Happened twice within a day. The main electric fan on the radiator stopped working and the car overheated. Once at idle, was able to shut the car off safely. The second time, there was traffic on the highway, and the fan stopped working and the car started to overheat. Had to shut the car off and wait for it to cool down on the side of the road. When I got the car home, I found the electrical connector of the fan to be melted and fused together. There was no indicator that the fan would stop running prior to the engine overheating.

- Redford, MI, USA

When I start my Corvette and attempt to shift my automatic transmission from park to drive, the shifter will not move out of the park position.

- Salem, VA, USA

When driving the vehicle, I can hear, as it seems to me, excessive valve train noise.

- Rockville, MD, USA

I was driving in S 35 mph zone and it changed to 45 mph. I was in 2 or 3rd gear and has just started up a slight incline and I was increasing speed when the car made a sudden jerk and loud almost a bang. I depressed the clutch and it stayed on the floor. I though that the clutch had came apart and I pulled the pedal up to see what was going on. The engine at that point was running very rough and would not hold speed or accelerate. I pulled into a parking lot and got my wife to pick me up. I then got my pickup and trailer and took the car to classic Chevrolet. They found where the valve had dropped into the cylinder and caused damage to the piston and rod. I looked at the engine while tore down and noticed what appeared to me to be a crack in the cylinder wall and pointed it out, the forman said the had checked it and didn't feel that it was a crack. They advised me to get a new head and have the other head worked on as well as a piston, etc. I did that and had the car repaired. When the car jerked it also affected the pressure plate so I had that replaced. After I got the car back I noticed it was smoking white vapor whenever I started it. I took it back to the dealership and the tested it and sure enough it was a crack in the cylinder. I then had the motor replaced and the dealership was very fair and credited the earlier work against the motor. When the motor let loose, the car locked the back wheels and the car behind me had to make a rather quick stop and Dodge me so as not to have a wreck.

- Granbury, TX, USA

The shifter is connected to the transmission with a 4 foot cable, this cable is housed in the drive shaft tunnel, the cable has a plastic bushing on both ends, the heat in the tunnel bakes the plastic bushing that connects the shifter to the transmission cable, my bushing broke into pieces and the car could not shift into or out of gear. Many Corvettes in the C5, C6 & C7 modes have this same issue and are failing everyday. My car was in the garage in park, I had driven it earlier in the day, I stared the car and the shifter would move, but the plastic bushing had broken into pieces due to the heat failure. I know of the happening to 4 other Corvettes and the shop I took my car to was receiving other calls on the same issue.

- Richardson, TX, USA

Car will refuse to shift out of park during normal start. Car will refuse to shift out of park when in acc mode. Problem is non deterministic and may be related to voltages and/or resistances and/or faulty parts in system. Car is rendered non-operable and requires towing or repeated attempts to release gear train over a variable period of time. This seems to be a well known manufacturing defect not addressed by the manufacturer

- Scottsdale, AZ, USA

Automatic transmission shift lock solenoid fails, preventing trans. To lock into park and or can't place transmission in park. GM corrected this condition starting with VIN number 75405780, VIN numbers before that still continue to have this safety condition

- Childs, PA, USA

Shifter stiff and is very hard to shift into gear on automatic transmission

- Holbrook, NY, USA

My automatic shifter jammed in the D location and would only go to neutral and would not go into reverse or park, and the doors would not open with the button, this shifter has jammed in park in the past. This car only has 26K miles on it. And is not driven in bad weather. Not a good feeling to be traped in your car.

- Lockport, NY, USA

Vehicle would not shift in park or reverse and drive. Malfunction car was in traffic

- Little River, SC, USA

The shift level on my automatic transmission locks in nuetral. Been reading that this is a safety concern. It starts when the car is in park and then won't let the shifter move

- White Plains, NY, USA

The contact owns a 2006 Chevrolet Corvette. While attempting to drive out of the driveway, the clutch pedal traveled to the floorboard. The vehicle was taken to williams Chevrolet (2 automotive blvd, elkton, md 21921) where it was diagnosed that the clutch plate, pressure plate, and slave cylinder failed and needed to be replaced. The vehicle was repaired. The manufacturer was made aware of the failure and stated that they would not assist. The failure recurred while driving 55 mph. The vehicle was towed to a storage facility. The contact did not contact or take the vehicle to a dealer or mechanic. The manufacturer was made aware of the failure and stated that the contact should take the vehicle to a dealer and have it diagnosed. The vehicle was not repaired. The approximate failure mileage was 21,229 for the first failure and 24,000 for the second failure.

- Augusta, WV, USA

Waiting in traffic due to accident ahead. Shift auto trans. Into park. The trans. Would not shift out of park to resume normal operation. Problem described in owner operations manual. Finally able to shift to drive. Now will not shift out of drive creating potential for car to roll without break applied. Research shows this is happening in years 2005 to 2016.

- Jamestown, RI, USA

The contact owns a 2006 Chevrolet Corvette. The contact stated that the vehicle failed to shift into the park or reverse position without warning. The vehicle was not diagnosed or repaired. The contact had to disconnect the battery in order to shut off the vehicle. The manufacturer was not made aware of the failure. The failure mileage was approximately 51,000.

- Randolph, AL, USA

After initial start, and while holding brake pedal down, the automatic shift lever stays locked in "park, " and cannot be shifted to other gears. The solenoid seems not to be engaging. This is an annoying occurrence, which happens too often. I can see safety issues arising from this problem. Problem began @ 2,500 miles. Vehicle now has only 3,100 miles, and still occurring. Vehicle is always stationary, and mostly occurs during initial start, when operation of vehicle begins. Also occurs after a few hours of vehicle operation, when parked, ignition turned off, then restarted minutes or hours later. Vehicle is always garaged, and this problem is not weather related.

- Hernando Beach, FL, USA

1st the plastic bushing that holds the shift cable to the transmission shift linkage broke and left the car inoperable ( unable to shift ) parked in my carport about 4 moths ago, 2nd the plastic bushing that holds the shift cable to the center console shifter broke and left my car in reverse and took off and rolled back into carport with both doors open, needless to say what happened I've only seen in the movies until now, both doors are totaled, and Chevrolet knows this to be a problem but does not fix cheap plastic bushings, only offers whole cable with same cheap plastic bushings...

- New Iberia, LA, USA

The contact owns a 2006 Chevrolet Corvette. After the vehicle was started, it failed to shift from the park position without warning. The shifter cable was replaced, but the failure recurred. The manufacturer was made aware of the failure. The failure mileage was 74,000.

- Jasper, TN, USA

Automatic transmission shifter stuck in park. In the 2006 model both of these issues will eventually lead to being "stuck in park" and you cannot control when or where. It is a known issue with GM and they have failed to issue a recall because of the cars age. It is starting to effect newer models and likely the same or similar part. The safety locking solenoid goes bad, and the part is not replaceable on its own. You have to buy an entire shifter assembly. It will cost upwards of $700 or more. If you force it into gear you can also break the shifter cable at a higher cost.

- New Hope, AL, USA

Automatic shifter will not return to park or reverse position from neutral. Essentially vehicle is stuck in neutral. The failure is in the shifter mechanism and not the linkage or transmission. There is no way to safely park the vehicle in this condition or restart the car once it has been turned off. Once in this bad state, the vehicle remains in accessory mode therefore killing the battery.

- Viera, FL, USA

Has crack on top of fuel pump spraying gas, smells in cab

- Bella Vista, AR, USA