When buckling up the seat belts in the back seat of my car- they do not register on the screen. I get a message that says 'rear belt monitor fault service required'

- Azle, TX, USA

The car shakes while the car is in idle. The car displays an illuminated crossed out child car seat and the word -??on-??. These two alerts do not turn off. Even though there is no one seated in a back and two adults are seated in the front seats. It also leaks fluid. I have an appointment with a ford dealer this Tuesday and I already contacted the ford corporate office. #CA********

- Montebello , CA, USA

"PASSENGER SIDE SEATBELT PRETENSION AND RETRACTOR ASSEMBLY INTERNALLY FAULTED:" This caused the seat belt light to be illuminated. This was repaired free of charge by the dealership.

- Houston, TX, USA

I rented this Ford Escape from Avis this month and ran into what could have been an incredibly dangerous safety issue due to a massive oversight in the car's design. I installed a small booster seat in the passenger side back seat for my 10 year-old son. He got in the seat and attached his seat belt, which he has done hundreds of times before in our own car. About 1 hour into a 2-hour freeway trip, a notification went off on the dashboard, telling me that a seat belt in the back had come undone. My son tried frantically to reattach the buckle but was unable. I had to exit the freeway and park on the side of the road. When I tried to reattach the buckle, I saw why there was a problem: He had inserted the buckle into the CENTER receptacle, not the passenger-side one. The receptacle didn't click, as it was probably designed not to do, but because the metal of the buckle has a slight angle to it, there was enough tension for it to temporarily hold. However even a minor accident could have been fatal because my son wasn't property strapped in. There are several issues here. First, the dash indicator should have been designed to tell me that there was weight on the right rear seat but no buckle was attached to that receptacle. Second, the center receptacle did not immediately reject the right-most buckle; instead, the bent angle of the buckle's metal temporarily held it in place and made my 10 year-old believe he was strapped in. Finally, the receptacles themselves have no play from side-to-side. This, plus the angle of the buckle's metal, means that when a booster seat is installed, there is not enough room to fully attach the buckle into the receptacle without exerting a LOT of force to push the receptacle to the left. I can't imagine the buckle can be attached at all with a larger child seat. The image I attached shows why this is; attaching a car seat requires exerting enough force to bend the metal holding the receptacle in order to attach the buckle.

- Valley Village, CA, USA