While driving heard a thumping noise in the front end of the vehicle. Took vehicle to the dealer, and was told that she needed a new axle. She had the axle replaced. Also, she was told that the rims were bad, and tires continuously lost air. Took the vehicle back to dealer, and was told that the rims rusted completely through. That was why the tires didn't last. The rims broke into the tires.

- Penn Yan, NY, USA

Vehicle had several flat tires. This was due to poor sealant of the aluminum rims at the factory, causing air to leak out.

- Schaumburg, IL, USA

On December 18,2003, one the wheels (rims) on my wife's car bent and caused the tire to deflate very repidly and almost caused her to loose control and cause an accident. In 2002 the same thing had happened with another of the wheels. The car had to be towed after the 2003 incident. While having the wheel replaced it was found out that two other wheels were bend and in need of replacement. My wife found out from other customers at the tire place that several other people had the same bad experience with the same type Sebring. I called chrsyler and they insisted they had never had similar complaints, but I know of an individual who was compensated for his wheels. My complaint is so that it may be noted that there is a problem with the wheels on 1999 Sebrings. I found out that there was a problem in the metal alloy used in the manufacture of the wheels.

- Corpus Christi, TX, USA

Please add VIN# to complaint I filed earlier. I would appreciate a reply from you. This is a serious safety issue, and it's only a matter of time before someone has a blowout and a major wreck. Chrysler needs to recall these wheels, and I believe they know it but are ignoring the customers.

- Evansville, IN, USA

Wheels on this car are too soft and bend easily. When bent badly enough, they lose the seal on the tire and cause a blowout. So far I've had 9 wheels fail, with one blowout, 5 flat tires. My tire dealer tells me this is the #1 replaced wheel in the nation, with #2 very far behind. Chrysler and their dealer both refuse any assistance.

- Evansville, IN, USA

The rims on my 1999 Chrysler Sebring bend very easy. I have had 2 blowouts and 5 flat tires because of this. Before this car I never have had any blowouts. The rims are defective is what a mechanic said about these.

- Santa Rosa, CA, USA

Was having tires rotated when mechanic noticed left front rims were bent. Was informed not to drive vehicle, and have rims replaced. A few months later, had noticed rear rims were bent like front rims had been.

- Wrigley Park, PA, USA

Tires loose air due to rim leaks. Snow tires lost air as well as all seasons. Bead area has been cleaned, this did not help. Tire dealer states that the leak is in 2 rims. Ie: bad weld. (tiresize: 205-65-15)

- Milford, NH, USA

Rims on vehicle bent very easily. When rims bent, it caused bead between rim and tire to separate/ tires started to lose air, and go flat. When contacting dealer, dealer melted and reshaped rims, including two that where melted and reshaped.

- Rhome, TX, USA

I have never had a flat tire untill I owned this vehicle. The problem I believe is with the aluminum rims. They lose air, the rim bends up easily, I never know when I'm going to have another flat tire because of these stupid rims that look nice.all tires on my vehicle have been replaced. This car is a death trap and me and my daughter might not be so lucky the next time I get a flat tire because of my rims!!!!!!!T (tiresize: P215/50R17)( dot number: Tire size: P215/50R17 )

- Newport, MI, USA

The wheel rim does not have a good seal causing the tires to leak air, the rear drivers tire experienced a blowout. Nlm

- Hilliard, OH, USA

The wheel rim does not have a good seal causing the tires to leak air, the rear drivers tire experienced a blowout. Nlm

- Hilliard, OH, USA