10.0

really awful
Crashes / Fires:
4 / 1
Injuries / Deaths:
0 / 0
Average Mileage:
123,862 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 1999 Chevrolet Silverado 2500:

Unsubscribe any time. We don't sell/share your email.

problem #60

May 012000

Silverado 2500

  • 0 miles
The parking brake has never worked properly since new. Your partial recall fix for standard transmissions only is inadequate. Make me wonder about undue GM influence. Just because the automatic transmission trucks have park. That is not an excuse for GM not to fix the parking brake.

- Littleton, CO, USA

problem #59

Mar 292018

Silverado 2500

  • miles
ABS engaging less than 10 miles per hour. Not covered by the recall of 805,000, as not in a rust belt state.

- Cortez, FL, USA

problem #58

Jul 152014

Silverado 2500

  • 230,000 miles
Driving along road, brake pedal went to the floor when I attempted to stop. Upon inspection, discovered that the hydraulic line going from the ABS module to the rear brakes had ruptured due to corrosion. Upon further inspection it has been determined that all of the hydraulic brake lines are swollen and corroded to the point of failure and must be replaced at a cost of over $1200. My truck has not moved since, as I cannot afford to repair this issue.

- Canton, MI, USA

problem #57

Dec 132015

Silverado 2500

  • 90,000 miles
Rusted brake lines ! driving down the street, hit brakes to slow down to turn into a drive, brake peddle went to the floor, no brakes at all, I found the brake line going to the rear had broken by the gas tank, brake lines are very corroded and rusty, truck is keep indoors, and came from New Mexico, no rust on the body at all, tow bill was 200 bucks, around 50 miles from home. Stainless steel break lines are around 200 to 300 bucks, around 200 to 300 for labor, very expensive so far, and the truck is not fixed yet. The truck only has 90,000 miles on it. When the rear line broke, I should have, still had front breaks, in a two part brake system, but I had no brakes at all. I'm lucky, it caused, no accidents, or injuries, or any other damage. It could have been very worse, even deadly under different circumstances. You think they would have put stainless steel on the brake lines like they did on the exhaust. I mean, a rusty exhaust, probably wont kill anybody, but rusty brake lines have killed a lot of people, I'm sure.

- Sidney, OH, USA

problem #56

Nov 032014

Silverado 2500

  • 123,500 miles
I started to backup out of my driveway, when I pressed on the brake pedal they went all the way to the floor. Pulled back into driveway and saw where brake fluid would shoot out when the brake pedal was pushed under the driver's side door. Further investigation showed the brake line had corrosion in for about 4 inches. Replaced the brake line. Yesterday, September 13, 2015 again went to back up and pedal to floor. Upon examination the brake fluid shoots out in a steady stream when pedal is depressed.

- Austin, TX, USA

problem #55

Sep 032015

Silverado 2500

  • 170,000 miles
While approaching intersection put on brakes and they failed, pedal went to the floor. If I had not been a test driver for Chrysler Corp. And doing lots of brake and suspension work I could have easily been seriously hurt. The brake lines were shot, rusted through. This vehicle has spent it's life in fl. No salt on the road. I know you have ruled on this being a recall, but I think you made a huge mistake, someone will be killed by this. Thanks

- Spring Hill, FL, USA

problem #54

Aug 142014

Silverado 2500

  • 193,348 miles
The contact owns a 1999 Chevrolet Silverado 2500. The contact stated that while driving at an unknown speed, the power steering and brakes malfunctioned. The vehicle was inspected by an independent mechanic. The technician diagnosed that the hydroboost malfunctioned and needed to be replaced. The manufacturer was not made aware of the failure. The failure mileage was 193,348.

- Owenton, KY, USA

problem #53

Jul 192015

Silverado 2500

  • 138,000 miles
The contact owns a 1999 Chevrolet Silverado. While driving 20 mph and attempting to engage the brakes, the accelerator pedal went to the floor and the brakes failed without warning. After inspecting the vehicle, the contact discovered that the brake line was corroded. The vehicle was driven to the contact's residence where he discovered large amounts of brake fluid leaking from various spots on the brake line. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 138,000.

- Georgetown, KY, USA

problem #52

Jan 012015

Silverado 2500

  • 58,000 miles
The contact owns a 1999 Chevrolet Silverado. While driving approximately 35 mph hauling a trailer, the front and rear brake hydraulic lines failed. The contact was able to stop the vehicle by using the brakes on the trailer. The vehicle was taken to the dealer; however, the vehicle was not diagnosed or repaired. The contact, an experienced mechanic, diagnosed and replaced the brake lines. On a separate occasion while driving 50 mph, a plastic component of the driver's seat fractured and caused the seat to slide back and forth into the steering wheel. The failure was not repaired and the manufacturer was not notified. The failure mileage was 58,000. The VIN was not available.

- Chillicothe, OH, USA

problem #51

Apr 052015

Silverado 2500

  • 164,000 miles
Brakes: Since approximately 136,000 miles to present miles, the vehicle has exhibited an ABS and brake warning light intermittently on the dash. This is a known GM issue that was recalled in certain states, but not all. It stems from faulty soldering points in the ABS control module and can affect the vehicles ability to stop correctly which could result in an accident. Engine/ emissions: The passenger side exhaust manifold bolt has broken off. This is a known issue with this 5.3L engine as well as the 4.8L and 6.0L engines. GM has failed to recall in spite of having thousands of complaints. The issue can cause failed emissions and potentially engine fires. Engine: As of 164,000 miles, the engine is experiencing loud "piston slap". this is a known issue which GM addressed through redesign in later models. It leads to excessive engine wear and potential engine failure. It appears to be a factory defect, yet GM has claimed it is not important despite numerous complaints from customers that the engines have required replacement as a result.

- Vancouver, WA, USA

problem #50

Jan 152015

Silverado 2500 4WD 8-cyl

  • 147,248 miles
One morning out of the blue when I went to drive my truck, pressed the brake pedal to put it in gear my pedal went to the floor with very little give. Looking under the truck I notice a metal brake line has a hole. The worst part, all the medal brake lines are so rusted it looks as if they could all fail at any time.

- Milton, PA, USA

problem #49

Nov 122014

Silverado 2500 4WD 8-cyl

  • 213,000 miles
Pushed the brake pedal and was not able to stop due to a blown brake line. This was my first incident, but the second for the truck. This issue occurred when my father owned the truck and he had GM replace the brake lines. I had GM replace the brake lines for a second time. It's very scary not being able to stop a vehicle, but luckily I was on a highway and was able to drift over to the shoulder.

- Edgewood, MD, USA

problem #48

Nov 252014

Silverado 2500

  • 10,045 miles
Driving on two way street attempted a right hand turn applied brakes, peddle went to floor, attempted to pump, truck slowed to stop. Noted large amount of fluids on road. Truck was taken to mechanic, found brake-line had burst on left front wheel. After inspection noted that all brake-lines looked like kfc chicken were all corroded and brittle. Mechanic indicated that this was a extreme safety hazard. Recommended that I contact dealership and report incident. Also, fill our and file a vehicle safety complaint. I was not informed by GM that there maybe a problem that has been on going and after looking into it have found both GM's cavalier attitude, and the governments not requiring at the very least a notification never mind a total fix to be required of GM a serious breach of confidence in my government to provide for the safety of its citizens.

- Florence, MA, USA

problem #47

Oct 112011

Silverado 2500 4WD 8-cyl

  • 115,000 miles
I own a 1999 Silverado ext cab 4X4 and the frame is rot in many different places the driver and passenger mid sections are half gone and now the rear sections under the bed are rotting to the point to where the is no good metal left the bed buckled and is hitting the cab the rest of this vehicle is in very good condition but the frame is gone.

- Erie, PA, USA

problem #46

Sep 102014

Silverado 2500 4WD 8-cyl

  • 150,000 miles
Was going to work at about 3:40 pm about 15 miles from my house had stopped at 2 stop signs and 3 red lights was going down hill towards 4th stop light cars were slowing down in front of me speed limit was 45 I was slowing my vehicle at about 25mph or less lost all brakes pedal went completely to floor was not able to stop vehicle hit truck in front of me no one was injured thank god this vehicle was bought brand new buy us at shelor motor mile Chevrolet in christiansburg Virginia it came with lifetime inspection by them had always been inspected by them last inspection 7 month this year last day of month never got any call of recall notice from GM or check brake line information from them I think GM should pay to have my truck brake lines replaced and be held liable for damages to my and the other persons truck this is a much more severe problem then ignition switch cutting off I think GM is putting this off because of cost and labor charges the truck is being towed to dealership today by the way brake lines at left under drivers door at ABS valve burst with no warning due to corrossion.

- Fairlawn , VA, USA

problem #45

Aug 182014

Silverado 2500 8-cyl

  • 95,757 miles
I was moving the 1999 Chevrolet Silverado 1500 in my driveway to make room to move another car. I backed the truck into my turn around, then put the truck into drive to move it forward a little. When I pushed on the brakes to stop the pedal went halfway to the floor stopped them went clear to the floor. I had no brakes, other than the emergency brake on the truck, which I used to stop the truck. After getting the truck stopped and to a spot I could inspect it. I discovered that two brake lines had burst and were leaking fluid onto the ground. The breaks were not in a bend in the line where they seems to typically happen. They were in a straight section just underneath the drivers side door where the lines run along the frame. Upon further inspection I noticed that all the brake lines were as heavily corroded as the section that had burst. Luckily this happened in the driveway as I was preparing to leave in the truck.

- Albany, OH, USA

problem #44

Sep 092010

Silverado 2500

  • 156,386 miles
ABS failure to stop vehicle. Accident occurred.

- Mason, OH, USA

problem #43

Jul 252014

Silverado 2500 8-cyl

  • 100,000 miles
Brake pedal went to the floor, vehicle did not want to stop, found all brake lines to be severely corroded from the master brake cylinder to the braking hardware at each wheel, dot3 brake fluild leaking quickly from brake line running toward the rear of the truck. Ref: www-ODI.NHTSA.dot.gov/cars/problems/defect/results.cfm?action_number=EA11001&searchtype=quicksearch&summary=true

- Hopkins, MN, USA

problem #42

Mar 312006

Silverado 2500 8-cyl

  • 72,602 miles
In 2013, the ABS began routinely activating during braking at speeds of 5-10 mph. I found recall 05068: Unwanted ABS activation. My GM maintenance records noted this recall service was completed 3/31/2006. The 3/31/06 service notes were "inspections: Electrical/wiring." I contacted GM corporate customer service in Jan.2014 to notify them that currently my ABS were erroneously activating on nearly all braking events. Additionally, I asked what recall service was actually performed on 3/31/06 because the notes only indicate an inspection occurred. A conference call ensued between GM customer service, the local GM service dealership, and myself. GM allowed 1 hour to diagnose the ABS problem on 1/22/14 at the local GM dealer. The resulting 1/22/14 service notes were: "diagnose & found left front wheel speed sensor dropping out. Inspect wiring for poor connections or damaged wiring. All ok. Gave estimate to replace left front wheel hub assembly." In person, the dealership said this bearing was worn & was causing ABS activation. I left upset, without the $642 wheel hub assembly install because I didn't believe the bearing was worn. On 5/30/2014, I had another service shop independently diagnose my trucks bearings, tie rods and suspension. They confirmed my original belief that the bearings did not need to be replaced. I did have both inner tie rods replaced at this time. On 6/17/14, I took my truck to a 3rd service shop to have them complete a front end alignment because inner tie rods were recently installed. I also asked them to determine if this bearing was worn. Their opinion was the bearing was ok and no maintenance was required. In summary, the GM service shop had opportunities on 3/31/06 and 1/22/14 to complete the recall remedy and failed. I have removed the fuses to disengage the ABS and prevent an accident because this condition still exists.

- Wausau, WI, USA

problem #41

Jul 172014

Silverado 2500 8-cyl

  • 93,000 miles
The brake lines are very rusty which has caused the brake line to break and cause the brakes to fail.

- Benton Harbor, MI, USA

Read the next 20 complaints »