The contact owns a 2020 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the vehicle jerked while accelerating and while coming to a stop. The check engine warning light was illuminated. The vehicle was taken to the dealer, but no cause of failure was found. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 65,000.

- Pasadena, CA, USA

Engine started rough idle, reduced power, poor acceleration, ticking and knocking noises, and a check engine light and a few other lights came on the dash. Safety was not a risk at time of incident. Problem has NOT been diagnosed yet BUT have done a ton of research and it-??s all leading towards lifter failure/misfire issues. No warning lights or symptoms prior to sudden problems.

- Winnsboro, LA, USA

The contact owns a 2020 GMC Sierra 1500. The contact stated that while attempting to start the vehicle, the vehicle vibrated abnormally. The engine warning light was illuminated. The contact stated that on another occasion, while driving at an undisclosed speed, there was an abnormal knocking sound coming from the engine. There was no warning light illuminated. The vehicle was towed to the dealer; however, a cause for the failure was not found. The vehicle was not repaired. The failure recurred and the contact stopped driving the vehicle. The manufacturer was not made aware of the failure. The failure mileage was approximately 110,000.

- Pearland, TX, USA

This car had lifter motor failure at 135K miles and Transmission failure at 145k miles, the torque converter of this truck is the culprit of many issues as the lifter issues.

- West Covina, CA, USA

The contact owns a 2020 GMC Sierra 1500. The contact stated while driving 5 MPH, the vehicle made an abnormal popping sound. The check engine and the ABS warning lights were illuminated. The messages "Parking Brake Service" and "ESC Service" were displayed. Additionally, the contact stated the vehicle experienced a reduced fuel range. The vehicle was taken to the dealer, where it was diagnosed that the lifters had fractured, causing damages to the engine. The dealer determined that the engine needed to be replaced, and the part was ordered. The vehicle was not repaired. The contact related the failure to NHTSA Action Number: PE25001 (Engine, Engine and Engine Cooling). The manufacturer was notified of the failure. The failure mileage was approximately 80,100.

- Hugo, OK, USA

Motor failed with no warning, motor was replaced at a GM dealer for $12,000. Mechanic stated he believed it was a main bearing failure. Not under warranty.

- Rhinelander, WI, USA

Our middle seat belt has stopped working in the back seat- we have not had it replaced yet. No damage was done on it by us, but will not click into the buckle. Driving on the hi-way engine started making awful noises. We pulled over and had the truck towed to Royal Moore GMC in Hillsboro Oregon as we didn't want to cause any more harm to the engine. Royal Moore GMC informed us the engine rod bearing failed on [XXX], leading to breaching of the engine block by the rod. This caused us to replace the entire engine at the cost of over 13,000$ and no vehicle for over 3 months. (Along with engine replaced they told us we had to replace the O2 sensor as the light came on after the engine was replaced). We had to take a hardship loan to get the engine replaced, and had the truck back for 1 day before we had a o2 error l light came back on. At this time (May 5th) we are still waiting for our truck back. Royal Moore doesn't know why the engine light is on- and contacted TAC for GMC. We also contacted GMC multiple times when we were waiting for the engine. They have offered no help to us besides empty promises to call us back later. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

- Forest Grove , OR, USA

On [XXX] at around noon I was driving my 2020 GMC Sierra northbound on [XXX] 26 miles north of Moab Utah. My truck died and I attempted to coast to the next passing lane but did not make it. The shoulder was about 3 feet wide and then had a steep drop off. I pulled over as far as I could but the majority of my truck and trailer was still in the only northbound lane. The northbound traffic was forced to cross over the double yellow into the oncoming southbound traffic. The concern was getting rear-ended by northbound traffic behind me or a head-on collision with the northbound traffic veering into southbound traffic. I made several attempts to restart the truck and the dash just goes blank with no attempt from the starter. We waited for a tow-truck and about an hour into this wait Utah Highway Patrol arrived and parked behind us with his lights on warning traffic from both directions. There were no precursors to this failure or notifications. I didn-??t even hear any noises. There was no physical damage or any leaking fluids. It just quietly stopped. John Elway Chevrolet informed me the bearings failed and the engine seized. I wanted to keep the core for evidence due to learning about the numerous catastrophic failures of the L87 engine I had. Keeping the seized core was going to cost me double the cost of a rebuilt one ($7000). When I asked the service Manager, Ben why its twice the cost? He said, -??GM doesn't want you keeping the core and they can set whatever price they want.-?? I have had this truck since it was new (6 miles) and noticed unusual oil consumption early on. I would never make it to the next oil change without having to add oil, even with the very first oil change. I inquired about this with the dealer and told this extreme oil consumption was normal and given Bulletin 01-06-01-011M. I did not involve my insurance because they do not cover engine failure. I paid $12,653.97 for a remanufactured long block. Of that was $2469.93 was for parts not need INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INF

- Highlands Ranch, CO, USA

I was driving on the frontage road that enters the freeway when then engine suddenly failed and stalled. It lost power and seemed like it was misfiring. All the warning lights on the dashboard came on as this happened but there were no warnings lights, messages, or symptoms before this happened. The sudden loss of power posed a risk to my safety because it could have caused a crash or left me stranded. I had my vehicle towed to the Freeway Chevrolet dealer in Chandler, AZ where they inspected the vehicle and confirmed the engine had a camshaft and lifter failure.

- Tucson, AZ, USA

Engine Lifters failure. Problems with Dynamic Fuel Management System

- Lilburn, GA, USA

1) Complete Engine Failure. Vehicle is no longer is in possession for inspection but pictures and video can be provided. 2) My Truck stalled at 70 MPH going down the interstate. I was lucky to be driving in the right lane to glide to a complete stop. This could have been way worse, not just for myself but for others. 3) Shortly after the loss of propulsion on the interstate. The engine started knocking very loud and I brought it into Boucher GMC of Brookfield. After about a week, the conclusion was I needed a new Engine. The Bearings, camshaft, rods and other components within the engine were damaged. The dealership said it was because of Bad Oil. 4) Parts were inspected and Dealership provided pictures. Not sure what they did with the junk parts. 5) I initially brought in the vehicle where it was purchased at Kunes of Stoughton WI for a Check engine light that read a P06DD error code at 56472 miles on the truck. They performed a software update and sent me on way. Since then, I was dealing with a on and off engine light which eventually brought me to a engine replacement at about 70,000 miles. None of this was covered under warranty and I had to pay for all of this out of pocket. In the events of all this. GMC had my truck for about 3 months. I had to purchase another vehicle because it was cheaper then renting one, GMC didn't have a loaner I could use. I could not perform my everyday work tasks besides getting to and from work, because I did not have a truck to carry my everyday work tools. Now understanding the full impact of this faulty engine and that I could have done harm to others or my self, has me worried about driving a GM vehicle. After I received the new engine, approximately 2000 miles later, The new engine, not rebuilt started making a knocking noise, only to find out, it was the same issue after bringing it to the dealership. No engine lights or nothing. People should be scared to drive a vehicle with the L87 engine from GM.

- Elm Grove, WI, USA

3.0 LM2 Duramax engine failed at 91,000 miles. It needs a new engine and they are available with a 2-3 week wait time. The engine failure has been inspected and confirmed by the dealer. No symptoms or check engine lights were on prior to the failure. Problem first appeared 03/2025.

- Wellsboro, PA, USA

I have had two engine failures within 2 years of buying a new GMC truck. The first occurred at 24,181 miles whereas i found engine failures is an all to common occurrence with these 5.3 liter engines, failures are wide spread, tons of complaints can be found with a simple internet or youtube search. The second engine failure occurred at 45,517 miles, again with lifer falling apart. Several service bulletins have been issues including reworking vehicles on dealers lots to replace faulty components but in my case i had over 16000 miles so they put the same parts in again and did not touch the other side which then failed two years later at in my case both were attributed collapsed lifter. This is a safety concern, there is no indication this is about to occur. The vehicle loses power, shakes, instrument panel lights up with various different warning lights. If you are passing another vehicle and this occurs it can be frightening as you have no idea what is happening and why you are no longer accelerating if you are passing some vehicles. The value of these vehicles is now also diminished, who wants a GM vehicle with two engine failures with 45k miles? No one, because it more than likely going to keep occurring until the engine is damaged beyond repair.

- Attica, NY, USA

Engine locked

- Shreveport, LA, USA

Shut off in traffic twice

- Denham Springs, LA, USA

The contact owns a 2020 GMC Sierra 1500. The contact stated that while attempting to start the vehicle, the vehicle failed to start. There was no warning light illuminated. The contact pushed the vehicle out of the garage. The vehicle was towed to a dealer where it was diagnosed that the spun bearing had failed. The contact was advised that the engine needed to be replaced. The engine was replaced. The contact stated that recently there was an abnormal sound coming from the engine. The vehicle was not diagnosed or repaired after the most recent failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 40,000.

- Framingham, MA, USA

Merging onto highway, lost engine power. Cylinder lifter failed, damaged cam shaft, caused damage to coolant system via metal debris, and engine needs to be replaced. 76,000 miles on vehicle, regularly serviced at dealership. I inspected the parts, and was shown the cylinder lifter that had failed and fragmented as well as the galled cam shaft. There were no prior indications of impending failure (no hard shifts, jumping, warning lights, etc). Warning lamps turned on after failure. I asked the mechanic at the GMC Dealership what caused the failure, and wasn't given a definitive answer.

- Hockessin , DE, USA

1. Vehicle automatic transmission failed during routine highway driving. Significant drivetrain vibration and limited gear availability. Warning lights included: ESC. - Electronic Stability Control TSC - Traction System Control Emergency Brake Fault light Power Steering assist reduced Flashing Yellow Engine Warning light. 2. White exhaust smoke upon arrival at GMC dealership. GMC technician advised full diagnostic would be required to assess extent of transmission failure and cause of white exhaust smoke. Service technician subsequently communicated that the engine was -??failed-?? and would have to be replaced. Vehicle could not be driven and so full extent of transmission failure could not be assessed UNTIL ENGINE IS REPLACED!?!

- Port St Joe, FL, USA

I was about 45 miles or so from home on [XXX]. As I left a business my truck went about 100 feet and the engine stopped working. No warning. Truck was towed to a GM dealer in Wilmington Il. It was determined the cause was due to the wiring from the engine ECM that was run over the top of a very sharp plastic mounting bracket for the ECM. The wire had been cut because of the way this was done at the factory. In addition the fuel pump also needed to be replaced. At the time of this, the truck had 39,140 miles on it. I had no warning this was about to happen. No check engine light went on, etc. Most of my route home is on the highway. Had this not happened on a side street, I would have been involved in an accident. I ended up paying $865.42 plus towing for this repair I should not be paying for. The people at the GM dealer told me this has been happening on numerous GM pick up trucks. This is NOT a maintenance issue or an isolated case. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

- Braidwood, IL, USA

2020 GMC Sierra "Denali" 6.2L engine with only 64,000 all original well maintained at miles -- NO prior issues no unusual sounds or indications of any issues. Vehicle has had timely maintenance regularly. engine lost power and began shuddering severely. Immediately taken to GM certified dealership upon which charged almost $1600 for engine analysis. Diagnosis is cylinder # 5 had lifter collapse which in turn ruined the camshaft. Will have to wait 4 weeks for parts and since GM power train warranty (conveniently) only covers first 60,000 miles the total engine rebuild is out of my pocket. Total price $9,741.11. THIS IS RIDICULOUS AND GM NEEDS TO REPAIR OR REIMBURSE EVERY SINGLE OWNER THAT EXPERIENCES THIS ISSUE IN FULL. I think GM knew about this issues and hopes it will go away but this really pisses me and SHOULD everyone else too.

- Honey Grove, TX, USA