Driver's seat is wobbling and feels like something is broken or detached beneath the right side of the seat. I've read many complaints about this in a Chevy Malibu/maxx. Should be a recall. Mechanics on the phone assume it's a welding issue. The wobbling occurred over time. Shouldn't have to pay for a manufacturing defect.

- Bloomington, IN, USA

The driver seat, rear right side is broken. Driver leans toward center console. Potential safety concern if there were to be an accident. Seems as if there was a structural failure in that location. Driver did not notice it break until sitting down one day to start daily commute.

- New Era, MI, USA

The weld on the front torsion tube of the driver seat adjuster is detached and the tube is disconnected, allowing more than 200mm of fore/aft movement of the upper seat back and headrest if seat is in full up position. This will clearly not pass FMVSS 207 or 210. There are already dozens of complaints nearly identical to this one on the NHTSA site. This should be a recall. I do not know when this initially occurred.

- Grand Haven, MI, USA

Issue one is the drivers seal welds brake on the rear and front from the floor mount base to the elevated control thus in the case of a crash the seat is compromised to separate completely from the floor mount due to these welds being broke. Second issue fuel pumps begin to leak at the seal of the pump at the fuel tank leaking heavy amounts of fuel from the tank and onto the exhaust. Third issue which I have seen multiple reports of recalls but the dealership denies there is an issue with the maxx that only the base model is effected but while driving the power steering will fail and the car has no control and will violently jerk in one direction throwing the vehicle in to oncoming lanes or even into the ditch. Happens periodically the power steering message appears on main control message screen and car will sound an alarm, other times the entire dash board warning lights from check engine, oil, air bag, seat belt, so on so all come on and the power steering goes out. I have found that this issue usually occurs while accelerating whether slowly or even while trying to speed up more aggressively to merge unto expressway traffic. I have nearly wrecked into numerous cars due to steering going out and wheel will violently jerk one direction or to the other. Not sure why this site shows a recall for power steering but dealership denies there is a active recall for the maxx but they have one for the 2005 base Malibu

- Wellington, KS, USA

Driver power seat/ broken weld on metal stabilizer bar across the lower front of the seat. Causes the seat to be unstable and shift when braking or accellerating.

- Fort Wayne, IN, USA

The driver seat welds have broken making the seat unsafe.

- Ballwin, MO, USA

Drivers seat welding has snapped underneath causing the seat to lean to the right and bounce up and down.

- Indianapolis, IN, USA

When entering my parked 2005 Malibu maxx, the cross bar under the front right side of the seat snapped at the corner weld. From reading these posts from other consumers, this has been happening since the car was manufactured. Not sure how many people can afford $1000 to buy another defective seat frame before they make a stronger one, but this seems like it should be added to the list of recalls I already have for this vehicle. ( which parts are not available as of yet ) this is definitely a safety concern.

- Kenmore, NY, USA

I was adjusting the driver side seat when I heard a metallic pop. Seat had a slight tilt to right that became worse when seat was raised up. Slight rocking motion was noticed when shifting body weight. Visual inspection found that right front weld had failed.

- Morgantown, WV, USA

Power driver's seat suddenly tilted back and right, and I heard a loud pop. Upon inspection a bar that runs under the seat broke at a weld. Seat now feels insecure and bouncy.

- Parkville, MD, USA

This 2005 Malibu maxx lt is equipped with a 6-way power driver's front seat. Something has broken that allows the seat to slide forward slightly during braking and slide back during acceleration. I have read the various owner's complaints regarding broken Malibu seat frames and I feel that this manufacturing defect should be repaired or replaced by Chevrolet. This vehicle has only 56,000 miles and is driven by my wife who weighs only 122 pounds. It has been a garage kept car all its life and is exceptionally clean. There is no reason for this seat to have failed other than poor construction. As with many complaints, this is a safety issue! this seat has not been fixed yet.

- Howell, NJ, USA

Drivers seat broke in three places and is a hazard to drive, because the seat moves left to right when you get in and out of the car. When the seat moves before driving, you sit tilted to the left and its uncomfortable to sit and drive good. It happened so sudden I was afraid to drive anywhere, if I did I only drove slow.

- Red Lake, MN, USA

Drivers seat weld broke right side. Now I have a very uncomfortable drive and don't trust the safety of my vehicle since my seat rocks back and forth at every turn and stop.

- Toronto, NY, USA

I noticed the drivers side seat "swayed" to the inside of the vehicle when sitting down in the vehicle. After removing the seat for inspection, the weld connecting the support tube inside the seat completely separated from its weld joint. No previous accidents occurred with this vehicle. Local service center stated this weld would be difficult to fix by rewelding and suggested finding a autosalvage seat to replace it.

- Powell, OH, USA

Two welds holding the console side of the driver's seat to the body of the car snapped, causing the seat to sit crooked (lower on the inside), pivot backward during acceleration, and forward when breaking. If it were ever in a collision, the additional stress placed on the door side welds will likely result in the entire seat coming free. (even in the absence of a collision, the seat may come free based on the stress of constant pivoting during normal use.) for the record, to my knowledge the car has never been involved in any collisions or other situation that might have placed abnormal stress on these welds.

- Lexington, SC, USA

While driving on the freeway, luckily on a curve. The driver seat began to wobble and lean to the right and back and I thought the motor came out of alignment. When I got home I began to search to locate the issue. After further investigation I noticed that the front bar of the seat had broken off. I have taken pictures of the defect. The issue and concern I have at this time is safety, how can a seatbelt secure me if the seat is not attached to the car during an accident. If I were in a stand still on a freeway and the car behind me did not stop in time and hit me at 45 mph, what would the result be? I picture my seat finally snapping off of its frame and me and the seat flying through the windshield.

- Fort Worth, TX, USA

Sat down in drivers seat and it popped and slumped to the right towards the center console. I looked under the seat and the metal tube frame had separated at the weld and looks like it just peeled back. The seat is now unstable and will wobble back and forth during driving. Researched this on the internet and it appears that there is an epidemic of driver seat frames breaking in the same manor on this year Malibu maxx. With so many vehicles experiencing the same malfunction in the frame it would appear that a manufacturing defect exists with this seat. The manufacture should be required to investigate and repair the defect as a safety issue.

- Mary Esther , FL, USA

The support bracket welded to the seat frame broke on the driver side seat, causing the seat to lean towards the passenger side. The seat can not raise up on the passenger side of the driver seat.

- Eldersburg, MD, USA

Sat down in drivers seat and it popped and slumped to the right towards the center console. I looked under the seat and the metal tube frame had separated at the weld and looks like it just peeled back. The seat is now unstable and will wobble back and forth during driving. Researched this on the internet and it appears that there is an epidemic of driver seat frames breaking in the same manor on this year Malibu maxx. With so many vehicles experiencing the same malfunction in the frame it would appear that a manufacturing defect exists with this seat. The manufacture should be required to investigate and repair the defect as a safety issue.

- Lusby, MD, USA

Driving away from work in a parking lot and the front right seat of the driver seat popped and sagged about 3 inches down, shoving the seat sideways. I pulled over to check it and found that a pipe running the front of the seat had sheered away on the right hand side. Driving it home, another pop in the back of the seat happened and now the seat is shoved into the center console.

- Saint Louis, MO, USA