The contact owns a 2008 Chevrolet Trailblazer. The contact stated that the ignition was turned to the on position and there was smoke coming from the hood without warning. The contact turned the ignition back to the off position and opened the hood and discovered the head lamp driving module relay on fire. The contact extinguished the fire. A police report was not filed and there were no injuries reported. The vehicle was taken dealer where it was diagnosed that the accessory board failed and needed to be replaced. The vehicle was not replaced. The manufacturer was not made aware of the failure. The approximate failure mileage was 89,471.

- Rio Rancho, NM, USA

Purchased this vehicle from a dealer. The next day the truck was dead. It has since had the battery replaced 3 times. The exhaust manifold cracked at 82,000. The number 4 position on the blower does not work. The stabiltrak lights come on for no reason and go off for no reason. With all of the complaints, something should be done.

- Walkerton, IN, USA

While driving low beam lights shut off while driving at night. Will not come on now! this is a very dangerous situation for safety reasons. I am 73 years old and afraid to drive at night and also daytime with no daytime running lights. Please advise if there is a recall or solution so I can have dealer get it fixed. Loyal Chevrolet customer for 50 years that needs desperate help. Thank you! ## VIN passed ## Chevy Trailblazer LT2 2008 ##

- San Antoni, TX, USA

Low beam lights went out. We replaced bulbs, they worked for a short time. Low beams went out two or three days later. Went to local garage, they replaced wire from battery to lights as they were not getting any power. Lights worked for two or three days. Trailblazer was in shop for a week, unable to find issue. Called Chevrolet dealership, at first they thought it was a 2007 which has a recall for the issue. Found it was a 2008, no recall. Found bad/burnt/exploded fuse labeled 15016745. Have found multiple other people with same issue online.

- Gilmanton, NH, USA

Airbag light came on and had a bad impact sensor. Had to replace to pass inspection. SUV only 6 years old. Stability control light comes on every time I hit a bump in the road.

- Portsmouth, VA, USA

While I was driving down the road, both curtain side air bags deployed at same time. There were no other cars on the road, so I was able to stop the vehicle without causing an accident. The airbag on the driver side pushed me over so hard that it broke my center console. My lower back still hurts, but I am hoping the pain will go away. My left ear is still ringing and has not returned to normal hearing yet caused from the exploding noise from the airbag deployment. Both of the front seat belts will not work and the dashboard has so many lights going off, I don't know if there are any other problems. The dealership that I purchased the vehicle from said the damages could run as much as $4000 which I do not have and my insurance doesn't cover this since there was no accident that caused this. The dealership service dept. Also said they have never heard of any vehicles doing this. After research, I see that this has happened alot.

- Waukee, IA, USA

My fan blower quit working on some settings (0-5 available, only 1,2, and 3 make fan work). I bought a new blower resistor to replace it, and when I tried to disconnect the old one, I discovered what appeared to be an electrical fire had fused the harness to the resistor. I was able to break the harness away from the resistor, but two of the connectors on the harness are blackened, and the harness is partially melted away. When I hooked up the new resistor, 1,2,3, and 5 work, but 4 is still not operational. I believe 4 is not operational due to charring or melted plastic preventing connection from being made to one or both of the two charred connectors. First date of problem is estimated to be winter 2012, though it may have been a year or two earlier. My replacement of the resistor was 18 Oct 2014.

- Saint Peters, MO, USA

While driving on a steep downhill curvy mountain pass, the key got jerked into the off position. Luckily I quickly restarted the engine. This is very dangerous on roads with a sharp incline and/or decline as one would need to be able to brake and steer the car into a safe area.

- Reno, NV, USA

The contact owns a 2008 Chevrolet Trailblazer. The contact stated when the brakes were applied the vehicle stalled without warning. The vehicle was towed to the dealer where the ignition switch was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 86,000.

- Conneaut, OH, USA

The ignition switch has been acting like the ones that are recalled with the 05 - 07 model years. Our vehicle when you turn the ignition on it acts like its dead, even with no key in ignition you can turn switch a little and the gear selector light comes on as well as the battery light, and we have had two dead batteries from this.

- Waretown, NJ, USA

The electronic control module "fried" and caused the brakes to "fail" - specifically, the brake pedal needed to be pressed to the floor although it had little effect. This sounds very much like the failure seen in the recall #3: 2014 Chevrolet Malibu. The ECM failure also caused a short in the airbag sensor. (a repair was done on the brakes - but I am not sure it was needed except for the ECM problem based upon the description of the Malibu recall). The dot reference for this is: 656599.

- Richmond, KY, USA

On the 2008 Trailblazer, had two problems with the ignition switch. In April 2011 the tumbler mechanism portion of the ignition switch failed at approximately 27,225 miles and was replace under warranty. In May 2014 had difficulty starting the vehicle when the ignition switch was in the start position. Was able to start the vehicle and drive to the Chevrolet dealership. While waiting for the service technician, I moved the tilt steering wheel to a different position and the vehicle stopped running. This would have been an extremely dangerous situation under normal driving conditions. It was diagnosed that the electrical portion of the ignition switch had failed. The ignition switch was replaced. The approximate mileage was 71878.

- Prince Frederick, MD, USA

While sitting the parked vehicle, with the key in ignition in the on position but engine off the dash began to pour smoke into the vehicle. Upon inspecting under the hood there were burned and melted wires leading to fuse box. Electrical fire occurred.

- Orange Park, FL, USA

The contact owns a 2008 Chevrolet Trailblazer. The contact stated that the ABS and stabilitrak warning lights were illuminated. The vehicle was taken to the dealer, who diagnosed that the ignition switch was defective and needed to be replaced. The vehicle was repaired and the defect was remedied. The manufacturer was not notified. The failure mileage was 10,779.

- Chandler, AZ, USA

Repeated issue. Smell of smoke/burning triggers dash warning signals. Same dash warning signals come on without smell of smoke/burning. Cycle repeats itself without pattern, and includes during 4 wheel use. Vehicle taken to multiple Chevrolet dealerships for service (Utah, North Carolina and Washington) with the dash warning lights on. Utah and nc claim unable to replicate event or identify problem, so listed as unknown without correction. GMC executive office interdiction resulted in replacement of stereo even though dash light indicate powertrain & electrical. Stereo broke 2 mos later. Gmeo and wa identified fuse issue related to 4 wheel drive, but unable to replicate smoke/burning before claiming issue resolved. Dash warning lights constantly come on and off indicating problem with powertrain/electrical. Gmeo closed case as resolved.

- Monroe, WA, USA

The contact owns a 2008 Chevrolet Trailblazer. The contact stated that the key failed to turn in the ignition and the vehicle could not be started. The contact mentioned that the failure occurred only once. The vehicle was not taken to a dealer for diagnostic testing. The manufacturer was not made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 74,316 and the current mileage was 81,447.

- Bethlehem, PA, USA

The contact owns a 2008 Chevrolet Trailblazer. The contact stated that the front driver's side electric panel for the windows was not fully functioning. The failure recurred intermittently. The rear windows would electronically open but when attempting to close the windows from the front drivers side main electric panel, it would require the contact to manually close the windows. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 102000.

- Telford, PA, USA

I've noticed several times that my vehicle will turn on when I place the ignition key into the "on" position right before I turn the key all the way to start it. I'm not sure if it was due to the cold weather or not. Also, my engine light is always on and I had it tested which came back as an emissions control problem. Which could be the gas cap I haven't paid to fix yet.

- Bloomington, IL, USA

In the fall of 2012, I had to replace an ignition switch in my Trailblazer at approx. 90,000 miles. Then, in July of 2013, we were driving on interstate 95 in ct, heavy traffic, high speeds, and all of a sudden my car just died. I, fortunately, was in the right hand lane and was able to drift off the road. A ct trooper sat behind us for an hour while we waited for aaa. It was a Sunday. We were towed to a Chevrolet dealer in old saysbrook, essex ct. Had to spend the night in a hotel and that Monday, the dealer put in another ignition switch. My mileage was a little over 100,000. Have all the documentation. Have you looked into ignition switch failure in Trailblazers" is my car safe to drive" would appreciate a response.

- East Dennis, MA, USA

The contact owns a 2008 Chevrolet Trailblazer. The contact stated that while driving 15 mph, the vehicle stalled. The contact mentioned that the check engine and air bag warning lamp illuminated. The vehicle was towed to the dealer. The technician diagnosed that the ignition was defective and needed to be replaced. The manufacturer was made aware of the failure. The vehicle was repaired. The failure mileage was 61,000 and the current mileage was 63,000.

- La Vale, MD, USA