4.1
definitely annoying- Crashes / Fires:
- 0 / 0
- Injuries / Deaths:
- 0 / 0
- Average Mileage:
- 28,550 miles
About These NHTSA Complaints:
The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.
2011 BMW dct M3 engine turns off by it self while driving through intersection. Transmission goes into neutral. "N" pops up on the center cockpit. Steering wheel lock. Brakes work. Had to maintain foot on brakes. Have to push "engine start" button. Car starts up again. Engine stalling and shutting off is a safety hazard, especially if the car is in motion. Could cause death to end users or other people. Can cause property damages as well. This has happen twice within a 8 week period. Most recently on Nov 26,2014 approximately 430pm BMW "auto start stop function" ruled out because the led light above the button is lit, function is disable.
- Las Vegas, NV, USA
The problem occurs when you slow down- like for a turn, but do not come to a complete stop. The dct transmission seems to have trouble figuring out what gear to select because when you step on the gas to accelerate, there is a very significant delay in the onset of power- up to 2-3 seconds. By this time, the driver is usually really digging into the throttle. The transmission finally picks a gear, which results in the car suddenly lurching forward, sometimes invoking the anti-skip control. The danger in this behavior occurs when making a turn into on-coming traffic after slowing down to around 10-15 mph. After the turn, the car is positioned in the traffic lane, but you have no power to accelerate into the flow of traffic. The oncoming cars are now closing in on your car at a fast rate, and you're basically stuck. This situation is most pronounced in the "auto" mode of the dct transmission, but also occurs to a lesser degree while in the manual mode when you select second gear in preparation for the turn. It is also very repeatable in both modes. These problems started occurring after a previous recall on this transmission where the engine would stall under hard braking or not shift under hard braking. The recall fixed that problem, but introduced this problem, which occurs almost every day whereas the previous problem only occurred during a specific situation.
- Hillsdale, NJ, USA
Clunking noise and vibration when turning right from a stop in cooler temperatures.
- Beaverton, OR, USA
- Glendale, CA, USA