10.0

really awful
Crashes / Fires:
1 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
5,067 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2008 Dodge Ram 2500:

Unsubscribe any time. We don't sell/share your email.

problem #3

Sep 152011

Ram 2500

  • miles
At 39,000 miles right rotor became warped behind turning had to replace. A friend had same then happen on same kind of vehicle. Dealer claims maintenance item. Never had to have rotor replaced on new vehicle before. Brake pads we fine. Vehicle about 4omph would pulsate while braking and steering wheel would shake.

- St Charles, MO, USA

problem #2

Jan 092011

Ram 2500

  • 12,000 miles
The contact owns a 2008 Dodge Ram 2500. The contact stated that the ABS failed causing the vehicle to slide down a hill and into an intersection. The contact had to pump the brakes for the vehicle to stop. The vehicle had not been inspected or repaired. The current and failure mileages were 12,000.

- East Rochester, PA, USA

problem #1

Nov 192008

Ram 2500

  • 3,200 miles
On a misty morning our truck began to skid as we attempted to accelerate after yielding to exiting traffic on an access road on ih 10. My husband tried to control the skid by steering into it, but we just kept skidding out of control. He purposely remembers not applying the brake in an attempt to lessen the loss of control. We continued the skid across 2 lanes of access road to the right, then spun around 180 degrees and skidded back across 3 lanes of access road to the left. We came to stop facing oncoming traffic after hitting a concrete retaining wall first with the right front of the truck and then with the right rear of the truck. I remember hearing the tires continuing to spin and smelled burning rubber. This caused over $6500 damage to the truck and has caused our insurance rates to increase. After months of discussing the wreck and replaying it in our minds, we have determined that probably, as my husband clinched the steering wheel and tried to control the spin, that the cruise control was engaged and set which made us continue to travel at the set speed instead of slowing and allowing him to regain control of the truck. The cruise control on/off button and the set button are both located on the steering wheel. This is the first vehicle that we have ever had or seen that has the on/off control for the cruise located on the steering wheel. Most vehicles have this either on the blinker lever or even on the dash board. We feel certain that the cruise control was inadvertently turned on when my husband tightened his hold on the steering wheel. I feel that this is an unsafe location for this control. We were very lucky that in our travels across all lanes of traffic, not once, but twice that there were no other cars on the road that morning or this would have been a multi car pile up. No change has been made to the truck's cruise control. We plan to have it disconnected. In attempt to prevent others from having a wreck, we are reporting it.

- San Antonio, TX, USA