The contact owns a 2011 Chevrolet Cruze. When releasing the brake pedal, the vehicle abruptly jerked and shook. When the brake pedal was completely released, the vehicle jerked with force and shook. The contact had to wait a few seconds for the vehicle to stop jerking and shaking in order to engage the accelerator pedal. The failure was experienced everyday and the stability control, traction control, and check engine indicators illuminated during the failure. The failure normally occurred when the vehicle was driven 42 mph or less. However, when driving 55 mph or more, the failure was not experienced. After the jerking and shaking would end, the vehicle took a few minutes to reach 55 mph or more. The dealer was not contacted. The manufacturer was notified of the failure. The vehicle was not diagnosed or repaired. The approximate failure mileage was 93,000.

- Farrell, PA, USA

Ntsb: 2011 Chevrolet Cruze: Consumer stated the car goes from normal driving speed, and it will immediately drop to 2-5 mph with a message stating "low engine mode, serice stabilitrack" see 10839439

- Circleville, OH, USA

Upon starting my vehicle both the stabilitrak and traction lights were on, turned the vehicle off and then back on. Lights remained on, first repair place said stabilitrak sensor, second said it was the wheel bearing. Because of the differences in opinion I took it to a Chevy dealer who then told me the wires had gone bad and needed to be replaced at the cost of $300. I continue to have electronic issues with this vehicle after replacing the BCM twice. Something needs to be done.

- Westland, MI, USA

The contact owns a 2011 Chevrolet Cruze. While driving approximately 73 mph, the vehicle decelerated and the traction control, power steering, and transmission hot warning indicators illuminated. The vehicle was not diagnosed or repaired. The manufacturer was notified. The VIN was unavailable. The failure mileage was 1,000.

- Victorville, CA, USA