When applying the ABS brakes the pedal will travel to the floor, causing extended stopping distance which nearly caused a collision.

- Plano, TX, USA

Vehicle ahead stopped suddenly. Consumer applied brakes hard, vehicle required exdended stopping distance and rear ended vehicle ahead.

- Grand Prai, TX, USA

While driving applied brakes hard when vehicle ahead stopped suddenly, pedal went all the way to the floor, causing extended stopping distance, resulting in a rear end collision.

- Grand Prai, TX, USA

Anti-lock brakes do not work properly experiencing extended stopping distance.

- The Woodla, TX, USA

Pedal went to floor.

- Cumming, GA, USA

Anti-lock brakes fail intermittently.

- California, MD, USA

Anti lock brakes fail intermittently, causing loss of brake control.

- Asheville, NC, USA

Brakes lock up.

- Hawthorne, NJ, USA

ABS brakes; when applying the brakes in normal conditions, the brakes locked up/failed to stop the vehicle, causing an accident.

- Parsippany, NJ, USA

ABS malfunctions and the dealer cannot locate the problem.

- Weatherfor, TX, USA

ABS fails.

- Weatherfor, TX, USA

Anti lock brakes grabbing while stopping causing vehicle to extend its stopping distance.

- Boulder City, NV, USA

Brake failure.

- New Port Richey, FL, USA

ABS brakes failed.

- Sawyer, MI, USA

ABS brake system failed

- Sawyer, MI, USA

ABS brakes fail periodically. Read in consumer reports about ABS brake failures in GMC and Chevrolet trucks.

- Sawyer, MI, USA

When applying the brakes the vehicle would not stop. Dealer replaced master cylinder.

- East Brunswick, NJ, USA

Anti lock brakes failed, causing accident.

- Plano, TX, USA

ABS brake problems; while drivng on normal road conditions and applying the brakes, a howling noise came from the brakes. When taken to dealership, dealer stated that brakes were worn out, and needed a right rotor. Both rotors were damaged. The right rotor was replaced and the brake pads were replaced. The left rotor had to be grinded down. There has not been a problem with the brakes system in the last year.

- Granite Bay, CA, USA

The vehicle was placed in the park position, placed the vehicle from park into drive and the brake pedal traveled to the floorboard, resulting in an accident. Also there was brake fluid leaking from the master cylinder which caused the problem. GMC states that there is no defect, however dealer, who is now out of business, stated that brakes were cause of accident.

- Sea Bright, NJ, USA