2018 Mazda CX-9
TSBs (Technical Service Bulletins)
Please note: The TSB information displayed below are summaries. We do not have access to the full versions. To get full information about a particular TSB, write down the TSB title & date, & either contact your local dealer or click on the links below.
The TSB numbers are the NHTSA numbers, which are different from the manufacturer-assigned TSB numbers — the NHTSA doesn't keep track of those. It's a very screwed up situation that's almost completely unhelpful to you as the consumer. Use the issue date or the title when asking your dealer for more information about a TSB.
-
TSB #MT-021-17
NHTSA ID #10129368
Summary: Some vehicles may experience the Check Engine Light ON with DTC P0171 (Fuel Trim too Lean) and possibly DTCs P030X (Misfire). Vehicles having this concern should use the following Inspection/Repair procedure.
-
TSB #01-001-18-3419
NHTSA ID #10129572
Summary: After parking the vehicle at temperatures below the freezing, some customers may experience a lack of power with the check engine light on and DTC P0638:00 and/or P2112:00 stored in memory. - P0638:00: Throttle valve actuator control range/
-
TSB #MT-001-18
NHTSA ID #10129354
Summary: When installing a navigation SD card, the center display may show error message "Invalid SD Card". This may be caused by: The navigation SD card lock tab is locked.The navigation SD card has a VIN mismatch due to SD card swapping.The naviga
-
TSB #SA-074-17
NHTSA ID #10129352
Summary: If the BSM control module is replaced, Auto Configuration and BSM Radar Test must be performed: 1. Auto Configuration -When the ignition is switched ON, the blind spot monitoring (BSM) reads the vehicle specification information sent via CA
-
TSB #SA-067-17
NHTSA ID #10118752
Summary: Due to a change in the 2017 Mazda3, Mazda6 and 2018 CX-9 A-pillar wiring harness, the EC Mirror w/compass / EC Mirror w/compass + Homelink installation instructions have been updated.
-
TSB #09-002-18-3410
NHTSA ID #10129566
Summary: After the installation of a new instrument cluster, the message "Fctry" or "Factory" is displayed instead ofthe odometer. This concern may also occur when a room fuse is installed in a new vehicle.Some new instrument clusters are in the fac
-
TSB #09-035-17-3080
NHTSA ID #10118467
Summary: In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to co
-
TSB #SA-061-17
NHTSA ID #10111036
Summary: In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is© 2017 Mazda North American Operations, U.S.A. allowing all Mazda dealers to utilize a third party, SPECMO En
-
TSB #09-003-18-3405a
NHTSA ID #10129569
Summary: Some customers may complain that the Voice Recognition system does not recognize "Address" or "New Destination" navigation voice commands. This may be caused by faulty navigation SD card software. The SD card has been updated to eliminate t
-
TSB #09-003-18-3405
NHTSA ID #10129567
Summary: Some customers may complain that the Voice Recognition system does not recognize "Address" or "NewDestination" navigation voice commands. This may be caused by faulty navigation SD card software. TheSD card has been updated to eliminate thi
-
TSB #SA-067-17
NHTSA ID #10118752
Summary: Due to a change in the 2017 Mazda3, Mazda6 and 2018 CX-9 A-pillar wiring harness, the EC Mirror w/compass / EC Mirror w/compass + Homelink installation instructions have been updated.
-
TSB #09-004-18-3402a
NHTSA ID #10129573
Summary: Some customers may complain that the door weatherstrip (1) comes off at the front / lower part of the reardoor(s). This concern is caused by insufficient weatherstrip gripping force.
-
TSB #09-004-18-3402
NHTSA ID #10129568
Summary: Some customers may complain that the door weatherstrip (1) comes off at the front / lower part of the reardoor(s). This concern is caused by insufficient weatherstrip gripping force.
-
TSB #MT-016-17
NHTSA ID #10125469
Summary: The Smart City Brake Support (SCBS) system alerts the driver of a possible collision using an indication in the display and a warning sound when the Forward Sensing Camera (FSC) detects a vehicle ahead and determines that a collision with a
-
TSB #SA-067-17
NHTSA ID #10118752
Summary: Due to a change in the 2017 Mazda3, Mazda6 and 2018 CX-9 A-pillar wiring harness, the EC Mirror w/compass / EC Mirror w/compass + Homelink installation instructions have been updated.
-
TSB #SA-065-17
NHTSA ID #10118479
Summary: Use the symptom troubleshooting tables below to diagnose MAZDA CONNECT concerns. MAZDA CONNECT Symptom Troubleshooting Table Sections: Audio System, Bluetooth®, Center Display, DTC, i-ACTIVESENSE, Maintenance Monitor, Navigation, Noise, Reb
-
TSB #MT-015-17
NHTSA ID #10111043
Summary: Some customers may complain about the following MAZDA CONNECT Temperature Warning message: Display is too Hot. Screen performance may be decreased until it cools. The warning message displays when the MAZDA CONNECT screen temperature is abo
-
TSB #SA-001-18
NHTSA ID #10129353
Summary: The MAZDA MOBILE START (MMS) is currently experiencing a system disruption. User web portal and Call center web portal functions are affected. Mazda is working on this issue and will notify dealers when MMS service has been fully restored.
-
TSB #MT-021-17
NHTSA ID #10129368
Summary: Some vehicles may experience the Check Engine Light ON with DTC P0171 (Fuel Trim too Lean) and possibly DTCs P030X (Misfire). Vehicles having this concern should use the following Inspection/Repair procedure.
-
TSB #09-035-17-3080
NHTSA ID #10118467
Summary: In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to co
-
TSB #MT-015-17
NHTSA ID #10111043
Summary: Some customers may complain about the following MAZDA CONNECT Temperature Warning message: Display is too Hot. Screen performance may be decreased until it cools. The warning message displays when the MAZDA CONNECT screen temperature is abo