The contact owns a 2005 Chrysler Pacifica. The contact stated that upon start the vehicle, the gear shifter failed to operate as needed without warning. The contact called and informed several dealers of the failure and was informed that there was a defect with the power train. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 73,000.

- Richmond, TX, USA

The contact owns a 2005 Chrysler Pacifica. The contact stated upon attempting to reverse out of the garage into the driveway, the gear shifter remained seized in park(P). There was no warning light illuminated. The vehicle was towed to an independent mechanic where it was diagnosed that the gear shifter assembly needed to be replaced. However, the parts to repair the vehicle were not available. The dealer was notified of the failure and informed the contact that the parts had been discontinued. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 75,000.

- Roswell, GA, USA

Head lights cut off and on intermittently engine idles ruff

- Eastpointe, MI, USA

The contact owns a 2005 Chrysler Pacifica. The contact stated that the gear shifter ceased in the park position. The vehicle was not taken to be diagnosed nor repaired. The manufacturer and bakersfield Chrysler Jeep Fiat-3101 cattle dr, bakersfield, ca 93313, (661)832-3000) were contacted and informed of the failure. The failure mileage was 220,000.

- Bakersfield, CA, USA

The contact owns 2005 Chrysler Pacifica. The contact stated that while driving at 50 mph, the vehicle started to jerk and loss motive power with the check engine warning light illuminated. The contact activated the hazard light and veered to the shoulder of the roadway. The vehicle was restarted and driven for several minutes before the failure recurred. The contact also stated that the fuel gauge failed to register the correct level of fuel. The vehicle was not taken to be diagnosed nor repaired. A dealer was not contacted. The contact referenced NHTSA campaign number: 06V432000 (power train) as a possible solution to the failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 182,435.

- Warrensburg, MO, USA

Car loses power and cuts off due to PCM and fuel system

- Kansas City, KS, USA

The 2005 chrystler Pacifica was traveling 35 mph in the winter on a paved road when it just died no warning. I had it towed to my house for further testing.the car tries starting but never turns over act like no fuel. I then hooked it up to my foxwell NT630 elite obd2 scanner it detected codes P0340, P2066, P0700, & P0461 code P0340 cam shaft position sensor a circuit bank 1 or single sensor (part replaced). Code P2066 fuel level sensor B (performance). Code P0700 transmission control system. Code P0461 fuel level sensor a (range/performance) NHTSA campaign number: 06V432000 manufacturer DaimlerChrysler corporation components power train potential number of units affected 127,928 summary: On certain passenger vehicles, the fuel pump module and the power train control module (PCM) software may allow the engine to stall under certain operating conditions. Remedy dealers will reprogram the power train control module. The fuel pump module will also be replaced on vehicles built from August 1, 2004 through September 30, 2004. The recall began on November 21, 2006. Owners may contact DaimlerChrysler at 1-800-853-1403. Two separate defect conditions that could result in engine stall while driving in model year (my) 2005-2006 Chrysler Pacifica vehicles (NHTSA recall no. 06V-432). My 2005 vehicles built in August and September of 2004 are being recalled to correct a defect in the secondary fuel pump modules, which may have an improper press fitting on the inlet that can become dislodged and shut-off fuel flow. All my 2005-2006 vehicles built between July 8, 2004 and November 11, 2005 are being recalled to correct a powertrain control module (PCM) software issue with the evaporative emissions system which can also cause stalling. For both conditions, engine stall incidents tend to occur during left turns. NHTSA action number: RQ06002

- Hiawatha, IA, USA

I drove out from car wash I was going about 35mph then I turned right on to the freeway soon as I reached 50mph my vehicle made a weird noise and shut off as im on the freeway. There were no warning lights on whatsoever although I got a "gas cap" message. The steering wheel locked I had to pull off the free way(no accident, thankfully) the breaks were hard to push down I had no choice but to let it roll through traffic I got to a safe place I put it in park waited about 30 minutes to try starting it, it would not start. Smoke came out from back passenger rear tire. Let my car sit over night tried to start it the next morning, again it would not start. I had it towed it into shop they could not find the problem I had left my vehicle in the shop for a week other mechanics discovered the problem. Later they told me I need a whole new engine. I only got to drive it 2X before it stalled. I really like it and wish I can get it fixed I do believe it has to do with the power train, fuel propulsion, and engine.

- Scottsdale, AZ, USA

Takata recall the car lurches forward and bangs when stopped, also while stopped the car registers 20mph. When driving speed reaches 60mph the car has power surges and shutters, the car makes a loud whining noise while driving like it is stuck in high gear. The car has a high RPM speed of 4-6rpms while driving. The service engine light is on at all times.

- Bastrop, LA, USA

I just came out from car wash I turned right on to the freeway soon as I reached 50mph my vehicle made a weird noise and shut off. The steering wheel locked I had to pull off free way(no accident, thankfully) go to a safe place put it in park try starting it it wouldn't start. Smoke came out from back passenger rear tire. Let my car sit over night tried to start it next morning, wouldn't start. Towed it into shop they couldn't find the problem but later they told me I need a whole new engine. I only got to drive it 2X before it stalled. I really like it and wish I can get it fixed

- Scottsdale, AZ, USA

Car was stationary in residential driveway. Transmision would not shift out of park. The simple release mechanism did not help. Took consol apart. As described on youtube videos, could see that the pink plastic part was broken so spring did not operate. Found opening so I could rotate the pink part with finger and get out of park. This problem sounds exactly like problems covered by recall K39, but my model is apparently not covered. Why is it not covered" should Chrysler cover the repair"

- Pleasanton, CA, USA

When I was driving on the freeway (driving 45 mi/hr), it stopped moving accelerating (seems like the car is actually slowing down) even when I was stepping on the gas pedal. And then the car stalled.......it was a good thing I was on the very right side of the lane. The fuel pump module and/or the powertrain control module (PCM) software may allow the engine to stall under certain operating conditions, increasing the risk of a crash. Dealers will need to reprogram/replace the PCM/tcm and/or replace the fuel pump module to correct this concern. In most cases, aside from stalling and engine revving up and down on its own, there's a lot of hard jerking when driving the vehicle. It seems like the engine has a mind of its own since when I accelerate, the car will not move or delay in moving forward and if I let go of the gas, the car moves forward. It's a safety concern.

- Suffolk, VA, USA

Front sub-frame has rusted through rendering the vehicle unsafe to drive. This is the exact same failure as many other reports you have received on this vintage, make and model vehicle. Fca has refused to offer any assistance toward the repair and my local mechanic reported that new replacement sub-frames are not even available - leaving consumers with the choice of recycling the vehicle at a salvage yard, repairing it with what is obviously flawed oem components, or keep it as lawn decoration. I have taken the vehicle off the road and am thankful the problem was discovered prior to my wife or son experiencing a catastrophic failure while driving. It is only a matter of time before someone looses a life because of this defect. Be proactive and force fca to repair these failures - regardless of mileage - or this organization is part of the problem.

- Clarkston, MI, USA

The contact owns a 2005 Chrysler Pacifica. Within less than 30 days of the contact owning the vehicle, the contact stated that the vehicle jerked and the transmission slowly shifted in and out of gear. The vehicle was taken to an independent mechanic where it was diagnosed that the sensors could be the cause of the failure. The vehicle was also taken back to the dealer it was purchased from and the alternator assembly was replaced; however, the failure recurred. The vehicle was also taken to bergstrom used car super center of appleton (2925 N victory ln, appleton, wi 54913, (920) 749-3232) where it was diagnosed that the frame had extensive rust, holes, and corrosion that could affect the motor, rendering the vehicle unsafe to drive. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was not available.

- Appleton, WI, USA

The contact owns a 2005 Chrysler Pacifica. The contact stated that the key was difficult to turn in the ignition to start the vehicle. In addition, the fuel gauge was showing a low fuel amount after the vehicle had been filled with fuel. The vehicle was not diagnosed by a dealer. An independent mechanic inspected the vehicle. The manufacturer was notified of the failure. The manufacturer issued a safety recall (F44 ' fuel pump module and/or reprogram PCM). The vehicle was not included in NHTSA campaign number: 06V432000 (power train). The approximate failure mileage was 90,000.

- Granada Hills, CA, USA

I have owned this vehicle for almost two years with minimal issues. All of a sudden three days ago, I was driving on the freeway and the accelerator stopped working. The car did not shut off just kind of sputtered like it wanted to cut off. I had to maneuver my way to the side of the road. Eventually I ended up having it towed to my home. Now I am without a vehicle. I was told it could be the PCM, ECM or the transmission.

- Detroit, MI, USA

The contact owns a 2005 Chrysler Pacifica. While driving various speeds, the vehicle stalled and the check engine warning indicator illuminated. The vehicle restarted after several attempts. A unknown dealer was contacted and confirmed that the VIN was not included in NHTSA campaign number: 06V432000(power train). The vehicle was taken to an independent mechanic where it was diagnosed that the power train control module needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 130,474.

- Baltimore, MD, USA

The contact owns a 2005 Chrysler Pacifica. While attempting to accelerate the vehicle, it stalled without warning. The vehicle was unable to restart and was towed to the contact's residence. An independent mechanic inspected the vehicle and diagnosed that there was no fuel. The contact noticed that the fuel gauge displayed that the vehicle was filled with fuel. The contact mentioned that the vehicle stalled numerous times without warning. The vehicle was towed to an unknown shop where the failure was undetermined; however, the failure persisted. The manufacturer was notified of the failure and stated that NHTSA campaign number: 06V432000 (power train) was repaired before she became the owner. The VIN was unknown. The approximate failure mileage was 184,000.

- Semmes, AL, USA

When driving the car would stall at stop signs or has issues maintaining speed going up hills. Also I took the vehicle into a mechanic and they told me the sub-frame is completely rotted through and the steering is being held together with 1 bolt. They stated the car is unsafe to drive.

- Bellevue, NE, USA

The contact owns a 2005 Chrysler Pacifica. While driving 10 mph and making a right or left turn, the vehicle stalled without warning. The failure recurred numerous times. The vehicle was not diagnosed nor repaired. The VIN was not included in NHTSA campaign number: 06V432000 (power train). The manufacturer was notified of the failure. The approximate failure mileage was 150,000.

- West Valley City, UT, USA