I was turning left into a parking lot when my 2020 Voyager steering stopped working while it started to show all warning lights and the wipers went on, then it went dead, had to be towed on a flatbed to the dealership, and after 4 weeks with no solution in sight, I decided to bring it home and research the solution myself, The problem came from the CAN bus connector located above the glove box, any short or voltage fluctuation from the wires out of the can bus causes the car to go into panic mode, sometimes making the steering wheel stop steering, and the engine to turn off, most of the times it renders the vehicle disabled. One of the connectors goes into the steering module attached to the electric steering column under the car, the pair of wires near the steering module was fused and exposed, touching each other, and the poor wire insulation, proximity of the engine exhaust pipe, and other hot components coupled with an excessive tight cable zip tie caused the damaged to the wire. Chrysler needs to replace wiring coming from the can bus connectors as damages to any of the wires cause wide failure of vital car components while driving. Case and point, a major safety issue with the Chrysler Voyager 2020 and possibly Pacifica 2020 as my steering wheel stopped working while making a left turn that could have caused a crash with incoming traffic. The vehicle was inspected by an authorized Chrysler Dealer, but after 4 weeks they were unable to find and fix the issue, they replaced the auxiliary battery and were trying to replace the RFH module by did not fix it, that's when I decided to remove the car and inspect it my self.

- Boynton Beach, FL, USA

Start stop light comes on and vehicle goes to limp mode or dies while driving, Check engine light also comes on.

- Clinton , AR, USA