Dealership on 08/13/2001 replaced the cradle. Vehicle was under warranty in November 2001, and dealer replaced shaft. Cradle failed 2 years later, and needed to be replaced again, also, had a steering problem.

- Kettering, OH, USA

No summary listed for abov evehicle.

- Mountville, PA, USA

Vehicle would make a clicking noise whenever a turn was made. Vehicle was taken to dealer, and informed consumer that the subframe was broken. Repairs made by dealer. Feel free to provide any further details on this matter.

- Wheaton, IL, USA

The problem that happened after this subframe assembly was bent is the safety issue I am concerned with. When this assembly gets bent it smashes the power steering lines in the frame which in turn causes the power steering hoses to reach a high enough pressure to explode and you loose your power steering. What I am concerned with is someone traveling down a highway at say 70 mph and hitting a pot hole and this sub frame failing and at this time losing your power steering.

- Orion, IL, USA

The front end missed a weld on the frame which came from the factory that way.

- Middletown, NJ, USA

Clicking noise in front end at 3000 miles ended up replacing the frame on new car.

- Garden Grove, CA, USA

No summary listed for above vehicle.

- San Jose, CA, USA

The aluminum subframe has two brackets that need to be welded according to Chevrolet. The aluminum subframe "flexes" causing a clicking sound when the steering wheel is turned to the left and the right. Chevrolet advised the dealer to weld the two brackets and that should quiet the noise. Chevrolet said that there are no safety bulletins on this issue.

- Allison Park, PA, USA