I heard a creaking from the rear of my car, I put it on jacks to check it out. To my surprise I found extensive damage to the floor pan mainly around the differential mount. The car is claimed to be undrivable by BMW, but yet they will not take full responsibility for the matter. I see it as a safety issue as if I did not check it and continued to drive the cracks and tears in the body metal that exist could have continued even further and led to an accident or worse. I was estimated at a whopping 5200 dollars which BMW said they would only pay 3000 of. I believe it is a manufacturer defect, so it should be paid in fully by the company, but they will not stand up the their fault. I have at this time no choice but to drive the vehicle in its current state, I am a college student who doesnt have the largest income around so picking 2000 or more dollars out of nowhere is quite impossible. And I still have to go to work for the remainder of the time I am home, and so without a loaner from BMW or them taking full blame and paying in full I am forced to drive an unsafe car, for however long. I hope this situation can be taken care of as there are cases of similar subframe problems popping up all over forums online. Enthusiasts of the Z3 will recognize this issue if they tediously and carefully inspect their cars, however the average person who just buys their car and drives it around has absolutely no idea of the problem at hand and the possible safety issue that it may lead up to if not taken care of properly.

- Franklin, TN, USA

The subframe is tearing apart from the frame itself in the trunk. Spot welds have failed and separation is obvious. ## VIN passed ## BMW 2000#vpic# 4 - VIN corrected, error in one position only (indicated by ! in suggested VIN), multiple matches found; 14 - unable to provide information for all the characters in the VIN. #vpic# ##

- Franklin, TN, USA