2010 Hyundai Azera
TSBs (Technical Service Bulletins)
Technical Service Bulletins (TSBs) for the 2010 Azera are official communications between Hyundai & their dealerships that describe processes for troubleshooting or fixing certain common problems. All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
- 
		TSB #20-SS-001HThis bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when diagnosing and conducting alignment-related repairs for all models and model years. Read More » 
- 
		TSB #21-BR-002HThis bulletin provides best practice recommendations when performing brake service procedures. Read More » 
- 
		TSB #20-BR-002HThis bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area. Read More » 
- 
		TSB #23-EM-005HThis bulletin provides important checkpoint guidelines when performing engine oil and filter change services. Read More » 
- 
		TSB #22-EM-010HFollow the guidelines outlined in this bulletin to inspect and clean or replace certain components of the engine intake system accordingly during engine short block or sub-assembly replacement. Read More » 
- 
		TSB #21-EM-004HThis bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required ... Read More » 
- 
		TSB #21-EM-003HThis bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below. Read More » 
- 
		TSB #SB-10-EM-006HYUNDAI: A REVISED PROCEDURE FOR REPLACING THE TIMING CHAIN TENSIONERS. *RM Read More » 
- 
		TSB #24-AT-002HThis TSB provides a procedure to diagnose and replace, if necessary, an automatic transmission with Incorrect Ratio DTC (transmission clutch slip in gear above limit) listed on Page 2. Read More » 
- 
		TSB #21-AT-006HHyundai approves only the ATF, DCT gear oil and IVT gear oil specified in the vehicle??A?A?s owner??A?A?s manual. ??A?A? Use of other ATF may result in improper shift quality or other drivability conditions. Read More » 
- 
		TSB #20-AT-016HThe automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions: Read More » 
- 
		TSB #19-FL-003HThis bulletin provides the procedure to write the Vehicle Identification Number (VIN) during the replacement of the Engine Control Module (ECM) or Powertrain Control Module (PCM). Read More » 
- 
		TSB #5NP-E2D7G-09THE FOLLOWING VEHICLES ARE EQUIPPED WITH A 6-SPEED AUTOMATIC TRANSMISSION. THE ATF LEVEL MUST BE CHECKED BY THE FOLLOWING PROCEDURE. Read More » 
- 
		TSB #5NP-B6E2P-10"THE PCM OR TCM CONTAINS LOGIC TO ADJUST SOLENOID DUTY AND LINE PRESSURE AS NEEDED TO COMPENSATE FOR NORMAL CLUTCH WEAR OVER THE LIFE OF THE TRANSAXLE. Read More » 
- 
		TSB #5NP-B6E2P-10"THE PCM OR TCM CONTAINS LOGIC TO ADJUST SOLENOID DUTY AND LINE PRESSURE AS NEEDED TO COMPENSATE FOR NORMAL CLUTCH WEAR OVER THE LIFE OF THE TRANSAXLE. Read More » 
- 
		TSB #20-EE-003HThis bulletin provides information on identifying dealer stock vehicles with either: a?? A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. a?? A 30 Day alert - vehicle has not started and reported an SOC in 30 days. Read More » 
- 
		TSB #20-BE-001HThis bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. Read More » 
- 
		TSB #19-FL-003HThis bulletin provides the procedure to write the Vehicle Identification Number (VIN) during the replacement of the Engine Control Module (ECM) or Powertrain Control Module (PCM). Read More » 
- 
		TSB #20-BD-014HThis bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. Read More » 
- 
		TSB #24-BD-001HThis bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. Read More » 
- 
		TSB #23-BD-002HThis bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. Read More » 
- 
		TSB #24-BD-001HThis bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. Read More » 
- 
		TSB #23-BD-007HHyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. Read More » 
- 
		TSB #22-GI-006HEffective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) established a threshold for correcting load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail ... Read More » 
- 
		TSB #20-SS-004HThis bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. Read More » 
- 
		TSB #20-SS-002H(1)This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance. Read More » 
- 
		TSB #20-SS-004HThis bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. Read More » 
- 
		TSB #20-SS-002H(1)This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance. Read More » 
- 
		TSB #19-BE-011H-1The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. Read More » 
- 
		TSB #19-BE-011H-1The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. Read More » 
- 
		TSB #21-EM-004HThis bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required ... Read More » 
- 
		TSB #21-BR-002HThis bulletin provides best practice recommendations when performing brake service procedures. Read More » 
- 
		TSB #21-EM-003HThis bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below. Read More » 
- 
		TSB #20-BD-014HThis bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. Read More » 
- 
		TSB #20-BD-007H-1This bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using recommended safe chemical products. Read More » 
- 
		TSB #20-EE-003HThis bulletin provides information on identifying dealer stock vehicles with either: a?? A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. a?? A 30 Day alert - vehicle has not started and reported an SOC in 30 days. Read More » 
- 
		TSB #12-AT-023SUMMARY TO BE PROVIDED ON A FUTURE DATE. Read More » 
- 
		TSB #TSB-10-GI-001HYUNDAI: LABEL REQUIREMENTS FOR VEHICLE LOADING TO COMPLY WITH FMVSS 110. EFFECTIVE 6/2/08, FMVSS 110 (FMVSS 110) SETS A THRESHOLD FOR CORRECTING LOAD CAPACITY INFORMATION INDICATED ON TIRE PLACARDS WHEN VEHICLE WEIGHT HAS BEEN ... Read More » 
- 
		TSB #20-AT-016HThe automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions: Read More » 
- 
		TSB #21-BR-002HThis bulletin provides best practice recommendations when performing brake service procedures. Read More » 
- 
		TSB #20-BD-014HThis bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. Read More » 
- 
		TSB #20-AT-016HThe automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions: Read More » 
- 
		TSB #20-BD-007HThis bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe chemical products. Read More » 
- 
		TSB #19-GI-006HThis bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository. Read More » 
