Affected Component: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT:SEAL

Date Published
JAN 22, 2024
NHTSA TSB #
10249928
TSB Document
Summary
DIAGNOSING REAR FINAL DRIVE ASSEMBLY LEAKS SERVICE INFORMATION If a Rear Final Drive Assembly (rear solid axle) is found to be leaking from one, or more, of the locations listed below, the source(s) of the leak should first be identified and, if possible repaired before the Rear Final Drive Assembly is considered for replacement. A Rear Final Drive Assembly should not be replaced unless bearing, gear, or other significant damage has occurred. Possible points of fluid leaks:  Front Oil Seal (Pinion Seal)  Axle Tube Seal  ABS Rear Wheel Sensor  Rear Axle Wheel Bearing Seal  Gear Carrier Cover Gasket  Drain Plug IMPORTANT: If a Rear Final Drive Assembly is found to have been replaced for a repairable leak and no internal damage is present, the claim will be charged back. Refer to pages 2-5 for additional information that illustrates and/or describes some, but not all, possible points where fluid leaks can occur, as well as helpful service HINTs.  This bulletin is only intended as a diagnostic reference and does not direct or imply repair.  Refer to the ESM for any applicable repair procedures, if needed.