7.5

pretty bad
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
6,500 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2002 Honda CR-V:

Unsubscribe any time. We don't sell/share your email.

problem #2

Jun 062006

CR-V 4-cyl

  • Automatic transmission
  • miles
I purchased a "certified Honda" vehicle, a 2002 Honda CRV in June 2005. I was told that the brakes, both front & rear passed Pennsylvania inspection but did not pass Honda's certified inspection so they were replaced to make the vehicle a "certified Honda". (they were replaced on 6/1/05) I have had the vehicle for 1 year, took it for inspection on 6/12/06 to find out that the rear brakes are down to a 1/B or far below passing - completely gone! I have driven the vehicle under 7000 in the year that I have owned it. I called the original (and only other owner) of the vehicle. He told me that he had the same problem when the vehicle was under 1 year old. He was told that Honda knew that there is some kind of defect in the design that causes the rear brakes to wear extremely fast in the 2002 & 2003 crvs, especially in the northern states because of our winters. He was told that the brakes need to be greased to help prevent this- something I was not told when I purchased the vehicle. When I asked the service mgr at the Honda dealer about this, he said they suggest it be done every 7500 miles. I have not even driven 7000 miles on the car. If Honda is aware of this problem with the rear brakes, why hasn't there been a recall"? are they waiting for the brakes to fail and kill someone before they do something?"

- Erie, PA, USA

problem #1

May 072004

CR-V 4-cyl

  • Automatic transmission
  • 13,000 miles
I own a 2002 Honda CR-V which has a disk brake defect. All 4 disk brake calipers are developing corrosion inside of the pistions. The dealer replaced the rear pads and rotors because they had worn and frozen to the wear indicators after 13,000 miles. They stated that they were "insufficiently lubricated" from the factory and added more grease to take care of the binding condition. The front ones are now showing the same signs of failure after 15,000 miles. Is there a way to persue that the dealer replace all 4 brake calipers due to the corrosion defect? my concern is that the pistons inside of the calipers are rusting through and may fail, causing accident/injury.

- Sagamore Hills, OH, USA