Vehicle was fine until the front calipers, pads, rotors were replaced. Then randomly started loosing braking power. brakes are fine, new. Randomly when using brakes brakes will work, then loose pressure. No stopping power, petal goes to the floor and all the warning li come 9n. Have to reset code to get brakes again. Then at random they quit working again Code c12fe abs pressure pump loss

- Shelley, ID, USA

Ncfjj HD el n m a de no jabón

- Dallas, TX, USA

Front passenger seatbelt is stuck won-??t expand to buckle up, when turning on right blinker the high beam lights turn on. Which is unsafe for other drivers being blinded by the bright lights. Back hatch does not operate at all, could potentially be life threatening if that was an only exit due to unexpected Circumstances

- Fridley, MN, USA

Rear brakes faulty no to minimal braking power to the rear bakes as of today stopping distance significantly increased...by 20-30 feet.. no check engine light, ABS or brake light illuminated...currently there is no reason as to why it should not be working... front brakes work perfectly fine.. momentary power loss to vital components lost. System power loss event that caused power steering and all wheels to lock up among other things to stop working. Approximate speed at the time was 50mph... engine was still running at the time I was very fortunate for it to happen on a off ramp the two cars behind me were able to stop in time... it nearly cause and accident pile up with 2 other cars

- Palmdale, CA, USA

The contact owns a 2008 Chevrolet Tahoe. While driving approximately 75 mph, the brake pedal was depressed but the vehicle failed to decelerate. The vehicle was taken to a dealer where it was diagnosed that throttle position sensor failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 145,000.

- Milwalkee, WI, USA