Vehicle will stall without prior warning. When at stop light consumer would put vehicle in neutral. Dealership was aware of the problem. Dealer stated ignition system had shorted out resulting in spark plugs being burned, dealer replaced the ignition switch and spark plugs, consumer states there are still problems and now the engine is misfiring, consumer stated there was a recall regarding the ignition switch problems, however dealer informed that this VIN is not included. Fan belt replaced. Front and rear brake pads replaced.

- Whiting, NJ, USA

Brake pads failed.

- Texas City, TX, USA

Brake pad material not mating to respective surfaces causing the rotors to warp and damage resulting in extreme vibration.

- Charlotte, NC, USA

When driving the vehicle the brakes are making a lot of noise, and consumer can smell a little of smoke burning from the brakes. Consumer has to replace the pads on the brakes and that Ford has to replace the brakes.

- Atlatic Beach, FL, USA

Brake pads failed.

- Seviervill, TN, USA

Brake pads failed.

- Greenville, SC, USA

Rotors and pads that clamp onto disc warp. This occurs when condinsation and dust particals contact surface area. Documented incidents: Six.

- Woodbridge, VA, USA

Brake system: Brakes start making a noise, and when applying the brakes, driver has to push the brakes completely to the floor in order to stop. Had to have brake shoes put on 6 times, calipers 0ne time and rotors replaced and machined three times.

- Lucasville, OH, USA

Brake calipers/pads replaced.

- Chicago, IL, USA

After three days of having the car the rotors needed to be replaced, three month afterwards brake pads needed to be replaced.

- Chester, PA, USA

Replaced front warped brake rotors; also, replaced worn out pads.

- Davie, FL, USA

Brake rotors warp/brake pads wear irregularly, causing vehicle to shimmy.

- North Ridgeville, OH, USA

Every (3,255) miles vehicle requires a new brake job. Warped rotors, causing brakes to vibrate, also replaced worn pads/shoes.

- Atlanta, GA, USA

When the brakes are applied. Noise/ pulling and vibration is experienced. Rotors and pads have been replaced.

- Wayne, MI, USA

Replaced brake pads.

- Knotts Islan, NC, USA

Steering wheel shimmies and the brakes grind when you apply the brakes. Replaced rotors, drums and brake pads (3) times.

- Raydal, GA, USA

The brake pads are melting, when stopping the steering shakes and pulls to the side.

- Marrero, LA, USA