1.4

hardly worth mentioning
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
124,201 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2010 Chrysler Sebring:

Unsubscribe any time. We don't sell/share your email.

problem #9

Apr 012018

Sebring

  • 95,000 miles
The contact owns a 2010 Chrysler Sebring. The contact stated while driving at an undisclosed speed, the throttle body warning message illuminated and the vehicle stalled. The vehicle was towed to an independent mechanic who replaced the electronic throttle body, alternator and sensor however, the failure recurred. The vehicle was taken to another independent mechanic and diagnosed with a low voltage failure, and a defective engine control module which needed to be replaced. The vehicle was not repaired. An unknown dealer and the manufacturer were notified of the failure. The failure mileage was 95,000. The VIN was not provided.

- Sacramento, CA, USA

problem #8

Nov 052019

Sebring

  • 300,000 miles
The contact owns a 2010 Chrysler Sebring. While making a turn, the vehicle shut off and the check engine indicator illuminated. The vehicle was placed in park and restarted. The dealer and manufacturer were not contacted. The failure recurred, but was not diagnosed or repaired. The failure mileage was approximately 300,000.

- Jacjsonville, AR, USA

problem #7

Aug 272018

Sebring

  • 179,000 miles
Check engine light came on and I started having erractic shifting, codes came back as PO755, P0700, P0716, P1607. This vehicle's transmission will not shift. I have taken to numerous shops half of them say it the PCM the other say it needs a transmission replacement. I have had the shift solenoid B replaced by dealership only for them to charge me then tell me it need a transmission replacement. The vehicle will still drive forward and backward but will not shift gears at all. Losses acceleration every so often then harsely goes back into gear while in motion. RPM is very high but will still drive.

- Commerce, GA, USA

problem #6

Oct 062016

Sebring

  • 105,820 miles
Etc light comes on and vehicle will not accelerate it happens when I start the vehicle when I drive it happens constantly I took vehicle to Chrysler dealership and was told it wa the throttle body paid 800 dollars still have the etc and same issue happening. This is a libility and accident waiting to happen it is unsafe to drive a vehicle and have it lose acceleration why driving up hill or highway.

- San Antonio, TX, USA

problem #5

Apr 292016

Sebring

  • 121,000 miles
The electronic throttle light comes on and the RPM decreases then engine stalls. Several times I was able to restart engine and it has now completely failed. I see numerous reports of this issue online but no specific repair for this defect.

- White City, OR, USA

problem #4

Feb 082016

Sebring

  • 127,000 miles
My car's electronic throttle control light comes on when I am in motion. The etc turns off when the car is cut off and restarted. I feel unsafe driving the expressway being that I drive for a living.

- Memphis, TN, USA

problem #3

Jun 022014

Sebring 4-cyl

  • 85,000 miles
First time anything happened - hotoil warning, check engine light and a weird temp light came on - but all gauges were fine and car was driving fine. Took it to a couple different places to have a diagnostic run on the car. Codes came back that the ECM and tcm were not communicating. System was reset and car was fine. A few weeks later same thing. My husband was driving and it also quit shifting. At a stoplight we felt a clunk as it slipped into gear lights went out and everything seemed fine. About a week ago - same thing happened, took it to Chrysler garage and for $100 ran a diagnostic and told us that the powertrain control module was defective. They updated the computer and it seemed to work fine. Tonight (only a week since it was updated) all of the lights came back on and it has quit shifting. I am going to have to go back to Chrysler for a $3000 + replacement of the entire PCM (powertrain control module is the main computer system in the car) I have a warranty on the powertrain - but of course this part is not covered - even though it is the powertrain control module. It seems odd to me that the 2009 Sebring had a recall for this exact part and so did the 2011, but not the 2010. Strange -- and I can honestly say I hate Chrysler --- totally rude and unconcerned about the financial burden this will cause my family --- if the PCM is required for the powertrain to function properly - it should be considered part of the powertrain and should be covered under the warranty. Also I would be very interested to know why the 2010 is not being recalled for the same part as the 2009 and 2011.

- Grand Junction, CO, USA

problem #2

Mar 182014

Sebring 4-cyl

  • 104,992 miles
The car is less then 6mo I purchased the car with extended warranty, they now saying that the extended warrant only cover the engine and the transmission, the electronic throttle control is faulty, the whole throttle body has to be replace the shop then tells me that throttle body on the car was from a junk yard the sensor is warped. J.D byryder has been giving me the run around about fixing my car that I still pay a car note on every two weeks. And have never missed a payment.

- St. Louis, MO, USA

problem #1

Sep 012012

Sebring

  • miles
2010 Chrysler Sebring. Consumer writes in regards to vehicle racking pinion problems. The consumer stated the rack pinion failed again three years later. When the consumer picked the vehicle up, from the dealer, the noise was still there. The consumer returned to the dealer, and according to their diagnosis, the vehicle needed a new steering column. When the consumer picked the vehicle up again, the noise was still present. The technician informed the consumer, the noise was coming from the rack and pinion again, and there was no remedy. Later in the evening, the vehicle began making another noise, and was taken back to the dealer, where they determined the left front axle and wheel bearing needed to be replaced.

- Washington, DC, USA