The contact owns a 2002 Chevrolet Silverado. The contact stated that while the vehicle was being serviced, the mechanic discovered that there was a brake line fluid leak. The vehicle was repaired but the repair specifics were unknown and the failure recurred. The vehicle was taken to an independent mechanic where it was diagnosed that all of the brake lines needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 137,000.

- Lake City, MI, USA

The contact owns a 2002 Chevrolet Silverado. The contact stated that while driving 45 mph engaging the brakes, the brake pedal sank to the floor and the vehicle failed to stop. The vehicle was taken to an independent mechanic where the technician diagnosed that the brake line had rusted and needed to be replaced. The brake line was replaced. The manufacturer was not made aware of the failure. The failure mileage was 115,000. The VIN was unavailable.

- New Haven , IN, USA

The contact owns a 2002 Chevrolet Silverado. While attempting to stop the vehicle, the brake pedal traveled to the floorboard when it was depressed. As a result, the brakes hesitated to respond. The contact mentioned that the braking distance increased. The contact discovered that the brake lines were rusted and corroded, causing brake fluid to leak from the vehicle. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 96,800.

- Florissant, MO, USA

The contact owns a 2002 Chevrolet Silverado. The contact stated that while driving approximately 40 mph, the brake pedal was depressed with no immediate response. The contact shifted into a lower gear and applied the emergency brake in order to stop the vehicle. The contact inspected the vehicle and noticed brake fluid leaking. The vehicle was taken to an authorized dealer, who replaced the rusted brake lines and a brake hose. The failure recurred on two different occasions and the vehicle was repaired by an independent mechanic each time. The brake hose and brake lines were replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 95,000. Updated 07/13/12 updated 07/1912

- Slatington, PA, USA

The contact owns a 2002 Chevrolet Silverado. The contact stated the brakes failed when the brake pedal was applied and it extended to the floor. The vehicle was not taken to the dealer for diagnostic testing. The vehicle was not repaired. The failure and current mileage was 242,020. Updated 02/0812 the consumer stated when he applied the brake pedal, it went all the way to the floor. There were no warning lights. The next day, he was able to determine the failure was due to a brake line failure, between the master cylinder and the ABS unit, there was rusting and brake fluid was leaking. The consumer replaced the brake lines with stainless steel lines. Updated 03/08/12

- Minneola, FL, USA

The contact owns a 2002 Chevrolet Silverado. The contact was traveling 50 mph when he applied the brakes and the brake pedal went into the floorboard. The brakes did not respond. The contact applied the emergency brake in order to stop the vehicle. The vehicle was not diagnosed for the failure. The contact stated that the rear rotors were entirely rusted three years prior to the failure. The current and failure mileage was 49,000. Updated 3/8/11 the consumer stated he noticed brake fluid was leaking from two of the steel brake lines and they were completely corroded. The front brake line ruptured which was located below the drivers seat on the outside of the frame rail and the rear brake line had ruptured as well, which was located on the drivers side wheel well. All seven brake lines along the fuel lines showed some degree of corrosion and needed to be replaced.

- Mount Holly, NJ, USA

The contact owns a 2002 Chevrolet Silverado. While driving 45 mph, the contact placed his foot on the brake pedal and the speed failed to decrease. The vehicle was driven onto the emergency lane. The contact inspected the vehicle and noticed that the brake line was leaking fluid. The contacted found two related NHTSA recalls, 05V379000 (service brakes, hydraulic, antilock) and NHTSA campaign id number 05V161000 (parking brake). The vehicle was taken to an independent mechanic for diagnostic testing. The mechanic stated that the brake lines were rotten and that the brake sensor was corroded. The dealer would not offer any assistance. The road conditions may have been a factor due to salt on the roads. The failure mileage was 140,000. The current mileage was 142,000.

- Pavilion, NY, USA

The contact owns a 2002 Chevrolet Silverado. The contact stated while braking from speeds of 5 mph, the brake pedal fell to the floorboard. The contact was able to stop the vehicle and upon further inspection, found brake fluid leaking from the drivers side. The dealer advised the brake line had corroded causing the leakage. The dealer replaced the rotors, brakes, and the caliber at the owners expense. The manufacturer was not informed of the failure. The VIN was not available. The approximate failure mileage was 83,980 and the current mileage was 84,000. Updated 05/18/10.

- Chester, NY, USA

2002 Chevy Silverado was being driven and a steel brake line popped while braking for a downhill grade, causing loss of braking. If we had been towing our horse trailer an accident would certainly have occurred. The brake line is severely rotted and rust flakes off easily. The line is held to the frame, under the cab and not in a location where damage or wear should occur. The vehicle is too new and has low miles (55K) and this failure should not have happened.

- Chester, NH, USA

2002 Silverado K1500 brake pedal failed to stop the vehicle. ***** the consumer was told all of the brake lines between the master cylinder and electro hydraulic control unit were rusted and some were leaking fluid.

- Traverse City, MI, USA