy speed accelerated to pass slow vehicle, vehicle was delayed going into passing gear and clunked into passing gear. Had to let off accelerator to upshift into 6th gear. We would like to know if there has been an opened campaign for this issue.

- Madison, AL, USA

While driving at highway speed, vehicle stalled, no power, we had to pull over onto the shoulder. The wrench icon was displayed. After turning off the vehicle, we were able to restart engine and travel home. The same thing happened two more times. Luckily, we were able to pull over with no collision, although on two occasions, traffic was heavy. After the third incident, we made an appointment at our Ford dealer service department. They diagnosed throttle body failure and replaced the throttle body at the cost of $500, not covered by warranty. Mileage on the odometer is 55,000. Why has there been no recall on this part" are you waiting for serious injury or death" this is an extremely hazardous incident waiting to happen. Ford Motor Company and the NHTSA are obligated to protect the public and issue a recall as soon as possible.

- Traverse City, MI, USA

I was driving from san diego to orange county on interstate 5, which is always a very busy highway around 50 mph when the car did a slight hesitation and then a quick surge and then lost power. It did not die but was only moving at 4 mph and the gas pedal did not have any power, no response at all. I was in lane 4 of a 5 lane highway and finally was able to get to the left and pull off in the center of the interstate. I turned off the ignition and set there for a few minutes trying to gain my composure. The car started right up and seemed to be okay. I took the car to the Ford dealer the next morning and they said it was a throttle body problem but would take 8 days to get the part and it is not covered by the warranty. The throttle body unit usually does not have to be replaced until 100,000 miles. I have 34,000 miles and maintain my car as recommended by the Ford Motor Company at my Ford dealership. I believe the unit must be defective and should be recalled before someone is seriously injured or killed. It was extremely scary not knowing if at any minute another vehicle would run into the back of my car going 4 mph on a busy interstate!

- Lake Forest, CA, USA

On July 4, 2013 I was driving my 2010 Ford Escape on I-235 South in Oklahoma city at approximately 70 mph when the forward momentum of the vehicle dropped out and it began to decelerate. I attempted to continue forward momentum by applying pressure to the accelerator but with no response from the vehicle. I coasted the vehicle across lanes of traffic to the shoulder of the highway. Once stopped I placed the vehicle in park and the engine was sputtering and losing rpms. I identified the power train (wrench light) on control console was lite at which I observed the vehicle. I applied pressure to the accelerator to increase rpms at which no success was noted at that point I cut the power to the vehicle. I allowed the vehicle to sit for 5 minutes and then restarted the engine with some sputtering. At that point I applied pressure to the accelerator and immediately the rpms increased and the vehicle returned to operating normally. Similar action repeated on Aug. 13, 2013 X 4 times on the same highway: Once during morning traffic traveling at approximately 60 mph and then three times during evening rush hour traffic traveling 20-40 mph. Problem was identified as malfunctioning throttle body by Ford dealership mechanic. Failure acted during high traffic situations which could lead to a potential accident or injury to operator and surrounding motorists. Upon further research it has come to my attention that there are multiple failures of throttle bodies in 2010 Ford Escapes which had to be replaced at the owner's cost and Ford has not issued a recall for this defective component.

- Oklahoma City, OK, USA

Vehicle lost power in thruway traffic. Engine continued to run, but not able to maintain speed. Yellow service engine light and red wrench light appeared on dashboard. Had to turn off vehicle and wait to start. Then power was fine for another 10 or so minutes, then the same thing happened again.very dangerous in heavy traffic.

- West Seneca, NY, USA

Car stalled with a wrench on dashboard. Had to turn the car off and on again. Took longer to start.

- Rochester Hills, MI, USA

While sitting at a stop light my vehicle seemed to lose power and the wrench light came on. I limped my car to a parking lot and once shut down and restarted it seemed fine. It worked fine for 3-4 days and it occurred twice on my way to work while traveling approximately 35 mph. Once again the wrench light came on and once shut down and started fine. The second time the check engine light also came on. I brought my vehicle to a mechanic I know and trust and said the code that came up was P2111 and I would need to bring it to the dealer for repair.

- Tacoma, WA, USA

I was driving along I30 and gas pedal stopped working. I had to cross over 2 lanes of traffic to get out of the way. My car was idling roughly and gas pedal still did not make my car go. I turned car off. My car would start but when it got past 30 mph, the gas pedal stopped working again. I called my husband and he brought our truck and trailer, and we hauled it home.

- Canton, TX, USA

Wrench light lit up on the dash, car decelerated and stopped in the roadway and traffic. Engine was still running, but no response from the gas pedal. Turned the car off for 10 minutes. Started again and drove it home. Could have been a dangerous situation on a more crowded roadway. Based on internet research, a recall on the throttle body should be issued.

- Huntsville, AS, USA

The contact owns a 2010 Ford Escape. The contact stated that while driving approximately 40 mph, the vehicle failed to accelerate. The engine and wrench warning icon illuminated as the vehicle proceeded to engage into limp mode. The failure recurred intermittently. The manufacturer was not made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 64,000.

- Highland, MI, USA

July 2, 2013, I just pulled out of my garage, came to a stop sign, made a complete stop, proceeded to go forward, had my foot on the accelerator, RPM gauge started going up and down, the wrench light came on, the vehicle started to slow down even though I had my foot on the accelerator, I pulled to the side of the road, the vehicle just stopped and then started to shake, I turned off the vehicle. I waited a few minutes then I started the vehicle again and everything was fine. I went to the Ford dealership because the vehicle is still under warranty, they first told me that the computer chip needed to be updated. August 2, 2013, I was driving for about 30 minutes going at 55 mph, the RPM gauge started going up and down, the wrench light came on and I could feel the vehicle lose power even though my foot was on the accelerator, the vehicle went from 55 mph to 20mph within a minute, I pulled over to the side of the road as the vehicle started to shake, turned off the vehicle and waited a few minutes, restarted the vehicle and everything was fine. Call the Ford dealership and dropped my vehicle off for inspection again, they called me and told me that it was the throttle body valve that sticks and that Ford is aware of the problem. The Ford dealership is unable to get the part because its on back order, I have to wait 2 to 3 months for this part. August 9, 2013, I was at a stop sign, I proceeded to go forward while pressing on the accelerator, the vehicle lost power, the wrench light came on and I again was unable to accelerate, I pulled to the side of the road, turned off the vehicle, waited a few minutes and it started again.

- Owatonna, MN, USA

We were riding on interstate 40 traveling at about 75mph. My 18 year old son was driving. The vehicle suddenly lost power. We had to pull to the side of the interstate. Luckily there was not any traffic or transfer trucks directly behind us. Without warning, the vehicle lost power and the 'wrench light' came on. We immediately dropped down to about 40 mph. We sat beside of the interstate and called my husband to come to where we were. We did not attempt to crank the vehicle while waiting for him because we did not know what was wrong and feared causing further damage (I was not familiar with the throttle/powertrain light warning). When my husband got there, we cranked the vehicle and I drove us home without incident. I was afraid to allow my son to drive it because I feared the same thing would happen again. I hate to think what could have happened had there been another car or a transfer truck behind us. Due to the fact that we lost power without warning and so suddenly, I feel that if there had been a transfer truck directly behind us it would not have had time to stop or slow down and it would have hit us. Thankfully, we are scared, but fine this time. We are now afraid to drive my 2010 Ford Escape on any interstate or in any fast moving traffic.

- Dunn, NC, USA