Squeaking noise from engine accessory drive belts, clunking/ knocking noise at lower front of engine. The crank shift blancer split apart moving back to the engine. Damage to the timing chain cover and oil pan causing oil to leak.

- Milledgeville, GA, USA

While turning in a corner on the highway, I lost power steering and I had smoke and debris flying out of the back of the car. Luckily there was nobody near me, and I managed to steer off the road safely. Looked in the engine and the accessory belt was shredded, which also destroyed the heat shield material on the inside of the hood. Got a friend to pick me up and we installed a new belt. Drove 0.5 miles and the belt flew completely off this time. Power steering completely died, and I could barely turn the wheel while being tailgated by cars. Cooling system failed, coolant flying all over the engine bay, under the car, and on the highway. I'm glad I wasn't killed. Checked all the pulleys and found that the crankshaft pulley bolt had backed out, which I later found out caused wobble on the belt and led the engine/car to fail. Got a tow to the nearest GM dealer. There are many complaints about this on internet Corvette forums, and GM is aware of the issue (tsb #05-06-01-001A). It seems like crashing and causing accidents would warrant a recall.

- Raleigh, NC, USA

The contact owns a 2005 Chevrolet Corvette. The contact stated that while driving up a ramp at speeds of 45 mph, the left rear wheel locked causing the vehicle to spin and veer off of the road. There were no warning lights preceding the failure. The contact stated that he deactivated the manual active handling program and was able to drive the vehicle to the dealer for diagnostic testing. The vehicle was left in possession of the dealer and the contact was awaiting a diagnosis of the failure. The failure mileage was 32,000.

- Leeds, AL, USA

1 active handling system engaged without cause and redirected direction of vehicle engaged brakes to one side of car- 2.rear end blew out housing lost all oil and gears, prior repair under warranty- 3. transmission repaired by dealer2 times for shifting forks bent, warranty repair then had to replace transmission again after warranty expired at 5K! 4. driveline tunnel brace weld failed causing massive driveline damage to housing and driveshaft replacement.

- Ventura, CA, USA

Harmonic balancer.

- Milledgeville, GA, USA

Chevrolet 2005 Corvette. Aprox.40,000 miles driving under normal conditions. Dry/sunny. Driving slowly in morning rush hour traffic. Changing from first to second gear. Pedal lost pressure, sank to the floor. Slave cylinder, hydraulic clutch failure. Line ruptured, squirtig brake fluid all over hot exhaust manifold, block, heads, firewall. Fluid caught fire. Seen smoke within two seconds after pedal sank to the floor. Popped hood seen flames. Was able to put out. Seems to be very dangerous, generic design and parts quality. Car is at the shop as I write this. Mech removed slave master line assembly. It seemed to be inferior for heat and pressure. Most was plastic and held together with a plastic clip. If any of the plastic cracks or fails, break fluid could spray all over your hot exhaust manifold. Such as in my case.

- Grapevine, TX, USA