ADDITIONAL SERVICE WHEN REPLACING CONTROL VALVE OR TRANSAXLE ASSEMBLY
After a CVT assembly or control valve replacement, additional service must be completed with CONSULT-III plus (C-III plus).
- The original calibration data must first be erased from the TCM and then newcalibration data written.
- If the calibration data is not erased, the vehicle can experience drivability concernswhich may result in a CVT issue.
Additional Service when Replacing Control Valve or Transaxle Assembly
- The following procedures, starting on the next page, must be performed in thisorder.
- Check off procedure as they are performed in the order listed below.