Upon stopping when applying the brakes they locked up. There were no warning lights on. It was diagnosed by an independent auto repair shop, not drivable I had it towed to the Ford Dealership. The ABS module, and calipers have failed. I learned there was a recall on these parts but do not apply to my specific vin #. The ABS module is on national back order, likely a month out. I have paid for the part. The service dept quoted new rotors calipers/hose and pads I think this vehicle may need to be added to the recall since it is the exact same failure. Luckily I was in town and not on the interstate when the brake system failed.

- Elberta, AL, USA

My clutch slave cylinder failed with approximately 64000 mi on the vehicle. This is a hydraulic system sharing the same reservoir as the brakes. The clutch pedal stuck to the floor leaving me unable to change gear while driving on the highway. Had to pull off on the side of the road and manually pull up the clutch with my hand. After that it functioned seemingly fine. I took the car to a local garage who diagnosed the issue and said it was fairly common on these cars. Part has not been replaced yet so it cannot be inspected but it is scheduled to go in to have the transmission dropped and slave cylinder replaced. There were no lamps messages or other warning signs prior to the incident on the highway aside from a slight softening of the clutch feel which occured during the months proceeding the failure. The clutch in this vehicle is notoriously soft to begin with so it did not feel much different. Thank you

- Burlington, VT, USA

This car very bad no body can't buy

- Tamarac, FL, USA

While driving car it started to not want to go over 20mph then all together stopped. Couldn't even roll it to side of the road. Had it towed to dealer and they said the brakes locked up on it because there is something other than brake fluid in the brake lines.

- Sharon, TN, USA

On Monday December 2, 2019 on my way to work I was going straight on the street with heavy traffic and seen that there was needed to be a stop up front so I slowly stepped on the brakes and nothing was happening and then I pressed on the brakes firmly and the pedal went nearly to the floor and I got into a accident due to the fact that the brakes failed

- North Las Vegas, NV, USA

The contact owns a 2019 Ford Fiesta. While driving 20 mph, the vehicle failed to decelerate when the accelerator pedal was released. The contact stated that the engine rpms were at 1,100. When the brake pedal was depressed, there was a delay, the vehicle continued to move forward, and the rpms dropped to 750. The vehicle was taken to dave smith Ford (located at 4045 transit rd, williamsville, NY 14221, (716) 634-2000) where it was diagnosed that there was computer failure. The vehicle was not repaired. The manufacturer was not notified. The failure mileage was 5,100.

- William Ville, NY, USA