While driving on 30-40mph and hit the brakes slowly, it feels as if the pedal is gonna fall off and can also feel a vibrate on it. It also stalls as if the brakes are being pressed but I'm not, this happens usually in the beginning after being turned on and then stops doing it after reaching the middle of the temperature.

- Coachella, CA, USA

Been having voltage issues for a couple of days where my lights dim and volt gauge drops and raises while driving or stationary dealer said it's normal also hard down shifting while driving not letting off the gas assistant brakes have failed and clunk hard sometimes when stopping or press hard back at me through the pedal again dealer said it's normal I pulled my truck out from the back of the house to the front shut it off to go get ready for work a couple minutes later my daughter informed me my truck was over heating I went to door to find smoke pouring out of my truck from under the hood grab a fire extinguisher run out pop the hood and the whole passenger side of compartment is in flames how does a vehicle that's not running start on fire? awaiting my insurance company to get it out of here I imagine will be a total loss there isn't much left of the engine bay so not sure what started the fire

- Davenport, IA, USA

I started my vehicle and put the truck in reverse to back out of a parking spot. Gave the truck gas and it wouldn't accelerate. Put the truck back in park and looked at the guages and there were no RPM's showing on the cluster and the oil pressure was at zero. There was a message that said trailer brake system on the screen. I turned the truck off and on again and the same thing happened. I put the truck in drive and it would move forward but the motor ran very rough and there was no power steering. I dismissed the first message and another message popped up that said "steering assist is reduced, drive with care." I pulled into another parking spot, turned the truck off, and waited for a ride. I started the truck when my ride showed up to make sure it was still not working and it was as if nothing happened before. The truck had no issues on the 16 mile drive home. Got home and turned the truck off and started it again and the message came back up and the issues came back. I have a video of the trailer brake system and me shifting the truck and the guage cluster. I have a picture of the steering assist message.

- Mackinaw, IL, USA

While driving 41-60mph, the truck starts to idle as if the brakes are being pushed on one tire and the brake pedals and gas pedal tend to vibrate as if it were to fall off. After awhile doing that, the stability control light message comes on after reaching the middle of the coolant temperature and the problem goes away. Seems like it does it when it's on low temperature.

- Coachella, CA, USA

Air conditioning went out twice, brake pedal hard and wheel bearing noise from rear becoming louder after dealer said it was okay

- Cathedral City, CA, USA

Started having soft/hard braking issues when going at low speeds. Pump the brake petal a few times to try and apply more pressure but does not do the trick. Do not see any issue's with leaks or damage. Seen recalls for vacuum pumps with the year and model the same.

- Diamond, WV, USA

Loss of power due to vacuum pump. Message pops up on speedo saying service brake assist as the brakes stop working. Happens at slower speeds while moving (city driving)

- Trevose, PA, USA

I have filed a complaint already about my 2018 silverado1500 L, never received a response about the complaint filed. My truck road very rough, it had a bad vibration and shimmy in the front end. The front end would nose dive when braking. The truck would pull to the right when going around a right curve. The left front tire was riding on the outside edge. Taking to long to get the truck to stop when braking. These complaints were ignored by the GM service centers, I was pretty much called a liar. The left side front tire edge was very visible to the eye on the tire riding on the edge. Called a liar again. At 16000 miles I took matters into my own hands. I bought new shocks and struts and had a certified service center put them on. The truck rides well, no more shimmy in the front end, the steering is fine going around a right-hand curve does not pull to the right anymore. The truck is now braking like it is supposed to. I have a warranty on this truck the dealerships denied that anything was wrong with the truck. Why when I had the shocks and struts changed the problems went away. I keep the GM shocks and struts. I took a strut and placed the rod end on a board and pushed down on the tube the rod went into the tube with hardly any resistance they were junk. I am going to make a video demonstrating the GM strut and send it to the news media along with the paperwork showing where I had taken my truck to the dealership service centers. If GM is not going to honor their warranty and tell their service center techs to lie about the problem the public has the right to know. I am going to put the date that I had the shocks and struts changed on the next step.

- Rocky Gap, VA, USA

While towing a boat on the highway, a series of warning icons appeared that indicated there was something wrong with the ABS, trailer tow, tracking.

- Broken Arrow, OK, USA

My truck has a known recall with the brakes failing due to a mechanical issue with the vaccum. I contacted holly Chevy in marion Arkansas and it has been now over a month awaiting parts. I have to continue to drive this vehicle due to it being my only vehicle to travel to work. I have expressed this safety issue to them and having to press the brake pedal with force to stop the truck.

- Lepanto, AR, USA

Currently there is a recall for same make of my vechile but not this VIN, and issue is the same with my vechile. Breaks when pressed kicks back at me. And will hear a back kick. And electrical will make noise in the vechilce when stopped.

- Winston Salem, NC, USA

The contact owns a 2018 Chevrolet Silverado 1500. While driving low speeds, the brake pedal traveled to the floorboard and failed to bring the vehicle to a stop. The failure occurred multiple times. The vehicle finally stopped and was towed to wiesner of huntsville (230 I-45, huntsville, tx 77320, (936) 291-7500). The dealer was currently repairing the vacuum brakes. The manufacturer was made aware of the failure. The failure mileage was 24,325. The VIN was unknown.

- Huntsville, TX, USA

The truck has less than 100 miles on it. I had been driving at 55 and entering town. Slowed to 45, then 35, then 25 mph. Had a slow coast down hill approx 200 yds at 25mph while lightly on the brakes. I attempted to stop as I was approaching a stopsign. The brake pedal pushed deeper than usual, was very hard, and I did not have much stopping force. I had to stand very hard on the pedal to get it stopped and my stopping distance was greater than usual. Had there been a pedestrian crossing the street there would have been a big problem. As a let off the pedal to cross the intersection, there was a surge like the engine was stuck on fast idle or like when accelerating from a low RPM brake stand. After that short incident, brake function was back to normal and I drove the vehicle home without another issue.

- Polk City, IA, USA

Driving in straight line at 5mph with hill decent activated. Brake pedal began to pulsate, which was felt in the pedal and it was making an odd audible pulsating noise from the brake pedal non-stop as if ABS was constantly engaging. Brakes suddenly disengaged and truck started picking up speed. Error displayed on dash which said service stabilitrak system. I believe another error was displayed but I didn't see it. I attempted to manually apply brakes, however pedal was extremely stiff/hard and I was unable to press brake pedal down, and the truck did not slow. The pedal was hard for 1 second then the power brakes returned, and I was able to slow the vehicle. All error symbols disappeared from the display. A new ticking type noise just started from the driver side lower engine area. I later received two onstar emails which stated; -'an issue with the antilock braking system in your 2018 Chevrolet Silverado has been detected. Please service your vehicle within 7 days.' -'an issue with the stabilitrak stability control system in your 2018 Chevrolet Silverado has been detected. Please service your vehicle within 7 days.' Vehicle was brought to a Chevrolet dealer who said the vacuum pump had failed. Per my online search the problem is described in GM bulletin #pit5361B. Vacuum pump was replaced by dealer under warranty.

- Fairfield, CA, USA

In an accident where I was the at fault driver, I was approaching a stop light and did not notice the red light nor the car stopped until approximately three seconds before impact. Once I recognized what was happening, I immediately slammed on the breaks. I hit the other driver in the rear of his vehicle. As stated above, I hit my breaks about 3 seconds before impact, but my ABS did not activate; instead my breaks locked and I slid 15-30 feet into the other vehicle. Additionally, since my airbags deployed, a tow truck was required to tow my truck. Upon arrival of the tow, my truck would not start, so he needed to pull it up onto the bed of his tow truck with chains. Once hooked up, he began to drag the truck up. The tow driver asked me if the truck was 4 wheel drive and whether I had been driving in 4 wheel. I indicated it did, but I was not driving in 4 wheel mode. I asked why he had asked, and he said that it while pulling the truck up, all four wheels were locked. He said that should not happen normally. I'm not sure exactly how the mechanics of ABS work, but I have felt ABS engage multiple times and have attending drivers training for winter weather conditions. My ABS did not activate; there was no stutter of the breaks, only a stable press with no active response other than locked breaks and a long skid.

- Pasadena, MD, USA

The brake peddle went solid hard and loss of braking happened while backing a boat trailer down a boat launch ramp. When the brakes failed the dash flashed service brake assist. Loss of power brakes caused the truck to not stop even with pushing down on the peddle as hard as possible. This occurred while coasting in reverse off of the throttle using the brake to slow the vehicle and boat down while going down the launch ramp in reverse. Speed was approximately 5 mph. I managed to stop the vehicle at the water line by applying the emergency brake. The local Chevrolet dealership where the vehicle was purchased replaced the vacuum pump under warranty due to weak vacuum. I lost power brakes again on the way home from the dealership when backing down an incline on my driveway at low speed. The dash flashed service brake assist again. Returned truck to dealership the next morning and took a technician on a test drive with me. Showed technician loss of power brakes and service brake assist message on dash when braking in reverse on an incline. Chevrolet dealership says they contacted Chevrolet technical support and replaced brake booster and replaced vacuum pump for the second time. This is on a 2018 Chevrolet Silverado 1500 LT1 with the 6.2L engine and 42,155 miles.

- Holiday Island, AR, USA