The purge valve problem persists well into this model year. The car is hiccuping and stalling at lights and has difficulty starting after fueling. I find it appalling that reprogramming the "check engine" light to acknowledge the defect, rather than actually repairing the defect was considered an adequate solution. My car has 59,000 miles and is just out of warranty. I think had this purge valve problem (rather than just the engine light symptom) been properly addressed by the NHTSA and Ford, my family would be safer in this car. I will never buy a Ford again.

- New Orleans , LA, USA

The purge valve has been an ongoing continuous problem since we bought the vehicle. I have fixed it multiple times. It-??s caused the vehicle to stall after putting gas in the tank, and just recently stalled while driving, causing me to hit a curb leading to the passenger front tire popping, the rim being dented, the tire rod bent, alignment out of wack, and the valance ripped off. It also caused a dashboard light to pop up saying Hill Start is Not Available. I was in the car thankfully alone and not with my children. The windshield wipers are a fairly newer issue, they come on whenever they want with the switch being touch. But won-??t come on when I try to do it myself. I had my mom take a photo of the steering wheel/road while I was driving to show the severity of the alignment needed, it-??s causing extra wear and tear EXTREMELY fast on tires. Rainy season has begun and this is absolutely unsafe and not my responsibility.

- Oklahoma City, OK, USA

Slave cylinder on 2018 limited edition focus rs, i was driving home and pedal instantly fell to the floor! In the middle of the highway right before my exit and I had to do some rather scary driving when the car wouldn't change gears & stalled. I had to get the car to emergency lane/shoulder to pull over! No previous signs/warning lights or vehicle drive ability leading up to complete catastrophic failure of said slave cylinder. It's currently at the dealership where I had it towed with the clutch still on the floor &. Although the clutch was still on the floor the dealership took 2 DAYS TO "DIAGNOSE" the issue with the vehicle when its obviously a hydraulic issue with either the master cylinder or slave cylinder smdh thats an issue in of its self but i digress.The dealership did confirm that it is indeed a complete failure of slave cylinder. I've read that this is a known issue with ford focus vehicles that ford is well aware of yet they haven't recalled this part let alone acknowledge said issue when brought in for replacement. This is the 2nd time I have an issue with the slave cylinder which I had replaced 26,000 miles ago my vehicle currently has 126,699 but I replaced slave cylinder @ 104,568 miles so new slave cylinder doesn't even have 30,000 miles on it.

- Stockton, CA, USA

NHTSA number 18v845000 and 18v735000, my car is showing the same symptoms transmission and purge valve and should be included in these recalls

- Carrollton, GA, USA

While driving my car cuts off in the middle of the intersection of one of the most busiest streets where I live causing someone to bump into me nothing major but I was already still at that point with my Emergancy signals on but the oil pump went causing my car to shut completely off oil light comes on I contacted a mechanic just to look and he said my oil pump blew I have a crack in the pan smh no warning until it happened found out it-??s a common issue with fords it really sucks

- New Haven , CT, USA

[XXX], oil light came on, and engine fault light, That day I made a appt at the dewey ford dealership, in ankeny iowa, for monday, august 8..., I had no car problems before this date ( the 5th) august 9th, dewey texts me to let me know, the oil pump failed, and there is metal contamination in the engine and the turbo, I need a new engine and turbo charger.. to the tune of $6249.71 dollars my car is a 2018 ford focus with 50.500 miles on it !! They are saying there is not any warranty on the car, .. I see that there are some class action lawsuits for ford, with the very problem I am describing.. of course no one from ford has mentioned that... please let me know what to do... Thankyou for your help [XXX] [XXX] [XXX].. text only please.. dont hear well ( or e mail ) INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

- Des Moines, IA, USA

As I was driving my 2018 Ford Focus, the check engine flashed on. Almost as soon as I noticed it flashed on, it went away. Several more miles down the interstate, it came on again. Almost as soon as it came on, a warning displayed stating Engine Temp Hot, Stop Safely. As I started to pull over onto the shoulder, the power steering went out and then the brakes became extremely hard to push in. As my car slowed down I noticed smoke and as soon as we stopped flames came out from under the hood of the car. I called 911 and the Indiana State Police came and Incident # 2023-00344031 was filed after Pike Township Fire department extinguished the flames. State Farm Insurance was contacted and my car was deemed a total loss. I have photos but the website wouldn't upload the photos.

- Indianapolis, IN, USA

For a couple months I-??ve noticed after I pump new gas, my car hesitates. It acts as if it-??s going to turn off. I see this is a known issue but not for my year which is absolutely crazy. Not to mention how the car has jerked when you take off from a stop. This has been going on since I purchased the car new & I-??ve continued to be told -??it-??s normal-??. Nothing normal about a car hesitating and jerking.

- Smyrna, TN, USA

There was an immediate loss of power while on the highway driving normally at about 70mph. There were no codes indicated previous to this incident, after vehicle was in a safe location I checked the codes. I believe it is the fuel tank purge valve as all symptoms point to that. It-??s a known issue for this vehicle but for some reason my model/ year isn-??t covered.

- Georgetown, TX, USA

1) purge valve, available for inspection 2) causes stalling when driving and difficulty starting after a fresh refueling unless completely pressing onto the gas pedal 3) problem confirmed, Ford refused to fix the issue 4) inspected through diagnostic tools 5) several codes and the check engine light. Identical to recall 18S32 but 2018 Ford Focus S is not within the accepted years. Any sudden change in speeds will cause it to jolt and seize and/or rev the engine to over 4000 rpm even if less than a 5mph shift in speed Ford has a audio recording of several calls tied to the matter within the last week (31Mar-6APR and ongoing) Issue has been ongoing for several months

- Clayton, NC, USA

Car does not start or stalls when new fuel is added, poor fuel mpg. Check engine light with 1450 code. Recall on other fords 18s32 has the same issues but is not covering this model.

- Clayton, NC, USA

Initially the check engine light came on; took it to service center and the fuel sensor was replaced. Check engine light comes on the next day which revealed an evap code error. Suggestion was take it to dealer for recall check. Safety became an issue when the vehicle sputtered and stalled on the highway. I visually inspected the fuel tank which appeared "sunken" which suggested a vacuum pressure problem which the dealer also confirmed. All this is part of a recall which "should" include my VIN, make, model and year.

- Lanham, MD, USA

The check engine light came and the code for CPV show up. When you put gas in it doesn't start up right away like it suppose to. And the acceleration take time on occasion. Basically what the recall said for the car. But the dealship says my Vin numbet doesn't match the recalled so I don't know what to do.

- Georgetown, SC, USA

The check engine light came on and the code reads P0456. The car also has a rough idle and loss of accleration power. We had the car inspected at the mechanic and the shop said the Cannister Purge Valve (CPV) needed replaced and the PCM software needed to be updated. They notified us there was a safety recall on 2012 - 2018 Ford Focus - #18S32 that describes this exact issue, but when we contacted Ford, they said even though our car was a 2018 Ford Focus the VIN # was not included in the recall. Ford suggested we report the issue.

- Myrtle Beach, SC, USA

I keep having an off and on check engine light with a P1450 code for the last two months. I-??ve looked up my vehicle history. I found that my vehicle came up as a 2.0L GDI engine type which my car would qualify under the recall. But when I look up my vin, it tells me no. What do I do? I just financed this vehicle in October.

- Oakland, CA, USA

Hesitation, stuttering, and lack of power have plagued me since purchasing 2022. When I put my foot on the accelerator the car should go. My car decides to take a coffee break, then smoke break, then bathroom, another smoke break then decides to go.

- Independence, MO, USA

My vehicle is the same year make and model and engine as the one on recall. But my VIN isnt. But I having issue with the recall part. October as pumped gas, my vehicle started sputtering and cut off, thought may of been bad gas. Well each time I add gas, it starts sputtering, dies and stalls at starting. I looked it up and realized purge valve on car was obviously causing, my issue. Couple weeks ago on January 20th I drove vehicle to do a dash and my car didnt want to change out of first gear, like the transmission was going bad, I literally had to shift to low gear adn back to drive and next day it died on me at red light but started back up. Well 1/30/23 was on way about mile from store to add gas, had 10 miles to E and my car died going 45 mph and wouldnt even start back. Luckily noone was behind me or my son and his friend may of been hurt from getting hit. Due to car shutting off going down the rd. I contacted dealership and was told no recall on my VIN but same year make and model and 2.0 gdi engine.

- Bremen, GA, USA

FORD REFUSAL OF NO COST SERVICE/REPLACEMENT for an ACTIVE RECALL on 2018 FORD FOCUS Canister Purge Solenoid Issue: Engine stalls at idle. Engine underperforms at lower speeds (under 40mph). Engine does not start immediately after refilling gas tank. Check engine light is on. Independent (i.e. non-dealer) mechanic checked on 09Feb2023. Diagnostic codes report Canister Purge Solenoid error. Independent mechanic noted a FORD recall (reference: 18S32) for 2018 Ford Focus Canister Purge Solenoid replacement, but my VIN does not show an active recall. FORD Customer Service and local dealers refuse to include my VIN on the active recall. FORD has not offered any opportunity for an appeal to have my VIN included on the recall.

- Windsor, VA, USA

Got engine lights and promble truning on and when accelerating and deccelerating car will shake and wont change gears. Took the car to have a diagnostic told purge valve has some damage and was told some ford focus where being recall for this promble.

- Hereford, TX, USA

The vehicle is a 2018 Ford Focus SE sedan. The purge valve canister caused my car to stall in traffic and it would not start for up to 20 minutes the recall number is 18s32 but my car specifically does not have this recall, the service engine light is on it turned on right before the car stalled, this is a safety issue because it could lead to a crash due to stalling. The transmission is slipping when it is cold outside and it will not shift until 7,000RPM there is no recall on this but my vehicle has 74xxx miles and should not be having this issue, there is no warning light about the transmission. Ford is going to do a diagnostics for my purge valve but has stated they will not repair unless I pay for it due to lack of recall.

- Chubbuck, ID, USA