I saw that my back bumper had come loose from the screws that hold it on....well, the problem is that the PLASTIC that the screws go in to are broken. I can pop it back into place but once I hit a bump, or even normal vibration will cause it to come loose...AGAIN!!! So how does one fix this problem? Should I attempt to ZIP TIE it back on....attempt to GORILLA GLUE it together......use duct(K) tape or go to Nissan dealer and get told "It's not under warranty." WTHell! Why even bother...can't afford their $60 or more labor fee, plus parts, etc., etc., etc. Cars are made so cheaply yet they charge an arm and a leg to purchase one. I purchased this car in 2009...since then I have had the driver's seat RELACED.......rust spots appeared...and the tire sensor has bit the dust(stays on), and the fire panel needed to be tightened. Geez...had I known all this was going to happen I would have rethought my purchase and gotten something else.
I saw that my back bumper had come loose from the screws that hold it on....well, the problem is that the PLASTIC that the screws go in to are broken. I can pop it back into place but once I hit a bump, or even normal vibration will cause it to come loose...AGAIN!!! So how does one fix this problem? Should I attempt to ZIP TIE it back on....attempt to GORILLA GLUE it together......use duct(K) tape or go to Nissan dealer and get told "It's not under warranty." WTHell! Why even bother...can't afford their $60 or more labor fee, plus parts, etc., etc., etc. Cars are made so cheaply yet they charge an arm and a leg to purchase one. I purchased this car in 2009...since then I have had the driver's seat RELACED.......rust spots appeared...and the tire sensor has bit the dust(stays on), and the fire panel needed to be tightened. Geez...had I known all this was going to happen I would have rethought my purchase and gotten something else.
- Linda H., The Villages, FL, US