2016 TITAN XD; 6AT TRANSMISSION CALIBRATION
SERVICE INFORMATION
Anytime the 6AT (RE6R01A) transmission or its Transmission Control Module (TCM) is replaced an adjustment procedure must be performed using CONSULT-III plus.
IMPORTANT:
If the transmission adjustment is not performed, the transmission may have the following conditions:
Poor shift quality
Improper shift timing
Engine RPM flares between shifts
SERVICE PROCEDURE
1. Make sure the transmission is warm.
It may be helpful to take the vehicle for a drive (approximately 10 minutes) to warm the transmission.
2. Confirm the transmission fluid level is correct.
Follow the procedure for Checking the AT Fluid Level in the Electronic Service Manual (ESM), section TM-Transaxle & Transmission.
3. Set the parking brake.
4. Chock the wheels.
5.Connect the CONSULT PC to the vehicle with the plus VI.
6. Start the engine.
7. Turn the A/C system OFF.
8. Start CONSULT-III plus (C-III plus).
9. When the VI is recognized, select Diagnosis (One System).
