1.5

hardly worth mentioning
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
110,470 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2008 Dodge Caliber:

Unsubscribe any time. We don't sell/share your email.

problem #10

Sep 232021

Caliber

  • 159,000 miles
The contact owns a 2008 Dodge Caliber. The contact stated while taking the vehicle into a local state inspection, he was notified that the vehicle did not pass inspection due to the K-frame of the undercarriage was fractured due to corrosion and rust. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 159,000.

- Derry, NH, USA

problem #9

Jul 012019

Caliber

  • Manual transmission
  • 162,321 miles
The contact owns a 2008 Dodge Caliber. While the vehicle was at an intersection, the vehicle shook violently when the accelerator pedal was depressed. There were no warning indicators illuminated. The contact managed to steer the vehicle home while it shook. The contact looked under the vehicle and noticed that the rear subframe was fractured. The dealer was not contacted. The manufacturer was made aware of the failure and informed the contact to file a complaint with NHTSA. The vehicle was not repaired. The failure mileage was approximately 162,321. Consumer stated front subframe rusted and corrosion, VIN is xxxx. 'parts of this document have been redacted to protect personally identifiable information pursuant to the Freedom Of Information Act (FOIA), 5 U.S.C. 552(B)(6).'

- Swanton, OH, USA

problem #8

Aug 242018

Caliber 4-cyl

  • 128,000 miles
The problem deal with the front crossmember subframe. This part is total junk. It is completed rusted out. It was just a miracle it did not cause an accident prior to our finding it needed replaced. After checking online and finding the 2007 Caliber's were handled under a "recall" but nothing has been done on subsequent years. After just leaving home the right front wheel pulled badly to the right, while making screaking noises. The car was limped back into the drive and the problem found. I believe this is a very poorly made part, probably with inferior steel. I have attached two (2) pictures of the old subframe. The car is registered to my daughter [xxx], I am her father [xxx]. I contacted a local dealer and expressed my concerns and they informed me to contact Dodge/Chrysler which I did. They informed there was no assistance for this issue. They did take my complaint. I believe this to be a serious safely issue with any vehicle that has this type of crossmember subframe. Please contact me if you need any other information. [xxx]or by cell phone [xxx]. I would appreciated any type of reply. Sincerely [xxx]. information redacted pursuant to the Freedom Of Information Act (FOIA), 5 U.S.C. 552(B)(6).

- Wapakoneta, OH, USA

problem #7

Jul 242018

Caliber 4-cyl

  • 153,245 miles
Vehicle arrived at our shop for a standard oil change and on inspection we discovered that the sub frame had rotted and the vehicle is unsafe to drive. We contacted the dealer for the customer and found that the extended warranty had expired. This is a road hazard and should have no expiration date. Photo is available if there is an investigation.

- Blue Earth, MN, USA

problem #6

Mar 012018

Caliber

  • 107,000 miles
The contact owns a 2008 Dodge Caliber. While inspecting underneath the vehicle, the contact noticed that the cross member was rusted and contained holes. There were no warning indicators illuminated. The vehicle was not taken to a dealer or independent mechanic for diagnostic testing or repair. The manufacturer was not aware of the failure. The failure mileage was 107,000.

- Davenport, IA, USA

problem #5

Aug 172016

Caliber 4-cyl

  • 94,000 miles
I had my car to a garage for alignment. I was told my subframe is rusted out and needs replaced. I researched a 2008 Dodge Caliber subframe and got information about Chrysler offering a 10 year extended warranty specifically for this subframe. Its stating this is for 2007 models, but mine being 2008 isn't covered? the mechanic said this is an extreme safety hazard and I want to know how I could get this subframe replaced under this extended warranty. I live in pa, and that is a state included in the "salt-belt" due to the salt trucks during winter. This is reasoning for the dangerous corrosion. Please help me with this situation. Thank you.

- Williamsport, PA, USA

problem #4

Jun 082015

Caliber 4-cyl

  • 149,099 miles
The contact owns a 2008 Dodge Caliber. While driving 35 mph, a passenger heard a crunching sound under the vehicle. After inspecting the vehicle, the contact noticed that the entire front cross member was corroded, which resulted in the frame being fractured. The contact stated that the vehicle was inoperable due to the corrosion. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 149,099. Updated 7/23/15 updated 8/19/15 updated 9/23/15 updated 9/30/15

- Portage, IN, USA

problem #3

May 042015

Caliber

  • 108,000 miles
My sons car, sub frame rusted inconsistent with all of other components. Making unusual noises, deemed unsafe to operate.

- Newburyport, MA, USA

problem #2

Apr 032015

Caliber 4-cyl

  • miles
Front crossmember frame rusted through. Car is not safe and cannot be driven. Car belongs to our daughter who is a single mother and was just paid off. She cannot afford this repair. After finding many complaints on the internet, we called Chrysler and only some of these Calibers qualified for repair (free). Not sure why our car is not included. This is also a problem on the Jeep compass. It would seem that a frame would last longer than 6-7 years.

- Baldwinsville, NY, USA

problem #1

Sep 222014

Caliber

  • 44,038 miles
The contact owns a 2008 Dodge Caliber. While the vehicle was undergoing routine maintenance, the technician noticed corrosion underneath the vehicle. The technician stated that the front cross member cradle needed to be replaced. The vehicle was repaired and the manufacturer was not notified. The failure mileage was 44,038.

- Trafford, PA, USA