10.0
really awful- Crashes / Fires:
- 5 / 2
- Injuries / Deaths:
- 4 / 0
- Average Mileage:
- 86,227 miles
About These NHTSA Complaints:
The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.
« Read the previous 20 complaints
Bought this Commander 08/02/14, about two weeks after driving it. It started dropping out of gear and getting stuck in 3rd gear. And when driving on the highway it would completely shut down, I sent it back to where I bought it. For them to fix the problem being I haven't even made my first car payment. And the gave me a run around for two weeks saying they was waiting on parts. Then said they had it and had my Jeep for almost 4 weeks. Before getting my Jeep. Now its 01/02/15 and its doing it again. I cant make it back and forth to work. Or get my kids. With my Jeep stuck in third gear and dieing for no reason.
- Hamilton, OH, USA
The contact owns a 2006 Jeep Commander. While driving 25-30 mph, the vehicle stalled and the instrument panel flickered. The vehicle was able to restart after numerous attempts. The vehicle was towed to an independent mechanic where the starter and battery were replaced, but the failure recurred. In addition, the horn activated independently. The vehicle was shut off and failed to restart. The vehicle was towed to the dealer where the spark plugs were replaced and a tune up was performed, but the failure recurred. While making a turn at 15 mph, the vehicle stalled and the instrument panel flickered. The vehicle was towed to a dealer where the solenoid starter was replaced, but the failure persisted. The vehicle was taken back to the dealer where it was diagnosed that the control module and tire harness needed to be replaced. The vehicle was not repaired. On another occasion, the contact stated that the transmission temperature warning light illuminated. The vehicle was taken to an independent mechanic where an unknown hose and the water pump were replaced. The manufacturer was notified of the failures and stated that the VIN was not included in NHTSA campaign number: 08V203000 (power train), but was included in NHTSA campaign number: 14V438000 (electrical system). The parts were not available to repair the vehicle. The failure mileage was unknown. The VIN was not available.
- Las Vegas, NV, USA
As I driving down the highway I can be going between 40-60 mph and if I let off the gas and just coast and then give it gas again its like it is in neutral and it continues to do this until the car is going 20 mph or under and it is very dangerous it has caused me to almost have several wrecks and I have 5 kids which were with me in the car each time this has happened to me something needs to be done!
- Cadet, MO, USA
Safety recall N23. I took this vehicle in for the recall in April 2014. I was told the recall had already been performed & no work was needed. They could not give me a date of the previous update for this recall. So the recall was performed on my vehicle at some time. Now I have a constant error flashing "service 4WD system." This vehicle also has no working 4WD low. I feel this is a direct result of the software update that was used for this recall. I do not feel that a software update will correct a cracked or damaged circuit board.
- Radford, VA, USA
While driving at 45 mph the vehicle just turned off. There is a faulty ignition switch recall but Chrysler will not do anything to help get this repaired. I received a recall notice and contacted them but they will not get back to me about repair. This 2006 vehicle is being driven by my daughter who is 19 years old and away at college. Unfortunately my vehicle is a 2007 Jeep Commander and has the same recall therefore I can't even give her my vehicle to drive since it is unsafe as well. At the very least Chrysler should repair these vehicle pronto! in the interim they should provide a safe vehicle for my daughter to drive.
- Winston Salem, NC, USA
The contact owns a 2006 Jeep Commander. The contact stated that the esp/ bas warning light illuminated intermittently. In addition, the four wheel drive option failed and the vehicle failed to shift gears. The contact stated that the failures occurred after the vehicle was serviced under NHTSA campaign number: 13V175000 (electrical system, power train). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 150,000. The VIN was not available.
- Boulder Junction, WI, USA
The contact owns a 2006 Jeep Commander. The contact stated while driving at various speeds, the gear shifted into four wheel drive independently and without warning. The failure occurred on numerous occasions. The vehicle was taken dealer. The technician diagnosed that the final drive controller module needed to be repaired. The failure was repaired but the problem persisted. The manufacturer was notified of the issue. The approximate failure mileage was unknown.
- Grand Rapids, MI, USA
While traveling on an expressway in central Michigan, I was using the cruise control to maintain a speed of 75 mph. With no warning at all, the mechanical components of the vehicle shut down, leaving my Jeep "dead in the highway". I was able to steer and brake, but the vehicle would not respond to acceleration by pressing the gas pedal. I pulled off to the shoulder, luckily without incident. Turned the key to the "off" position and waited about 10 seconds. I turned the key to the "on" position and it started back up. I cautiously drove at a considerably slower speed until I was able to get to a rest stop. When I got to my destination I found a local auto parts store and had them do a diagnostic check. It showed a maf sensor gone bad. Mass air flow sensor was replaced. Hoping that was the issue, after several days, my family and I headed back home on the other side of the state. While driving about 60 mph with cruise control, there were no issues. I figured the problem was fixed. Unfortunately, I was wrong. As I reached the highway where the speed limit is 70 mph, I accelerated to 70 mph with the cruise control. As soon as I broke the 70 mph point, the car mechanically stalled again as I was trying to merge onto the busy highway. Again, luckily, I made it safely to the shoulder and restarted. I was able to exceed 70 mph on the way home without using the cruise control. Concerned for my pregnant wife, toddler son, and my own safety, as this happened on a busy highway at a high rate of speed; with no warning lights or sounds.
- Saginaw, MI, USA
The contact owns a 2006 Jeep Commander. While driving various speeds, the vehicle decelerated independently. The dealer was unable to determine the cause of the failure. The vehicle was not repaired. The manufacturer stated that the vehicle was not included in NHTSA campaign number: 13V175000 (electrical system, power train). The failure mileage was 117,000.
- White Bear Lake, MN, USA
My vehicle is a 2006 Jeep Commander that I have had numerous issues with even though it only has about 78,000 miles. I was driving down a residential street when it stalled and after I cut off the engine to restart it the vehicle would not turn over. I had it towed to a repair shop and was told it was the control relay module that was not communicating effectively. I have had the transmission replaced, all the recalls done, and many other things. This is so unsafe and ridiculous. Its nearly $1,000 to have this part replaced, but because it is such a common issue it is on back order. Chrysler should take responsibility for the defective items they produce and sell to customers who bear the brunt of having a barely drivable, money pit.
- Twinsburg, OH, USA
Vehicle seem to loose power while cruising at or around 45 mph or when engages 4th gear. RPM's drop really quick from 3500 to almost 1500 RPM's in matters of second. Increasing the risk of a rear end collision if trying to overtake another vehicle or driving up hill, dealer can't find problem. Problems happens every time under any weather condition.
- Reading, PA, USA
The contact owns a 2006 Jeep Commander. The contact stated that while driving 65 mph, the transmission shifted from drive to third gear independently. The transmission became stuck in third causing the vehicle to become inoperable. The vehicle was taken to dealer. The technician diagnosed that the left solenoid needed to be replaced. The vehicle was repaired. The manufacturer was not made aware of the failure. The failure mileage was 96,590. Updated 11/14/14 updated 4/29/2015
- Moreno Valley, CA, USA
The contact owns a 2006 Jeep Commander. While driving approximately 30 mph, the vehicle stalled and all the instrument panel indicators illuminated. The vehicle was able to be restarted, but the failure recurred multiple times. The vehicle was taken to an independent mechanic. The mechanic stated that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 80,000.
- Tampa, FL, USA
After Jeep recall 4 wheel low fails to engage. It gives a maintenance error instead.. this is affecting a lot of the Jeep with the trac 2 system. Look at the Jeep forums. This was the final drive recall.
- Sanford, FL, USA
The contact owns a 2006 Jeep Commander. The vehicle rolled away while parked. In addition, the vehicle failed to start on multiple occasions. The vehicle was not diagnosed or repaired. The manufacturer stated that the VIN was not included in NHTSA campaign number: 13V175000 (electrical system, power train). The approximate failure mileage was 60,000.
- Detroit , MI, USA
At any speed, anytime, cold or hot, the vehicle will produce a message on the instrument cluster information center stating " transmission over temp ". the vehicle was brought to the mechanic two times already and can't find anything wrong. This message will display on a cool morning upon start up or after the vehicle has been running for some time. The message will not stay on longer than a few minutes, then will turn off. A ton of research has been done and no one has the answer yet. The only thing I came across was to replace the PCM/ECM, someone stated there was a glitch with the computer. Many people have this recurring problem and it can't be fixed yet.
- Farmingdale, NY, USA
Our Jeep doesn't stay in gear, to back up out of driveway must go from reverse to neutral several times to engage. Also will slip from drive to neutral while driving. There have been many, many, times that our Jeep doesn't know it is in park or neutral and will not start until you mess for along time with shifter. Contact was made with dealers in area and they state our VIN. Isn't part of recall. When driving our Jeep has put itself into neutral but shifter is in drive position... please help us..
- Des Moines, IA, USA
For no reason the Jeep would just die, on the intrastate, in town, anywhere, just shut off, then after a hour or so it would start again. After being in the shop many weeks for this, the two computers were found to be the problem. Changed the computers, at the fee of almost $ 2000 and no more problems, which the money is nothing knowing my teenage daughter wont stall on the intrastate and be killed. Chrylser Corp can care less !!!!
- Lake Charles , LA, USA
Hello, my 2006 Jeep Commander started stalling out over a year ago and has stalled on me on and off various times at different speeds but usually at a higher rate of speed, which has been very scary. I have chosen not to drive the vehicle anymore and now it is sitting in my driveway and I am driving a 1991 Honda because I cannot afford to buy a new car at this time. I just paid this Jeep off and now I cannot drive the vehicle. The dealer fixed the one recall on the vehicle called the front control module and it ran fine for a couple of weeks and now once again the car stalled out while I was headed to a camping trip with my kids a couple months ago going 50 mph and almost caused an accident. I was almost hit by a semi and several cars were honking and trying to avoid my Jeep. I lose all power steering and there are no notifications that the car will stall so it is very scary and dangerous for me and my children. I am so upset that I cannot drive the car and feel safe. I have contacted Jeep and they have a recall for 2006 Jeep Commanders that covers up to January 2006 and my vehicle was made in March so they told me there is nothing they can do. The recall was for the PCM which my car has the same code on the diagnosis but now they are telling me to take it to the dealer and I have to pay for this. I really hope that this situation can be resolved by Jeep stepping up and taking care of this issue for the safety of people.
- New Carlisle , OH, USA
- Culver City , CA, USA