2008 Mitsubishi Lancer
TSBs (Technical Service Bulletins)
Technical Service Bulletins (TSBs) for the 2008 Lancer are official communications between Mitsubishi & their dealerships that describe processes for troubleshooting or fixing certain common problems. All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
-
TSB #TSB-13-35-006
MITSUBISHI MOTORS: IMPROVEMENTS MADE TO THE SERVICE MANUAL IN REFERENCE TO FASTENER TIGHTENING TORQUE SPECIFICATIONS. Read More »
-
TSB #TT-C1219-C2205
MITSUBISHI: IF THE CLOCKSPRING HAS BEEN REPLACED FOR THE SUBJECT DTCS AND THE DTCS RESET, NOTE THAT THE STEERING ANGLE SENSOR (SAS) IS NOT PART OF THE CLOCKSPRING. *PE Read More »
-
TSB #TT-C1219-C2205
MITSUBISHI: IF THE CLOCKSPRING HAS BEEN REPLACED FOR THE SUBJECT DTCS AND THE DTCS RESET, NOTE THAT THE STEERING ANGLE SENSOR (SAS) IS NOT PART OF THE CLOCKSPRING. *PE Read More »
-
TSB #TSB-11-23-003
MITSUBISHI: CORRECTED CVT HYDRAULIC PRESSURE TABLES FOR THE OWNERS MANUAL. *RM Read More »
-
TSB #TT-C1219-C2205
MITSUBISHI: IF THE CLOCKSPRING HAS BEEN REPLACED FOR THE SUBJECT DTCS AND THE DTCS RESET, NOTE THAT THE STEERING ANGLE SENSOR (SAS) IS NOT PART OF THE CLOCKSPRING. *PE Read More »
-
TSB #TT-C1219-C2205
MITSUBISHI: IF THE CLOCKSPRING HAS BEEN REPLACED FOR THE SUBJECT DTCS AND THE DTCS RESET, NOTE THAT THE STEERING ANGLE SENSOR (SAS) IS NOT PART OF THE CLOCKSPRING. *PE Read More »
-
TSB #TSB-16-11-003
THIS IS A TECHNICAL SERVICE BULLETIN (TSB) THAT WAS SENT TO DEALERS. THIS TSB PROVIDES INSTRUCTIONS FOR INSPECTION OF OIL LEAKAGE FROM THE FRONT OIL SEAL ON THE CRANKSHAFT, AND IF CONFIRMED, TO REPLACE THE FRONT OIL SEAL. Read More »
-
TSB #TSB-13-13-008
MITSUBISHI: SOME VEHICLES MAY DISPLAY AN ILLUMINATED MIL STATING TO SERVICE THE ENGINE SOON WITH DTCS STORED IN THE ECM MEMORY AND/OR REDUCED ENGINE PERFORMANCE. WATER MAY ACCUMULATE AT THE BOTTOM OF THE AIR CLEANER FROM SNOW BUILD UP. Read More »
-
TSB #TSB-09-13-001
MITSUBISHI: ECM REPROGRAMMING FOR THROTTLE HESITATION AND ENGINE STALLS WHEN COLD. THIS SETTING COULD PRESENT ITSELF AS A THROTTLE HESITATION DUE TO A LACK OF FUEL INJECTION VOLUME WHEN FIRST ACCELERATING. Read More »
-
TSB #08-13-006
ECM REPROGRAMMING FOR DTC P1320. *NJ UPDATED 5/21/08. *NJ UPDATED 6/4/08. *NJ Read More »
-
TSB #TSB-17-14-001
THIS IS A TECHNICAL SERVICE BULLETIN, SENT TO DEALERS, PROVIDING INSTRUCTIONS FOR MODIFYING THE WIRING HARNESS AND REPLACING THE RADIATOR AND/OR CONDENSER FAN MOTOR AND CONNECTORS, IN CASES WHERE AN INOPERATIVE FAN MAY BE CAUSED BY A ... Read More »
-
TSB #TSB-17-14-001
THIS IS A TECHNICAL SERVICE BULLETIN, SENT TO DEALERS, PROVIDING INSTRUCTIONS FOR MODIFYING THE WIRING HARNESS AND REPLACING THE RADIATOR AND/OR CONDENSER FAN MOTOR AND CONNECTORS, IN CASES WHERE AN INOPERATIVE FAN MAY BE CAUSED BY A ... Read More »
-
TSB #TSB-14-15-001
MITSUBISHI: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. DUE TO PROLONGED EXPOSURE TO ANTI-FREEZING AGENTS, FRONT EXHAUST PIPE SEAL RING MAY CORRODE, IN COLD WEATHER STATES, TO CLEAR ICE AND SNOW FROM ROADWAYS. Read More »
-
TSB #TSB-11-23-003
MITSUBISHI: CORRECTED CVT HYDRAULIC PRESSURE TABLES FOR THE OWNERS MANUAL. *RM Read More »
-
TSB #TSB-11-23-003
MITSUBISHI: CORRECTED CVT HYDRAULIC PRESSURE TABLES FOR THE OWNERS MANUAL. *RM Read More »
-
TSB #TSB-15-23-003
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, PROVIDES INSTRUCTIONS TO REMOVE THE TRANSMISSION AND REPLACE TWO PRIMARY PULLEY SHAFT BEARINGS AND ONE SECONDARY PULLEY SHAFT BEARING, IF A CLICKING NOISE (ALONG WITH WHINING/HUMMING), ... Read More »
-
TSB #TSB-15-23-004
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, ADDS PROCEDURES FOR DISASSEMBLY, ASSEMBLY AND CLEANING TRANSMISSION COMPONENTS. Read More »
-
TSB #TSB-15-23A-002
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, CORRECTS THE HYDRAULIC PRESSURE SETTINGS AND UPDATES THE SPECIAL TOOLS USED IN THE CVT HYDRAULIC PRESSURE TEST IN THE INDICATED SERVICE MANUALS. Read More »
-
TSB #TSB-16-22-001
THIS IS A TECHNICAL SERVICE BULLETIN, SENT TO DEALERS, TO SUPERCEDE TSB−14−22−002, ISSUED JULY, 2014, TO REVISE SPECIFIC STEPS FOR SELECTING REPROGRAMMING DATA IN THE ?PROGRAM NEW TRANSMISSION CONTROL MODULE (TCM)? AND ... Read More »
-
TSB #TSB-11-11-004
MITSUBISHI: INFORMATION PERTAINING TO SOME VEHICLES WHERE THE IGNITION SWITCH IS IN AN ON POSITION AND BRAKE PEDAL IS DEPRESSED AND STOP LAMPS ARE ILLUMINATED AND THE SHIFT LEVER MAY GET STUCK IN P (PARK) POSITION. Read More »
-
TSB #TSB-17-14-001
THIS IS A TECHNICAL SERVICE BULLETIN, SENT TO DEALERS, PROVIDING INSTRUCTIONS FOR MODIFYING THE WIRING HARNESS AND REPLACING THE RADIATOR AND/OR CONDENSER FAN MOTOR AND CONNECTORS, IN CASES WHERE AN INOPERATIVE FAN MAY BE CAUSED BY A ... Read More »
-
TSB #TSB-16-22-001
THIS IS A TECHNICAL SERVICE BULLETIN, SENT TO DEALERS, TO SUPERCEDE TSB−14−22−002, ISSUED JULY, 2014, TO REVISE SPECIFIC STEPS FOR SELECTING REPROGRAMMING DATA IN THE ?PROGRAM NEW TRANSMISSION CONTROL MODULE (TCM)? AND ... Read More »
-
TSB #TSB-14-54-007
MITSUBISHI: THIS BULLETIN IS AN INTRODUCTION TO MAPCARE AND THE MAP UPDATE PURCHASE FOR MITSUBISHI MULTI COMMUNICATIONS SYSTEM. THIS DOES NOT APPLY TO MITSUBISHI MULTI ENTERTAINMENT SYSTEM FOR THE 2014 AND LATER MIRAGE. Read More »
-
TSB #08-13-005
ECM REPROGRAMMING FOR ENGINE SPEED RETURNS TO IDLE SLOWLY. *NJ Read More »
-
TSB #TSB-09-42A-004
MITSUBISHI: WOULD HEAR A RATTLE FROM ONE OF THE DOORS. THE RATTLE COULD BE CAUSED BY DOOR GLASS RETAINING BOLTS COMING LOOSE DUE TO LOW SOOR GLASS RETAINING BOLT TORQUE SPEC LIMITS. Read More »
-
TSB #07003
REAR DOOR WINDOW SASH REPLACEMENT AND REAR DOOR LATCH COVER REMOVAL. *KB Read More »
-
TSB #TSB-15-52A-001
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, PROVIDES THE CORRECT TORQUE SPECIFICATION FOR THE 2012 OUTLANDER SPORT SERVICE MANUAL. Read More »
-
TSB #TSB-09-42A-004
MITSUBISHI: WOULD HEAR A RATTLE FROM ONE OF THE DOORS. THE RATTLE COULD BE CAUSED BY DOOR GLASS RETAINING BOLTS COMING LOOSE DUE TO LOW SOOR GLASS RETAINING BOLT TORQUE SPEC LIMITS. Read More »
-
TSB #138
DOOR SASH SERVICE CAMPAIGN. *KB Read More »
-
TSB #TIN-14-22-001
MITSUBISHI: LANCER/LANCER SPORTSBACK, RALLIART, AND LANCER EVOLUTION: WARRANTY HAS BEEN EXTENDED FOR VEHICLES THAT HAS BEEN AFFECTED FOR THE AWC HYDRAULIC UNIT FROM FAILURE DUE TO CORROSION. Read More »
-
TSB #SRSINVNOV2016
THIS IS A COMMUNICATION SENT TO DEALERS REQUIRING THEIR ASSISTANCE WITH MMNA'S INVESTIGATION OF POTENTIALLY DEFECTIVE FRONT IMPACT SENSOR(S). Read More »
-
TSB # INVESTIGATIONRE
THIS IS A COMMUNICATION SENT TO DEALERS REQUESTING COOPERATION WITH MMNA'S INVESTIGATION OF POTENTIALLY DEFECTIVE FRONT IMPACT SENSOR(S). Read More »
-
TSB #TSB-15-23A-002
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, CORRECTS THE HYDRAULIC PRESSURE SETTINGS AND UPDATES THE SPECIAL TOOLS USED IN THE CVT HYDRAULIC PRESSURE TEST IN THE INDICATED SERVICE MANUALS. Read More »
-
TSB #TSB-15-15-001
THIS TECHNICAL SERVICE BULLETIN ADDS THE NON-REUSABLE PARTS INDICATION THAT WAS MISSING FROM THE SERVICE MANUAL FOR CERTAIN EXHAUST FASTENERS. Read More »
-
TSB #TSB1422005CUSTLE
THIS IS THE LETTER SENT TO OWNERS OF AFFECTED VEHICLES, INFORMING THEM THAT THE WARRANTY HAS BEEN EXTENDED FOR THE AWC HYDRAULIC UNIT ON THEIR VEHICLE. Read More »
-
TSB #TIN-14-22-001
MITSUBISHI: LANCER/LANCER SPORTSBACK, RALLIART, AND LANCER EVOLUTION: WARRANTY HAS BEEN EXTENDED FOR VEHICLES THAT HAS BEEN AFFECTED FOR THE AWC HYDRAULIC UNIT FROM FAILURE DUE TO CORROSION. Read More »
-
TSB #TSB1422005CUSTLE
THIS IS THE LETTER SENT TO OWNERS OF AFFECTED VEHICLES, INFORMING THEM THAT THE WARRANTY HAS BEEN EXTENDED FOR THE AWC HYDRAULIC UNIT ON THEIR VEHICLE. Read More »
-
TSB #TSB-15-52A-001
THIS TECHNICAL SERVICE BULLETIN, PROVIDED TO DEALERS, PROVIDES THE CORRECT TORQUE SPECIFICATION FOR THE 2012 OUTLANDER SPORT SERVICE MANUAL. Read More »
-
TSB #TSB-13-35-005
MITSUBISHI: INFORMATION CONCERNING AN UPDATE OF THE SERVICE MANUAL INVOLVING INSTRUCTIONS FOR THE REMOVAL AND INSTALLATION OF THE ABS AND ASC HYDRAULIC UNIT. Read More »
-
TSB #08-13-012
CHANGES TO FUEL PUMP CIRCUIT DIAGRAM - SERVICE MANUAL REVISION. *NJ Read More »
-
TSB #TSB-14-15-001
MITSUBISHI: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. DUE TO PROLONGED EXPOSURE TO ANTI-FREEZING AGENTS, FRONT EXHAUST PIPE SEAL RING MAY CORRODE, IN COLD WEATHER STATES, TO CLEAR ICE AND SNOW FROM ROADWAYS. Read More »