10.0

really awful
Crashes / Fires:
5 / 0
Injuries / Deaths:
2 / 0
Average Mileage:
102,116 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2006 Ford F-150:

Unsubscribe any time. We don't sell/share your email.

« Read the previous 20 complaints

problem #3

Sep 072012

F-150 6-cyl

  • 78,912 miles
The contact owns a 2006 Ford F150. The contact stated that while driving 30 mph during a rain storm and depressing the brakes, the vehicle exhibited and unusually lound double clunking noise as the vehicle skidded and flipped over. The vehicle did not crash into any other object. The police were notified however, a report was not filed. The contact sustained an amputated arm during the crash. The vehicle was towed by the police and was deemed as destroyed. The contact mentioned that just prior to the crash, the vehicle was taken to Firestone for maintenance and the replacement of the rotor and front brake pad. The manufacturer was not notified of the incident. The failure mileage was 78,912. Updated 2/4/13 updated 2/20/2013

- Ft. Pierce , FL, USA

problem #2

Jun 112009

F-150 8-cyl

  • 102,000 miles
The brakes started jumping when I started slowing down and so I replaced the brakes.. and now even with new brake pads they go down to the floor.

- Watts, OK, USA

problem #1

Nov 262012

F-150 6-cyl

  • 93,255 miles
I am 6'5" and wear size 16 shoes. With my size and the distance to the pedal my legs go a little to the side and my shoe is at an angle to the petals lets say 30 degrees. I wearing typical work boot (like in Ford commercials) which the laces have pegs the shoe laces go around. These pegs are the same as all work boots (red wings - $300 boot). What happened is because the brake pedal has a thick rubber pad that stretches around the metal brake pedal and leaves a ridge in the back of the pedal all the way around (so the rubber fitting goes over it like a shower cap). Also the truck is an automatic and the break pedal is very large. While backing up giving just a little gas my boot shoe lace peg got trapped behind the brake pedal and was holding my foot on the gas pedal depressing it down. Because the rubber ridge runs all the way around my pedal (as designed) I could not move my foot to the side of the brake pedal to release the gas. Because of the thickness of my foot when I pressed the break with my other foot, it moves the gas pedal down at the same rate as my foot is trapped, so the more you press the brake the more you give gas at a ratio that does not let me stop the vehicle. (note I use only one foot for the gas and brake normally but with my right foot trapped I had no other choice but to use my left foot to brake and try to get it the truck out of gear. I could not do anything in time and hit a stationary building. If someone was behind me, they would have been killed. The only other way I could have gotten my foot loose is to depress the gas pedal which is not an option in a lot of situations because it would make the speed of the impending impact faster and harder. This is a design flaw that traps work boots and at certain times and causes loose control.

- Redmond , WA, USA