The fuel pump relay has failed. The relay is part of the TIPM and the cost to repair at the dealer is well over one thousand dollars.

- Girard, OH, USA

Vehicle has repeatedly died while driving on the highway. After sitting approximately 1 hour it will start again.

- Gwinner, ND, USA

Fuel pump relay not working and caused van to stall while driving. Then van wouldn-??t start due to not getting fuel. Vehicle is not safe to drive due to possibility of stalling while driving.

- Greendale , IN, USA

Confirmed cylinder number 2 misfire. Performed relative compression test and intake trace pull. Confirmed that number two has low compression and is directly affecting cylinder number fives intake pull. removed spark plug and did a compression test on cylinder 2 it had 90psi of compression and the rest of the cylinders were at 148psi of compression. used a bore scope and found cylinder damage in video attached vehicle needs a new engine to correct customers concern. When going up a small incline at 30-45mph engine would stall out. I have 3 little kids and I drive a lot for my job and want to be safe on the road! Also my blind spot detectors have constantly been on since about 75,000 miles. It-??s kind of a distraction when you are driving at night.

- Ofallon, MO, USA

The can has issue starting due to tipm malfunctions effecting the fuel pump. Also causes battery to die from fuel pump not shutting off when car sure off. The car has shut off on me. A few times. Most recently on the highway while being in the left lane. It was very dangerous. And hard for me to get it somewhere safe.

- Atlanta, GA, USA

The External Fuel Pump Relay has failed causing stalling conditions while driving and starting problems. Along with that, it has drained the battery due to not turning the fuel pump off after the car is turn off. The part was recalled on the Jeep and Durango models with the same 3.6L engine. There have been many reports of this online with Town and Country and Dodge Caravan models with the 3.6L and 5.7L engines.

- Beaver Falls, PA, USA

Bad relay module: 1. Battery drained while parked in garage overnight, multiple occasions. 2. Fuel pump continued to run and make noise when the vehicle is shut off. 3. Chrysler dealer performed diagnosis and confirmed that the TIPM require replacement, replacement part will take additional two months to arrive. 4. Engine stalled while making low speed right turn at high traffic intersection and nearly caused accident with children onboard. Likely caused by shut off fuel pump. 5. The vehicle is absolutely unsafe to drive and require immediate repair.

- Ellicott City, MD, USA

It's the timp the big black box with all the fuses in it I have had so much problems with it it messed up the alternator and the battery and the doors and the fule pump now I have to get a new box and a fused pump because it won't start at all now it have quite on me while I was driving before it broke all the way down I don't know why they ain't a recall on it yet

- South Charleston, WV, USA

Chrysler recalled Jeep n Durango models due to faulty fuel pump relay. Town and Country vans were added to recall expansion. #R09- 14V-530 My van doesn't start properly and have been stranded with 2 young children n cold weather. I need my van for work as I'm a single mother and just bought the van. I need this repaired immediately.

- Gladys, VA, USA

Car stalls while driving. Looses brakes and steering. Mechanics can not determine cause. No codes stored. Almost caused a collision happened 4 times in a month

- Wilmore , KY, USA

When trying to start start button is pushed, van turns over, starts for ~2 seconds and shuts off. Takes several tries to get it to completely start and continue running. Also when turning van off. Push button, van stops running, however, it switches to accessory and takes several times pushing button to switch to off and stay there. Vehicle is on level ground and stationary parked position. This has been going on for a month off and on. Recently the last week.

- Williamsport, PA, USA

The van would not crank when I got ready to leave work. I waited a bit, put my halo charger on it and it cranked. The next morning it would not crank. It would turn over but not start. We had it towed to a mechanic who kept it for 4 days and told us we needed to take it to the dealer. We were told that it was the tipm, $1600 to replace, but $400 to do a bypass.

- Beaufort, SC, USA

The fuel pump relay is faulty. We have had issues with the vehicle stalling out while driving. Once almost causing an accident. My mechanic said this is an issue with this vehicle. This is the same set up as the Jeep Grand Cherokee and there was a recall issued for that. We took the vehicle to a mechanic and the parts to replace the relay are not available. We do not feel safe to drive the vehicle any more. I believe there should be a recall issued for the safety of owners. My wife was pulling out into traffic when the van completely stalled out while oncoming traffic was approaching. Luckily, she was able to manuver into a turn lane to avoid a collision. We've also had numerous times that it would glitch out while driving but not stall.

- Sunfield, MI, USA

The vehicle does not consistently start and has a chance of failure when in operation. I have the vehicle in a shop and it has been diagnosed as a fuel pump relay that is not consistently receiving power. This has been a well known issue within the tipm system but no recalls are open on this specific vehicle.

- Battle Creek, MI, USA

Vehicle has less than 85,000 miles was working fine then few days ago would not start. The starter worked fine but would not turn over. Let it sit for half an hour and it started on first crank so I let is it run for a few minutes. Turned off and left for an hour or so tried again and had to repeat entire process...vehicle was stationary because we're afraid to drive it anywhere. Original owner is in a va healthcare facility and his daughter and me (husband are handling his affairs. Because of that it is my contact info imputed.

- Tampa, FL, USA

Tapping noise coming from top of engine diagnosis multi cam shaft rollers

- Baltimore, MD, USA

In starting van, engine was turning over when key turned but not to the point of running. After 5-8 attempts it would crank and also sputtered in between attempts. Car was stationary. This was a sudden onset of symptoms that happened on vacation. Recogniing we had additional days on our trip plus the ride home, I took to local repair shop. In route, it sputtered like it wanted to quit. The diagnosis was fuel pump and fuel pump relay failed pressure test and diagnosis. I then learn by searching that 2011 vans have been recalled for same issues. With a return home interstate trip of 600 miles, I thankful I had repaired now reading what has happened with the 2011 related accidents and problems.

- Columbus, MS, USA

My van needs a new tipm. This is a recall for some Chrysler vehicles under P54/NHTSA 14V-530. Why does this not include all Chrysler vehicles? the van starts intermittently. Sometimes without issue other times takes minutes and several attempts.

- Omaha, NE, USA

I purchased my vehicle in March of 2016 for the purposes of transporting 2 disabled family members. First, check engine light was coming on and stated that the crankshaft sensor we're not working. When I would drive while driving my vehicle would just shut off I feared getting hit by other vehicles. Then the fuel pump relay would stay on after shutting vehicle off until it would drain the battery. After, now my vehicle cranks but doesn't start at all. This is a hazard and dangerous what I am afraid of is that this is a common issue with these vehicles and the issue has not been looked at by the proper department or authority. I also brought this issue to Chrysler where I purchased the vehicle and they said they can not assist with the issue and no recalls have been put in place my vehicle has been parked for 5 months now.

- Springfield, MA, USA

2012 Chrysler Town and country purchased second hand at 84.000 miles vehicle started then following at 86,000 miles. Lights sensor would activate lights without input from remote or driver. Then the lights stopped sensing when to change and has to be activated in manual. Vehicle windows would not remain up and locked when manually inputted to do so or activated to do so with remote. Interior lights would randomly switch on and run the battery dead. This resulted in many jumpstarts. Vehicle began to use fuel like $30 weekly with normal driving of my family to $30 every two to three days with no charge in driving. This increased when the family needs to drive increased to almost $20 daily. Vehicle would not accelerate on an incline would stay at 30 mph despite you pressing the gas and it woul rev. Vehicle would decorate and accelerate on its own merit, one could press the gas and it wouldn't increase going up an incline causing any to maneuver around you to avoid collision and the it would accelerate on its own merit. Vehicle lift gate would not remain locked when secured whether by remote or manual. Lift gate also stopped sensing and has almost locked my small disabled a children in between where it closes. Vehicle lights would stop working with sensing in the auto mode. Have to manually use them then internal lights would come in and kill the battery. The signals in the dash had major malfunctions you would get the airbag, check engine and various lights intermittently flashing. The driver side seat would not work as you change a fuse it would blow. The passenger doors would not lock with remote input or manual lock door can open when driving. Rear windows would open on their own merit usually causing animal to get in. The car fuel pump would not stop running until the battery died or the terminal was removed. The screen said display is hot.

- Manchester, CT, USA