The contact owns a 1995 Dodge Ram 2500. The contact became aware that the VIN was included in NHTSA Campaign Number: 01V037000 (Vehicle Speed Control) however, the part to do the recall repair was not yet available. The local dealer was contacted and informed the contact that parts to perform the recall repair had been discontinued. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

- Herndon, VA, USA

The dealership was unable to perform the ignition switch wiring recall #00V135000, and the throttle cable recall# 01V037000 because the parts were not available. It has been 60 days. Recall campaign; the consumer stated that it has now been 3 months and the parts are still not available. The consumer has since found a part on his own.

- Rogers, AR, USA

Although throttle cable was frayed (4 strands of the cable) it did not fail at the time I replaced it. I just noticed it while performing some preventive maintenance and was afraid that it could stick in the wide open throttle position if not repaired. **dimsii IVOQ entry posted after 12/12/02 cut-over to artemis*734289

- Big Rapids, MI, USA

Throttle control cable was repaired under campaign id 01V037000. Less than 500 miles later, throttle cable failed while driving. Vehicle checked by another dealer, who advised consumer that recall repairs did not properly repair the first time. Dealer advised consumer that first dealer did not add all necessary components. Consumer states hood latch and ignition switch repaired under recall campaign (01V-040 and 00V-135) but failed again.

- Reids Spring, MO, USA

Although the throttle cable was frayed (4 strands of the cable) it did not fail at the time I replaced it. I just noticed it while performing some preventive maintenance and was afraid that it could stick in the wide open throttle position if not repaired.

- Big Rapids, MI, USA

While traveling on highway speed control will surge, and ignition switch will short out. Dealership is aware of problem.

- Buffalo, NY, USA

Consumer was traveling about 5mph and throttle got stuck. Dealership was made aware of the problem. Consumer received a recall notification in the mail #970 for the throttle cable and throttle linkage componets to be replaced, however after becoming stranded and then having vehicle towed it was determined by a mechanic that none of the throttle linkages components were replaced and mechanic informed consumer that the parts were on back order and the the previous dealer that performed the work must have used a defective part and consumer realized that the repair only took an hour.

- Marysville, CA, USA

1. rough idle and slight loss of power I've replaced plugs, wires, rotor, distributor cap, cleaned injectors, but nothing seems to help 2. the cable wire on the throttle body is frayed2.

- Stillwater, OK, USA

After elec. Ingnition harness replaced under recall vehicle has had numerous electrical related faliures. Headlight switch melted in dash 2X's causing smoke and or fire condition. A/C failure, no power to compressor. Bucking, missing, hesitation at idle and all speeds. Buck, miss, hesistation can not be diagnoised by numerous dealers or private mechanics. Have spent over $1700 replacing parts (PCM, egr selonoid, egr gasket, tps sensor, iat motor, O2 sensor, fuel pump, fuel regulator) to remedy problem. So far no help. Any help would be greatly appreciated.

- Brick, NJ, USA

Consumer has a stick shift, and driving through traffic one day throttle wouldn't return. At that time there was no recall. Consumer purchased a new throttle and put it on. Consumer located recall 01V037000/ manufacturer's recall 97, )and contacted manufacturer. This vehicle was not included in recall due to VIN. Consumer states upon replacing the cable for the throttle, it was clearly evident that the cable was badly frayed and got caught on the rubber tube and caused an open stuck throttle.

- Lakseside, CA, USA

Cruise control will get stuck and will not disengage when travling at high speeds. Has not contacted dealership yet. Consumer states when he replaced the frayed throttle cable, he noticed that the cruise control cable was also badly frayed, which had been causing cruise control to stick at high way speeds.

- Lakeside, CA, USA

Throttle became stuck in closed position. This kept consumer from accelerating when applying gas pedal. Dealer has been contacted.

- Troy, MI, USA

Although the throttle cable was frayed (4 strands of the cable) it did not fail at the time I replaced it. I just noticed it while performing some preventive maintenance and was afraid that it could stick in the wide open throttle position if not repaired.

- Big Rapids, MI, USA

The throttle linkage rod fell off because the heat of the engine expands the plastic cups so that it becomes loose, causing the vehicle to not move forward. Nlm

- Amery, WI, USA

No summary

- Paris Ontario Canada, AK, USA

Throttle cable failed.

- Louisa, VA, USA

No summary liste don this vehicle.

- Muskegon, MI, USA

While driving down freeway at 70 mph tried to slow down and could not.throttle was stuck so had to apply brakes very hard to maneuver through traffic.got to shoulder of road and turned off ignition at very high RPM.found fraid throttle cable with part of it inside throttle cable housing.dealer said they could not fix for 3 days.took it to steve's auto and diesel repair 408 E. rio vista burlington wa. 98233.ph.# 360-755-1212.they where real busy but took us in because they said it was dangerous to drive truck that way.paid $84.35 for new cable and labor.suggest all truck owners inspect throttle cables closely.could have been a major accident with falities with less experienced driver.

- Bow, WA, USA

The throttle stuck open because of a frayed cable. When I left the interstate I almost ran into the rear of the vehicles in front of me. I had to shift into neutral so that I could stop. If I would have turned off the engine I would not have had any power brakes. The manufacture must has been awair of this problem as the replacement cable was entirely different and incased in plastic so that it could not bend and fray.

- Avella, PA, USA

Vehicle down shifted to first gear due to a failed speed sensor.

- Unknown, CT, USA