3.2

definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
42,423 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2008 Dodge Dakota:

Unsubscribe any time. We don't sell/share your email.

problem #4

Jan 012020

Dakota

  • miles
Extended cab doors will not open which makes it impossible to access tire changing tools. Looking on the internet, I've discovered this happens to many Dodge Dakota extended cab trucks. Vehicle was stationary.

- Houston, TX, USA

problem #3

Jul 052013

Dakota 4WD 8-cyl

  • 62,692 miles
Right rear tire pressure sensor internal failure, leading to need for replacement.

- Woodbridge, VA, USA

problem #2

Jul 132012

Dakota

  • 40,000 miles
The contact owns a 2008 Dodge Dakota. While inspecting the rear passenger side tire pressure the valve stem fractured. The vehicle was taken to an independent mechanic for diagnostic. The valve stem and tire pressure sensor were replaced. The vehicle was repaired. The approximate failure mileage was 40,000.

- Williamston, MI, USA

problem #1

Jul 092012

Dakota 8-cyl

  • 67,000 miles
On 9 July 2012, I took my vehicle into T J tire and service in richlands, nc. I was there to have tires installed onto my truck. The representative told me that there was a very bad situation with my valve stems and that they would not be able to perform the install with the current valve stems. The problem with the valve stem is that they were severely corroded and were breaking and fragmenting apart. I immediately contacted Chrysler corporation to see if there was a tsb or a recall. They responded that there was not one in effect or pending. Upon inspection of the valve stem it was found to be composed of an aluminum stem, brass valve core and a cap of unknown metal/alloy. This combination of dissimilar metals on a component exposed to weather and road conditions is not advisable. There is substantial reason to believe that there is a direct correlation between the dissimilar metals and increased rate of corrosion. This component is subject to failure and would pose a significant risk at a high rate of speed.

- Sneads Ferry, NC, USA